precision loads and stores as well as reg+imm double precision loads and stores.
Previously, expansion of loads and stores was done after register allocation,
but now it takes place during legalization. As a result, users will see double
precision stores and loads being emitted to spill and restore 64-bit FP registers.
llvm-svn: 190235
point registers. We will need this register class later when we add
definitions for instructions mfhc1 and mthc1. Also, remove sub-register indices
sub_fpeven and sub_fpodd and use sub_lo and sub_hi instead.
llvm-svn: 188842
load/store instructions defined. Previously, we were defining load/store
instructions for each pointer size (32 and 64-bit), but now we need just one
definition.
llvm-svn: 188830
Previously, three instructions were needed:
trunc.w.s $f0, $f2
mfc1 $4, $f0
sw $4, 0($2)
Now we need only two:
trunc.w.s $f0, $f2
swc1 $f0, 0($2)
llvm-svn: 182053
invalid instruction sequence.
Rather than emitting an int-to-FP move instruction and an int-to-FP conversion
instruction during instruction selection, we emit a pseudo instruction which gets
expanded post-RA. Without this change, register allocation can possibly insert a
floating point register move instruction between the two instructions, which is not
valid according to the ISA manual.
mtc1 $f4, $4 # int-to-fp move instruction.
mov.s $f2, $f4 # move contents of $f4 to $f2.
cvt.s.w $f0, $f2 # int-to-fp conversion.
llvm-svn: 182042
This option is used when the user wants to avoid emitting double precision FP
loads and stores. Double precision FP loads and stores are expanded to single
precision instructions after register allocation.
llvm-svn: 181718
functions. Set AddedComplexity to determine the order in which patterns are
matched.
This simplifies selection of floating point loads/stores.
No functionality change intended.
llvm-svn: 175300
register names in the standalone assembler llvm-mc.
Registers such as $A1 can represent either a 32 or
64 bit register based on the instruction using it.
In addition, based on the abi, $T0 can represent different
32 bit registers.
The problem is resolved by the Mips specific AsmParser
td definitions changing to work together. Many cases of
RegisterClass parameters are now RegisterOperand.
Contributer: Vladimir Medic
llvm-svn: 172284
use load/store fragments defined in TargetSelectionDAG.td in place of them.
Unaligned loads/stores are either expanded or lowered to target-specific nodes,
so instruction selection should see only aligned load/store nodes.
No changes in functionality.
llvm-svn: 163960
single-precision load and store.
Also avoid selecting LUXC1 and SUXC1 instructions during isel. It is incorrect
to map unaligned floating point load/store nodes to these instructions.
llvm-svn: 161063
Daniel Sanders