XOP has the VPCMOV instruction that performs the common vector bit select operation OR( AND( SRC1, SRC3 ), AND( SRC2, ~SRC3 ) )
This patch adds tablegen pattern matching for this instruction.
Differential Revision: http://reviews.llvm.org/D8841
llvm-svn: 251975
When push instructions are being used to pass function arguments on
the stack, and either EH or debugging are enabled, we need to generate
.cfi_adjust_cfa_offset directives appropriately. For (synch) EH, it is
enough for the CFA offset to be correct at every call site, while
for debugging we want to be correct after every push.
Darwin does not support this well, so don't use pushes whenever it
would be required.
Differential Revision: http://reviews.llvm.org/D13767
llvm-svn: 251904
In the current BB placement algorithm, a loop chain always contains all loop blocks. This has a drawback that cold blocks in the loop may be inserted on a hot function path, hence increasing branch cost and also reducing icache locality.
Consider a simple example shown below:
A
|
B⇆C
|
D
When B->C is quite cold, the best BB-layout should be A,B,D,C. But the current implementation produces A,C,B,D.
This patch filters those cold blocks off from the loop chain by comparing the ratio:
LoopBBFreq / LoopFreq
to 20%: if it is less than 20%, we don't include this BB to the loop chain. Here LoopFreq is the frequency of the loop when we reduce the loop into a single node. In general we have more cold blocks when the loop has few iterations. And vice versa.
Differential revision: http://reviews.llvm.org/D11662
llvm-svn: 251833
1) PR25154. This is basically a repeat of PR18102, which was fixed in
r200201, and broken again by r234430. The latter changed which of the
store nodes was merged into from the first to the last. Thus, we now
also need to prefer merging a later store at a given address into the
target node, instead of an earlier one.
2) While investigating that, I also realized I'd introduced a bug in
r236850. There, I removed a check for alignment -- not realizing that
nothing except the alignment check was ensuring that none of the stores
were overlapping! This is a really bogus way to ensure there's no
aliased stores.
A better solution to both of these issues is likely to always use the
code added in the 'if (UseAA)' branches which rearrange the chain based
on a more principled analysis. I'll look into whether that can be used
always, but in the interest of getting things back to working, I think a
minimal change makes sense.
llvm-svn: 251816
Optimized <8 x i32> to <8 x i16>
<4 x i64> to < 4 x i32>
<16 x i16> to <16 x i8>
All these oprtrations use now AVX512F set (KNL). Before this change it was implemented with AVX2 set.
Differential Revision: http://reviews.llvm.org/D14108
llvm-svn: 251764
This patch generalizes the zeroing of vector elements with the BLEND instructions. Currently a zero vector will only blend if the shuffled elements are correctly inline, this patch recognises when a vector input is zero (or zeroable) and modifies a local copy of the shuffle mask to support a blend. As a zeroable vector input may not be all zeroes, the zeroable vector is regenerated if necessary.
Differential Revision: http://reviews.llvm.org/D14050
llvm-svn: 251659
This is a usage of the IR-level fast-math-flags now that they are propagated to SDNodes.
This was originally part of D8900.
Removing the global 'enable-unsafe-fp-math' checks will require auto-upgrade and
possibly other changes.
Differential Revision: http://reviews.llvm.org/D9708
llvm-svn: 251450
convert float to half with mask/maskz for the reg to reg version and mask for the reg to mem version (there is no maskz version for reg to mem).
Differential Revision: http://reviews.llvm.org/D14113
llvm-svn: 251409
GNU tools require elfiamcu to take up the entire OS field, so, e.g.
i?86-*-linux-elfiamcu is not considered a legal triple.
Make us compatible.
Differential Revision: http://reviews.llvm.org/D14081
llvm-svn: 251390
When taking the remainder of a value divided by a constant, visitREM()
attempts to convert the REM to a longer but faster sequence of instructions.
This conversion calls combine() on a speculative DIV instruction. Commit
rL250825 may cause this combine() to return a DIVREM, corrupting nearby nodes.
Flow eventually hits unreachable().
This patch adds a test case and a check to prevent visitREM() from trying
to convert the REM instruction in cases where a DIVREM is possible.
