These flags are now always passed to all tests and need to be disabled if
not needed. Disabling these flags, rather than passing them to almost all
tests, significantly simplfies our RUN: lines.
llvm-svn: 249422
I just learned that target triples prevent test cases to be run on other
architectures. Polly test cases are until now sufficiently target independent
to not require any target triples. Hence, we drop them.
llvm-svn: 235384
Scops that only read seem generally uninteresting and scops that only write are
most likely initializations where there is also little to optimize. To not
waste compile time we bail early.
Differential Revision: http://reviews.llvm.org/D7735
llvm-svn: 229820
SCEV based code generation has been the default for two weeks after having
been tested for a long time. We now drop the support the non-scev-based code
generation.
llvm-svn: 222978
This patch changes the RegionSet type used in ScopDetection from a
std::set to a llvm::SetVector. The reason for the change is to
ensure deterministic output when printing the result of the
analysis. We had a windows buildbot failure for the modified test
because the output was coming in a different order.
Only one test case needed to be modified for this change. We could
use CHECK-DAG directives instead of CHECK in the analysis test cases
because the actual order of scops does not matter, but I think that
change should be done in a separate patch that modifies all the
appliciable tests. I simply modified the test to reflect the
expected deterministic output.
Differential Revision: http://reviews.llvm.org/D5897
llvm-svn: 220423
In rare cases the modification of one scop can effect the validity of other
scops, as code generation of an earlier scop may make the scalar evolution
functions derived for later scops less precise. The example that triggered this
patch was a scop that contained an 'or' expression as follows:
%add13710 = or i32 %j.19, 1
--> {(1 + (4 * %l)),+,2}<nsw><%for.body81>
Scev could only analyze the 'or' as it knew %j.19 is a multiple of 2. This
information was not available after the first scop was code generated (or
independent-blocks was run on it) and SCEV could not derive a precise SCEV
expression any more. This means we could not any more code generate this SCoP.
My current understanding is that there is always the risk that an earlier code
generation change invalidates later scops. As the example we have seen here is
difficult to avoid, we use this occasion to guard us against all such
invalidations.
This patch "solves" this issue by verifying right before we start working on
a detected scop, if this scop is in fact still valid. This adds a certain
overhead. However the verification we run is anyways very fast and secondly
it is only run on detected scops. So the overhead should not be very large. As
a later optimization we could detect scops only on demand, such that we need
to run scop-detections always only a single time.
This should fix the single last failure in the LLVM test-suite for the new
scev-based code generation.
llvm-svn: 201593
Tobias Grosser