instructions in order to avoid inserting new ones. However, if
the cast instruction is the SCEVExpander's InsertPt, this
causes subsequently emitted instructions to be inserted near
the cast, and not at the location of the original insert point.
Fix this by adjusting the insert point in such cases.
This fixes PR4009.
llvm-svn: 69808
This fixes a very subtle bug. vr defined by an implicit_def is allowed overlap with any register since it doesn't actually modify anything. However, if it's used as a two-address use, its live range can be extended and it can be spilled. The spiller must take care not to emit a reload for the vn number that's defined by the implicit_def. This is both a correctness and performance issue.
llvm-svn: 69743
type to truncate to should be the number of bits of the value that are
preserved, not the number that are clobbered with sign-extension.
This fixes regressions in ldecod.
llvm-svn: 69704
%reg1498<def> = MOV32rm %reg1024, 1, %reg0, 12, %reg0, Mem:LD(4,4) [sunkaddr39 + 0]
%reg1506<def> = MOV32rm %reg1024, 1, %reg0, 8, %reg0, Mem:LD(4,4) [sunkaddr42 + 0]
%reg1486<def> = MOV32rr %reg1506
%reg1486<def> = XOR32rr %reg1486, %reg1498, %EFLAGS<imp-def,dead>
%reg1510<def> = MOV32rm %reg1024, 1, %reg0, 4, %reg0, Mem:LD(4,4) [sunkaddr45 + 0]
=>
%reg1498<def> = MOV32rm %reg2036, 1, %reg0, 12, %reg0, Mem:LD(4,4) [sunkaddr39 + 0]
%reg1506<def> = MOV32rm %reg2037, 1, %reg0, 8, %reg0, Mem:LD(4,4) [sunkaddr42 + 0]
%reg1486<def> = MOV32rr %reg1506
%reg1486<def> = XOR32rr %reg1486, %reg1498, %EFLAGS<imp-def,dead>
%reg1510<def> = MOV32rm %reg2038, 1, %reg0, 4, %reg0, Mem:LD(4,4) [sunkaddr45 + 0]
From linearscan's point of view, each of reg2036, 2037, and 2038 are separate registers, each is "killed" after a single use. The reloaded register is available and it's often clobbered right away. e.g. In thise case reg1498 is allocated EAX while reg2036 is allocated RAX. This means we end up with multiple reloads from the same stack slot in the same basic block.
Now linearscan recognize there are other reloads from same SS in the same BB. So it'll "downgrade" RAX (and its aliases) after reg2036 is allocated until the next reload (reg2037) is done. This greatly increase the likihood reloads from SS are reused.
This speeds up sha1 from OpenSSL by 5.8%. It is also an across the board win for SPEC2000 and 2006.
llvm-svn: 69585
type as the vector element type: allow them to be of
a wider integer type than the element type all the way
through the system, and not just as far as LegalizeDAG.
This should be safe because it used to be this way
(the old type legalizer would produce such nodes), so
backends should be able to handle it. In fact only
targets which have legal vector types with an illegal
promoted element type will ever see this (eg: <4 x i16>
on ppc). This fixes a regression with the new type
legalizer (vec_splat.ll). Also, treat SCALAR_TO_VECTOR
the same as BUILD_VECTOR. After all, it is just a
special case of BUILD_VECTOR.
llvm-svn: 69467
for the optimization it's testing to kick in (although
it improves the code, getting rid of all spills).
I don't understand the optimization well enough to
rescue the test, so XFAILing.
llvm-svn: 69409
leaq foo@TLSGD(%rip), %rdi
as part of the instruction sequence. Using a register other than %rdi and then
copying it to %rdi is not valid.
llvm-svn: 69350
register is available and when it's profitable.
e.g.
xorq %r12<kill>, %r13
addq %rax, -184(%rbp)
addq %r13, -184(%rbp)
==>
xorq %r12<kill>, %r13
movq -184(%rbp), %r12
addq %rax, %r12
addq %r13, %r12
movq %r12, -184(%rbp)
Two more instructions, but fewer memory accesses. It can also open up
opportunities for more optimizations.
llvm-svn: 69341
have pointer types, though in contrast to C pointer types, SCEV
addition is never implicitly scaled. This not only eliminates the
need for special code like IndVars' EliminatePointerRecurrence
and LSR's own GEP expansion code, it also does a better job because
it lets the normal optimizations handle pointer expressions just
like integer expressions.