See http://reviews.llvm.org/D14035
llvm-svn: 251373
When the target does not support these intrinsics they should be converted to a chain of scalar load or store operations.
If the mask is not constant, the scalarizer will build a chain of conditional basic blocks.
I added isLegalMaskedGather() isLegalMaskedScatter() APIs.
Differential Revision: http://reviews.llvm.org/D13722
llvm-svn: 251237
When using the MCU psABI, compiler-generated library calls should pass
some parameters in-register. However, since inreg marking for x86 is currently
done by the front end, it will not be applied to backend-generated calls.
This is a workaround for PR3997, which describes a similar issue for -mregparm.
Differential Revision: http://reviews.llvm.org/D13977
llvm-svn: 251223
We don't need a mask of a rotation result to be a constant splat - any constant scalar/vector can be usefully folded.
Followup to D13851.
llvm-svn: 251197
This patch adds support for lowering to the XOP VPROT / VPROTI vector bit rotation instructions.
This has required changes to the DAGCombiner rotation pattern matching to support vector types - so far I've only changed it to support splat vectors, but generalising this further is feasible in the future.
Differential Revision: http://reviews.llvm.org/D13851
llvm-svn: 251188
Summary:
The logic here isn't straightforward because our support for
TargetOptions::GuaranteedTailCallOpt.
Also fix a bug where we were allowing tail calls to cdecl functions from
fastcall and vectorcall functions. We were special casing thiscall and
stdcall callers rather than checking for any convention that requires
clearing stack arguments before returning.
Reviewers: hans
Subscribers: llvm-commits
Differential Revision: http://reviews.llvm.org/D14024
llvm-svn: 251137
Summary:
This ensures that BranchFolding (and similar) won't remove these blocks.
Also allow AsmPrinter::EmitBasicBlockStart to process MBBs which are
address-taken but do not have BBs that are address-taken, since otherwise
its call to getAddrLabelSymbolTableToEmit would fail an assertion on such
blocks. I audited the other callers of getAddrLabelSymbolTableToEmit
(and getAddrLabelSymbol); they all have BBs known to be address-taken
except for the call through getAddrLabelSymbol from
WinException::create32bitRef; that call is actually now unreachable, so
I've removed it and updated the signature of create32bitRef.
This fixes PR25168.
Reviewers: majnemer, andrew.w.kaylor, rnk
Subscribers: pgavlin, llvm-commits
Differential Revision: http://reviews.llvm.org/D13774
llvm-svn: 251113
When we fold "mul ((add x, c1), c1)" -> "add ((mul x, c2), c1*c2)", we bail if (add x, c1) has multiple
users which would result in an extra add instruction.
In such cases, this patch adds a check to see if we can eliminate a multiply instruction in exchange for the extra add.
I also added the capability of doing the existing optimization with non-splatted vectors (splatted also works).
Differential Revision: http://reviews.llvm.org/D13740
llvm-svn: 251028
When we have to convert the masked.load, masked.store to scalar code, we generate a chain of conditional basic blocks.
I added optimization for constant mask vector.
Differential Revision: http://reviews.llvm.org/D13855
llvm-svn: 250893
The mask value type for maskload/maskstore GCC builtins is never a vector of
packed floats/doubles.
This patch fixes the following issues:
1. The mask argument for builtin_ia32_maskloadpd and builtin_ia32_maskstorepd
should be of type llvm_v2i64_ty and not llvm_v2f64_ty.
2. The mask argument for builtin_ia32_maskloadpd256 and
builtin_ia32_maskstorepd256 should be of type llvm_v4i64_ty and not
llvm_v4f64_ty.
3. The mask argument for builtin_ia32_maskloadps and builtin_ia32_maskstoreps
should be of type llvm_v4i32_ty and not llvm_v4f32_ty.
4. The mask argument for builtin_ia32_maskloadps256 and
builtin_ia32_maskstoreps256 should be of type llvm_v8i32_ty and not
llvm_v8f32_ty.
Differential Revision: http://reviews.llvm.org/D13776
llvm-svn: 250817
Simon Pilgrim