calling functions. This is necessary on Mac OS X, since bad things can happen if you set
the registers of a thread that's sitting in a kernel trap.
<rdar://problem/11145013>
llvm-svn: 160756
Allow debugserver to match process names that are longer than MAXCOMLEN (16) characters. We do this by digging up argv[0] from another sysctl if the process name supplied is longer than 16 characters.
llvm-svn: 160487
Designate MachThreadList as a transaction coordinator when doing Enable/DisableHardwareWatchpoint on the list of threads.
In case the operation (iterating on the threads and doing enable/disable) fails in the middle, we rollback the already
enabled/disabled threads to their checkpointed states. When all the threads succeed in enable/disable, we ask each thread
to finsih the transaction and commit the change of the debug state.
llvm-svn: 157858
Add default Process::GetWatchpointSupportInfo() impl which returns an error of "not supported".
Add "qWatchpointSupportInfo" packet to the gdb communication layer to support this, and modify TestWatchpointCommands.py to test it.
llvm-svn: 157345
Switch over to the "*-apple-macosx" for desktop and "*-apple-ios" for iOS triples.
Also make the selection process for auto selecting platforms based off of an arch much better.
llvm-svn: 156354
should be MasterPlans that want to stay on the plan stack. So make all plans NOT
MasterPlans by default and then have the SB API's and the CommandObjectThread step
commands set this explicitly.
Also added a "clean up" phase to the Thread::ShouldStop so that if plans get stranded
on the stack, we can remove them. This is done by adding an IsPlanStale method to the
thread plans, and if the plan can know that it is no longer relevant, it returns true,
and the plan and its sub-plans will get discarded.
llvm-svn: 156101
QListThreadsInStopReply
This GDB remote query command can enable added a "threads" key/value pair to all stop reply packets so that we always get a list of all threads in each stop reply packet. It increases performance if enabled (the reply to the "QListThreadsInStopReply" is "OK") by saving us from sending to command/reply pairs (the "qfThreadInfo" and "qsThreadInfo" packets), and also helps us keep the current process state up to date.
llvm-svn: 154380
We do this by delegating to two available Watchpoint Register Pairs (wvr, wcr). With
each pair handling the 4 bytes of (uint64_t)variable.
llvm-svn: 153300
that the inferior cannot execute past the watchpoint-triggering instruction.
The solution is disable the watchpoint before resuming the inferior and make it hardware single step;
when the inferior stops again due to single step, re-enable the watchpoint and disable the single step
to make the inferior able to continue again without obstacle.
rdar://problem/9667960
llvm-svn: 153273
However, the debugserver cannot get past the instruction which triggered the watchpoint.
So a workaround is in place for the time being which disables the triggered watchpoint
before resuming.
Lots of commented out printf's remain in the source which needs to be cleaned up.
WIP rdar://problem/9667960
llvm-svn: 153228
Sean Callanan