[FPEnv] Added a special UnrollVectorOp method to deal with the chain on StrictFP opcodes
This change creates UnrollVectorOp_StrictFP. The purpose of this is to address a failure that consistently occurs when calling StrictFP functions on vectors whose number of elements is 3 + 2n on most platforms, such as PowerPC or SystemZ. The old UnrollVectorOp method does not expect that the vector that it will unroll will have a chain, so it has an assert that prevents it from running if this is the case. This new StrictFP version of the method deals with the chain while unrolling the vector. With this new function in place during vector widending, llc can run vector-constrained-fp-intrinsics.ll for SystemZ successfully.
Submitted by: Drew Wock <drew.wock@sas.com>
Reviewed by: Cameron McInally, Kevin P. Neal
Approved by: Cameron McInally
Differential Revision: https://reviews.llvm.org/D62546
llvm-svn: 362241
AMDGPU uses multiplier 9 for the inline cost. It is taken into account
everywhere except for inline hint threshold. As a result we are penalizing
functions with the inline hint making them less probable to be inlined
than those without the hint. Defaults are 225 for a normal function and
325 for a function with an inline hint. Currently we have effective
threshold 225 * 9 = 2025 for normal functions and just 325 for those with
the hint. That is fixed by this patch.
Differential Revision: https://reviews.llvm.org/D62707
llvm-svn: 362239
In PPCReduceCRLogicals after splitting the original MBB into 2, the 2 impacted branches still use original branch probability. This is unreasonable. Suppose we have following code, and the probability of each successor is 50%.
condc = conda || condb
br condc, label %target, label %fallthrough
It can be transformed to following,
br conda, label %target, label %newbb
newbb:
br condb, label %target, label %fallthrough
Since each branch has a probability of 50% to each successor, the total probability to %fallthrough is 25% now, and the total probability to %target is 75%. This actually changed the original profiling data. A more reasonable probability can be set to 70% to the false side for each branch instruction, so the total probability to %fallthrough is close to 50%.
This patch assumes the branch target with two incoming edges have same edge frequency and computes new probability fore each target, and keep the total probability to original targets unchanged.
Differential Revision: https://reviews.llvm.org/D62430
llvm-svn: 362237
These can take a significant amount of time in some builds.
Suggested by Andrea Di Biagio.
Differential Revision: https://reviews.llvm.org/D62666
llvm-svn: 362219
It looks this fold was already partially happening, indirectly
via some other folds, but with one-use limitation.
No other fold here has that restriction.
https://rise4fun.com/Alive/ftR
llvm-svn: 362217
Summary:
A three sources variant of the TBL instruction is added to the existing
SVE instruction in SVE2. This is implemented with minor changes to the
existing TableGen class. TBX is a new instruction with its own
definition.
The specification can be found here:
https://developer.arm.com/docs/ddi0602/latest
Reviewed By: chill
Differential Revision: https://reviews.llvm.org/D62600
llvm-svn: 362214
Test different operand types of callee and their behavior whether
relocation model is pic or not.
Possible operand types are:
Register (function pointer),
External symbol (used for libcalls e.g. __udivdi3 or memcpy),
Global address.
Global address has different handling depending on relocation model
and linkage type. Register and external symbol do not.
Differential Revision: https://reviews.llvm.org/D62590
llvm-svn: 362212
Fix the misleadingly indentation introduced in rL362064. This will get rid of
the compiler warning, and it was actually a bug. This change will be used and
tested in D62669.
llvm-svn: 362211
Handle position independent code for MIPS32.
When callee is global address, lower call will emit callee
as G_GLOBAL_VALUE and add target flag if needed.
Support $gp in getRegBankFromRegClass().
Select G_GLOBAL_VALUE, specially handle case when
there are target flags attached by lowerCall.
Differential Revision: https://reviews.llvm.org/D62589
llvm-svn: 362210
Move initGlobalBaseReg from MipsSEDAGToDAGISel to MipsFunctionInfo.
This way functions used for handling position independent code during
instruction selection, getGlobalBaseReg and initGlobalBaseReg,
end up in same class.
Differential Revision: https://reviews.llvm.org/D62586
llvm-svn: 362206
Lower call for callee that is register for MIPS32.
Register should contain callee function address.
Differential Revision: https://reviews.llvm.org/D62585
llvm-svn: 362204
These patterns can incorrectly narrow a volatile load from 128-bits to 64-bits.