Also, since LLVM IR GEPs can't directly index into multi-dimensional
VLAs, moving the GEP analysis out of client code and into the SCEV
framework makes it easier for clients to handle multi-dimensional
VLAs the same way as other arrays.
Some existing regression tests show improved optimization.
test/CodeGen/ARM/2007-03-13-InstrSched.ll in particular improved to
the point where if-conversion started kicking in; I turned it off
for this test to preserve the intent of the test.
llvm-svn: 69258
sext around sext(shorter IV + constant), using a
longer IV instead, when it can figure out the
add can't overflow. This comes up a lot in
subscripting; mainly affects 64 bit.
llvm-svn: 69123
llvm.dbg.region.end instrinsic. This nested llvm.dbg.func.start/llvm.dbg.region.end pair now enables DW_TAG_inlined_subroutine support in code generator.
llvm-svn: 69118
operator is used by a CopyToReg to export the value to a different
block, don't reuse the CopyToReg's register for the subreg operation
result if the register isn't precisely the right class for the
subreg operation.
Also, rename the h-registers.ll test, now that there are more
than one.
llvm-svn: 69087
- Add patterns for h-register extract, which avoids a shift and mask,
and in some cases a temporary register.
- Add address-mode matching for turning (X>>(8-n))&(255<<n), where
n is a valid address-mode scale value, into an h-register extract
and a scaled-offset address.
- Replace X86's MOV32to32_ and related instructions with the new
target-independent COPY_TO_SUBREG instruction.
On x86-64 there are complicated constraints on h registers, and
CodeGen doesn't currently provide a high-level way to express all of them,
so they are handled with a bunch of special code. This code currently only
supports extracts where the result is used by a zero-extend or a store,
though these are fairly common.
These transformations are not always beneficial; since there are only
4 h registers, they sometimes require extra move instructions, and
this sometimes increases register pressure because it can force out
values that would otherwise be in one of those registers. However,
this appears to be relatively uncommon.
llvm-svn: 68962
to support C99 inline, GNU extern inline, etc. Related bugzilla's
include PR3517, PR3100, & PR2933. Nothing uses this yet, but it
appears to work.
llvm-svn: 68940
1. Sinking would crash when the first instruction of a block was
sunk due to iterator problems.
2. Instructions could be sunk to their current block, causing an
infinite loop.
This fixes PR3968
llvm-svn: 68787
register destinations that are tied to source operands. The
TargetInstrDescr::findTiedToSrcOperand method silently fails for inline
assembly. The existing MachineInstr::isRegReDefinedByTwoAddr was very
close to doing what is needed, so this revision makes a few changes to
that method and also renames it to isRegTiedToUseOperand (for consistency
with the very similar isRegTiedToDefOperand and because it handles both
two-address instructions and inline assembly with tied registers).
llvm-svn: 68714
in addition to ZERO_EXTEND and SIGN_EXTEND. Fix a bug in the
way it checked for live-out values, and simplify the way it
find users by using SDNode::use_iterator's (relatively) new
features. Also, make it slightly more permissive on targets
with free truncates.
In SelectionDAGBuild, avoid creating ANY_EXTEND nodes that are
larger than necessary. If the target's SwitchAmountTy has
enough bits, use it. This exposes the truncate to optimization
early, enabling more optimizations.
llvm-svn: 68670
integer types, unless they are already strange. This prevents it from
turning the code produced by SROA into crazy libcalls and stuff that
the code generator can't handle. In the attached example, the result
was an i96 multiply that caused the x86 backend to assert.
