Disable bypassing if one of the operands looks like a hash value. Slow
division often occurs in hashtable implementations and fast division is
never taken there because a hash value is extremely unlikely to have
enough upper bits set to zero.
A value is considered to be hash-like if it is produced by
1) XOR operation
2) Multiplication by a constant wider than the shorter type
3) PHI node with all incoming values being hash-like
Differential Revision: https://reviews.llvm.org/D28200
llvm-svn: 299329
ValueTracking is used for more thorough analysis of operands. Based on the
analysis, either run-time checks can be simplified (e.g. check only one operand
instead of two) or the transformation can be avoided. For example, it is quite
often the case that a divisor is promoted from a shorter type and run-time
checks for it are redundant.
With additional compile-time analysis of values, two special cases naturally
arise and are addressed by the patch:
1) Both operands are known to be short enough. Then, the long division can be
simply replaced with a short one without CFG modification.
2) If a division is unsigned and the dividend is known to be short then the
long division is not needed at all. Because if the divisor is too big for
short division then the quotient is obviously zero (and the remainder is
equal to the dividend). Actually, the division is not needed when
(divisor > dividend).
Differential Revision: https://reviews.llvm.org/D29897
llvm-svn: 296832
Summary:
Previously, CGP would unconditionally sink addrspacecast instructions,
even going so far as to sink them into a loop.
Now we check that the cast is "cheap", as defined by TLI.
We introduce a new "is-cheap" function to TLI rather than using
isNopAddrSpaceCast because some GPU platforms want the ability to ask
for non-nop casts to be sunk.
Reviewers: arsenm, tra
Subscribers: jholewinski, wdng, llvm-commits
Differential Revision: https://reviews.llvm.org/D26923
llvm-svn: 287591
Summary:
We don't do BypassSlowDivision when the denominator is a constant, but
we do do it when the numerator is a constant.
This patch makes two related changes to BypassSlowDivision when the
numerator is a constant:
* If the numerator is too large to fit into the bypass width, don't
bypass slow division (because we'll never run the smaller-width
code).
* If we bypass slow division where the numerator is a constant, don't
OR together the numerator and denominator when determining whether
both operands fit within the bypass width. We need to check only the
denominator.
Reviewers: tra
Subscribers: llvm-commits, jholewinski
Differential Revision: https://reviews.llvm.org/D26699
llvm-svn: 287062
Summary:
This "pass" eagerly creates div and rem instructions even when only one
is needed -- it relies on a later pass (machine DCE?) to clean them up.
This is problematic not just from a cleanliness perspective (this pass
is running during CodeGenPrepare, so should leave the IR in a better
state), but it also creates a problem for instruction selection. If we
always have a div+rem, isel will always select a divrem instruction (if
possible), even when a single div or rem would do.
Specifically, in NVPTX, we want to compute rem from the output of div,
if available. But if a div is not available, we want to leave the rem
alone. This transformation is overeager if div is always available.
Because this code runs as part of CodeGenPrepare, it's nontrivial to
write a test for this change. But this will effectively be tested by
a later patch which adds the aforementioned change to NVPTX isel.
Reviewers: tra
Subscribers: llvm-commits
Differential Revision: https://reviews.llvm.org/D26088
llvm-svn: 285460
Summary:
In BypassSlowDivision's short-dividend path, we would create e.g.
udiv exact i32 %a, %b
"exact" here means that we are asserting that %a is a multiple of %b.
But we have no reason to believe this must be true -- this is just a
bug, as far as I can tell.
Reviewers: tra
Subscribers: jholewinski, llvm-commits
Differential Revision: https://reviews.llvm.org/D26097
llvm-svn: 285459
Nikolai Bozhenov