After much back and forth, I decided to deviate from ARM design and split LDR into 4 instructions (r + imm12, r + imm8, r + r << imm12, constantpool). The advantage of this is 1) it follows the latest ARM technical manual, and 2) makes it easier to reduce the width of the instruction later. The down side is this creates more inconsistency between the two sub-targets. We should split ARM LDR instruction in a similar fashion later. I've added a README entry for this.
llvm-svn: 74420
predicate does not check if Thumb mode is enabled, and when in ARM mode
there are still some checks for constant-pool use that need to run.
llvm-svn: 73887
When compiling in Thumb mode, only the low (R0-R7) registers are available
for most instructions. Breaking the low registers into a new register class
handles this. Uses of R12, SP, etc, are handled explicitly where needed
with copies inserted to move results into low registers where the rest of
the code generator can deal with them.
llvm-svn: 68545
and into the ScheduleDAGInstrs class, so that they don't get
destructed and re-constructed for each block. This fixes a
compile-time hot spot in the post-pass scheduler.
To help facilitate this, tidy and do some minor reorganization
in the scheduler constructor functions.
llvm-svn: 62275
priority function. Instead, just iterate over the AllNodes list, which is
already in topological order. This eliminates a fair amount of bookkeeping,
and speeds up the isel phase by about 15% on many testcases.
The impact on most targets is that AddToISelQueue calls can be simply removed.
In the x86 target, there are two additional notable changes.
The rule-bending AND+SHIFT optimization in MatchAddress that creates new
pre-isel nodes during isel is now a little more verbose, but more robust.
Instead of either creating an invalid DAG or creating an invalid topological
sort, as it has historically done, it can now just insert the new nodes into
the node list at a position where they will be consistent with the topological
ordering.
Also, the address-matching code has logic that checked to see if a node was
"already selected". However, when a node is selected, it has all its uses
taken away via ReplaceAllUsesWith or equivalent, so it won't recieve any
further visits from MatchAddress. This code is now removed.
llvm-svn: 58748
flag. Then in a debugger developers can set breakpoints at these calls
to see waht is about to be selected and what the resulting subgraph
looks like. This really helps when debugging instruction selection.
llvm-svn: 58278
Instead, just create one, and make sure everything that needs
it can access it. Previously most of the SelectionDAGISel
subclasses all had their own TargetLowering object, which was
redundant with the TargetLowering object in the TargetMachine
subclasses, except on Sparc, where SparcTargetMachine
didn't have a TargetLowering object. Change Sparc to work
more like the other targets here.
llvm-svn: 57016
David Goodwin