Pin RUN lines with -analyze to legacy PM, add corresponding NPM RUN line if missing.
Reviewed By: asbirlea
Differential Revision: https://reviews.llvm.org/D87658
Just as as llvm IR supports explicitly specifying numeric value ids
for instructions, and emits them by default in textual output, now do
the same for blocks.
This is a slightly incompatible change in the textual IR format.
Previously, llvm would parse numeric labels as string names. E.g.
define void @f() {
br label %"55"
55:
ret void
}
defined a label *named* "55", even without needing to be quoted, while
the reference required quoting. Now, if you intend a block label which
looks like a value number to be a name, you must quote it in the
definition too (e.g. `"55":`).
Previously, llvm would print nameless blocks only as a comment, and
would omit it if there was no predecessor. This could cause confusion
for readers of the IR, just as unnamed instructions did prior to the
addition of "%5 = " syntax, back in 2008 (PR2480).
Now, it will always print a label for an unnamed block, with the
exception of the entry block. (IMO it may be better to print it for
the entry-block as well. However, that requires updating many more
tests.)
Thus, the following is supported, and is the canonical printing:
define i32 @f(i32, i32) {
%3 = add i32 %0, %1
br label %4
4:
ret i32 %3
}
New test cases covering this behavior are added, and other tests
updated as required.
Differential Revision: https://reviews.llvm.org/D58548
llvm-svn: 356789
Summary:
Statistics are still available in Release+Asserts (any +Asserts builds),
and stats can also be turned on with LLVM_ENABLE_STATS.
Move some of the FastISel stats that were moved under DEBUG()
back out of DEBUG(), since stats are disabled across the board now.
Many tests depend on grepping "-stats" output. Move those into
a orig_dir/Stats/. so that they can be marked as unsupported
when building without statistics.
Differential Revision: http://llvm-reviews.chandlerc.com/D486
llvm-svn: 176733
versions of Bash. In addition, I can back out the change to the lit
built-in shell test runner to support this.
This should fix the majority of fallout on Darwin, but I suspect there
will be a few straggling issues.
llvm-svn: 159544
The RegionInfo pass detects single entry single exit regions in a function,
where a region is defined as any subgraph that is connected to the remaining
graph at only two spots.
Furthermore an hierarchical region tree is built.
Use it by calling "opt -regions analyze" or "opt -view-regions".
llvm-svn: 109089
Arthur Eubanks