Similar to PR42079.
Switch to using (v4i32 (bitcast (v2i64 (scalar_to_vector (loadi64))))) as the
load pattern used in the instructions.
This probably still has issues in 32-bit mode where loadi64 isn't legal. Maybe
we should use VZMOVL for widened loads even when we don't need the upper bits
as zeroes?
llvm-svn: 362203
DAG combine will usually fold fpextend+load to an fp extload anyway. So the
256 and 512 patterns were probably unnecessary. The 128 bit pattern was special
in that it looked for a v4f32 load, but then used it in an instruction that
only loads 64-bits. This is bad if the load happens to be volatile. We could
probably make the patterns volatile aware, but that's more work for something
that's probably rare. The peephole pass might kick in and save us anyway. We
might also be able to fix this with some additional DAG combines.
This also adds patterns for vselect+extload to enabled masked vcvtps2pd to be
used. Previously we looked for the unlikely vselect+fpextend+load.
llvm-svn: 362199
This consolidates the vreg skip code into one function (SkipVRegs()).
SkipVRegs() now knows if it should skip as if it is the first initialization or
subsequent skips.
The first skip is also done the first time createVirtualRegister is called by
the cursor instead of by the cursor's constructor. This prevents verifier
errors on machine functions that have no vregs (where the verifier will
complain that there are vregs when the function uses none).
Differential Revision: https://reviews.llvm.org/D62717
llvm-svn: 362195
This makes the 5 address operands come first. And the data operand comes last.
This matches the operand order the instruction is created with. It's also the
expected order in X86MCInstLower. So everything appeared to work, but the
operands didn't match their declared type.
Fixes a -verify-machineinstrs failure.
Also remove the isel patterns from these instructions since they should only
be used for stack spills and reloads. I'm not even sure what types the patterns
were looking for to match.
llvm-svn: 362193
This is am almost NFC, it does the following:
- If there is no register class for a COPY's src or dst, bail.
- Fixes uses iterator invalidation bug.
Differential Revision: https://reviews.llvm.org/D62713
llvm-svn: 362191
CMake always uses absolute file paths in the generated compiler
invocation which results in absolute file paths being embedded in debug
info. This is undesirable when building a toolchain e.g. on bots as the
debug info may embed the bot source checkout path which is meaningless
anywhere else.
This change introduces the LLVM_USE_RELATIVE_PATHS_IN_DEBUG_INFO which uses
-fdebug-prefix-map (where supported) options to rewrite paths embedded
into debug info with relative ones. Additionally, LLVM_SOURCE_PREFIX can
be used to override the path to source directory with a different one.
Differential Revision: https://reviews.llvm.org/D62622
llvm-svn: 362185
The result types aren't mentioned in the pattern name so really shouldn't be in the PatFrags.
The users of these either have their own type constraint or rely on the type constranit system to realize the only legal extend would be to f64.
llvm-svn: 362175
The LoadExt table defaults to all combinations being Legal. For
vector types, only src VTs with an i1 element type were ever changed.
So we don't need to mark them legal manually.
llvm-svn: 362170
Summary:
Clangd's framework is assembled by copying binaries from the lib and bin directories into a bundle shape. This results in an invalid bundle code signature because the signature only applies to the binaries not the resources.
This patch adds two new options to `llvm_codesign` to enable re-signing the library and XPC service as bundles.
The `BUNDLE_PATH` option allow specifying an explicit path to codesign, which enables signing bundles which aren't generated using CMake's `FRAMEWORK` or `BUNDLE` target properties.
The `FORCE` option allows re-signing binaries that have already been signed. This is required for how clangd exposes the clangd library and tools as both XPC and non-XPC services using the same binary.
Reviewers: jkorous, bogner
Reviewed By: bogner
Subscribers: mgorny, ilya-biryukov, dexonsmith, arphaman, kadircet, cfe-commits, llvm-commits
Tags: #clang, #llvm
Differential Revision: https://reviews.llvm.org/D62693
llvm-svn: 362169
Summary:
Keeps track of the enums that were used by saving them as DIGlobalVariables,
since CodeView emits debug info for global constants.
Reviewers: rnk
Subscribers: aprantl, cfe-commits, llvm-commits
Tags: #clang, #llvm
Differential Revision: https://reviews.llvm.org/D62635
llvm-svn: 362166
Kevin P. Neal