Created a Thumb2 predicated pattern matcher that uses Thumb2 and
HasT2ExtractPack and used it to redefine the patterns for sxta{b|h}
and uxta{b|h}. Also used the similar patterns to fill in isel pattern
gaps for the corresponding instructions in the ARM backend.
The patch is mainly changes to tests since most of this functionality
appears not to have been tested.
Differential Revision: https://reviews.llvm.org/D23273
llvm-svn: 278207
We were assuming all SBFX-like operations would have the shl/asr form, but
often when the field being extracted is an i8 or i16, we end up with a
SIGN_EXTEND_INREG acting on a shift instead. Simple enough to check for though.
llvm-svn: 213754
Although the final shifter operand is a rotate, this actually only matters for
the half-word extends when the amount == 24. Otherwise folding a shift in is
just as good.
llvm-svn: 213753
insertions.
The old behavior could cause arbitrarily bad memory usage in the DAG
combiner if there was heavy traffic of adding nodes already on the
worklist to it. This commit switches the DAG combine worklist to work
the same way as the instcombine worklist where we null-out removed
entries and only add new entries to the worklist. My measurements of
codegen time shows slight improvement. The memory utilization is
unsurprisingly dominated by other factors (the IR and DAG itself
I suspect).
This change results in subtle, frustrating churn in the particular order
in which DAG combines are applied which causes a number of minor
regressions where we fail to match a pattern previously matched by
accident. AFAICT, all of these should be using AddToWorklist to directly
or should be written in a less brittle way. None of the changes seem
drastically bad, and a few of the changes seem distinctly better.
A major change required to make this work is to significantly harden the
way in which the DAG combiner handle nodes which become dead
(zero-uses). Previously, we relied on the ability to "priority-bump"
them on the combine worklist to achieve recursive deletion of these
nodes and ensure that the frontier of remaining live nodes all were
added to the worklist. Instead, I've introduced a routine to just
implement that precise logic with no indirection. It is a significantly
simpler operation than that of the combiner worklist proper. I suspect
this will also fix some other problems with the combiner.
I think the x86 changes are really minor and uninteresting, but the
avx512 change at least is hiding a "regression" (despite the test case
being just noise, not testing some performance invariant) that might be
looked into. Not sure if any of the others impact specific "important"
code paths, but they didn't look terribly interesting to me, or the
changes were really minor. The consensus in review is to fix any
regressions that show up after the fact here.
Thanks to the other reviewers for checking the output on other
architectures. There is a specific regression on ARM that Tim already
has a fix prepped to commit.
Differential Revision: http://reviews.llvm.org/D4616
llvm-svn: 213727
Sam Parker