Note that if TargetData had an idea of what the legal types are for
a target that this could be used to stop instcombine from introducing
i64 muls, as Scott wanted.
llvm-svn: 68598
with SUBREG_TO_REG, teach SimpleRegisterCoalescing to coalesce
SUBREG_TO_REG instructions (which are similar to INSERT_SUBREG
instructions), and teach the DAGCombiner to take advantage of this on
targets which support it. This eliminates many redundant
zero-extension operations on x86-64.
This adds a new TargetLowering hook, isZExtFree. It's similar to
isTruncateFree, except it only applies to actual definitions, and not
no-op truncates which may not zero the high bits.
Also, this adds a new optimization to SimplifyDemandedBits: transform
operations like x+y into (zext (add (trunc x), (trunc y))) on targets
where all the casts are no-ops. In contexts where the high part of the
add is explicitly masked off, this allows the mask operation to be
eliminated. Fix the DAGCombiner to avoid undoing these transformations
to eliminate casts on targets where the casts are no-ops.
Also, this adds a new two-address lowering heuristic. Since
two-address lowering runs before coalescing, it helps to be able to
look through copies when deciding whether commuting and/or
three-address conversion are profitable.
Also, fix a bug in LiveInterval::MergeInClobberRanges. It didn't handle
the case that a clobber range extended both before and beyond an
existing live range. In that case, multiple live ranges need to be
added. This was exposed by the new subreg coalescing code.
Remove 2008-05-06-SpillerBug.ll. It was bugpoint-reduced, and the
spiller behavior it was looking for no longer occurrs with the new
instruction selection.
llvm-svn: 68576
builds.
--- Reverse-merging (from foreign repository) r68552 into '.':
U test/CodeGen/X86/tls8.ll
U test/CodeGen/X86/tls10.ll
U test/CodeGen/X86/tls2.ll
U test/CodeGen/X86/tls6.ll
U lib/Target/X86/X86Instr64bit.td
U lib/Target/X86/X86InstrSSE.td
U lib/Target/X86/X86InstrInfo.td
U lib/Target/X86/X86RegisterInfo.cpp
U lib/Target/X86/X86ISelLowering.cpp
U lib/Target/X86/X86CodeEmitter.cpp
U lib/Target/X86/X86FastISel.cpp
U lib/Target/X86/X86InstrInfo.h
U lib/Target/X86/X86ISelDAGToDAG.cpp
U lib/Target/X86/AsmPrinter/X86ATTAsmPrinter.cpp
U lib/Target/X86/AsmPrinter/X86IntelAsmPrinter.cpp
U lib/Target/X86/AsmPrinter/X86ATTAsmPrinter.h
U lib/Target/X86/AsmPrinter/X86IntelAsmPrinter.h
U lib/Target/X86/X86ISelLowering.h
U lib/Target/X86/X86InstrInfo.cpp
U lib/Target/X86/X86InstrBuilder.h
U lib/Target/X86/X86RegisterInfo.td
llvm-svn: 68560
This introduces a small regression on the generated code
quality in the case we are just computing addresses, not
loading values.
Will work on it and on X86-64 support.
llvm-svn: 68552
Constant, MDString and MDNode which can only be used by globals with a name
that starts with "llvm." or as arguments to a function with the same naming
restriction.
llvm-svn: 68420
e.g.
%reg1024<def> = MOV r1
%reg1025<def> = ADD %reg1024, %reg1026
r0 = MOV %reg1025
If it's not possible / profitable to commute ADD, then turning ADD into a LEA saves a copy.
llvm-svn: 68065
x * 40
=>
shlq $3, %rdi
leaq (%rdi,%rdi,4), %rax
This has the added benefit of allowing more multiply to be folded into addressing mode. e.g.
a * 24 + b
=>
leaq (%rdi,%rdi,2), %rax
leaq (%rsi,%rax,8), %rax
llvm-svn: 67917
Dan Gohman