A test case was found with llvm-stress that caused DAGCombiner to crash
when compiling for an older subtarget without vector support.
SystemZTargetLowering::combineTruncateExtract() should do nothing for older
subtargets.
This check was placed in canTreatAsByteVector(), which also helps in a few
other places.
Review: Ulrich Weigand
llvm-svn: 299763
A number of backends (AArch64, MIPS, ARM) have been using
MCContext::reportError to report issues such as out-of-range fixup values in
their TgtAsmBackend. This is great, but because MCContext couldn't easily be
threaded through to the adjustFixupValue helper function from its usual
callsite (applyFixup), these backends ended up adding an MCContext* argument
and adding another call to applyFixup to processFixupValue. Adding an
MCContext parameter to applyFixup makes this unnecessary, and even better -
applyFixup can take a reference to MCContext rather than a potentially null
pointer.
Differential Revision: https://reviews.llvm.org/D30264
llvm-svn: 299529
Since LOCR only accepts GR32 virtual registers, its operands must be copied
into this regclass in insertSelect(), when an LOCR is built. Otherwise, the
case where the source operand was GRX32 will produce invalid IR.
Review: Ulrich Weigand
llvm-svn: 299220
Even on older subtargets that lack vector support, there may be vector values
with just one element in the input program. These are converted during DAG
legalization to scalar values.
The pre-legalize SystemZ DAGCombiner methods should in this circumstance not
touch these nodes. This patch adds a check for this in
SystemZTargetLowering::combineEXTRACT_VECTOR_ELT().
Review: Ulrich Weigand
llvm-svn: 299213
The def operand of the new LG/LD should have the old def operands
flags and subreg index.
New test: test/CodeGen/SystemZ/fold-memory-op-impl.ll
Review: Ulrich Weigand
llvm-svn: 298341
If one of the subregs of the 128 bit reg is undefined when splitMove() splits
a store into two instructions, a use of an undefined physical register
results.
To remedy this, an implicit use of the super register is added onto both new
instructions, along with propagated kill and undef flags.
This was discovered with llvm-stress, and that test case is attached as
test/CodeGen/SystemZ/splitMove_undefReg_mverifier.ll
Thanks to Matthias Braun for helping with a nice explanation.
Review: Ulrich Weigand
llvm-svn: 298047
The GeneralShuffle::add() method used to have an assert that made sure that
source elements were at least as big as the destination elements. This was
wrong, since it is actually expected that an EXTRACT_VECTOR_ELT node with a
smaller source element type than the return type gets extended.
Therefore, instead of asserting this, it is just checked and if this is the
case 'false' is returned from the GeneralShuffle::add() method. This case
should be very rare and is not handled further by the backend.
Review: Ulrich Weigand.
llvm-svn: 292888
Vector immediate load instructions should have the isAsCheapAsAMove, isMoveImm
and isReMaterializable flags set. With them, these instruction will get
hoisted out of loops.
Review: Ulrich Weigand
llvm-svn: 292790
During post-RA pseudo expansion, an 'undef' flag of the source operand should
be propagated by emitGRX32Move().
Review: Ulrich Weigand
llvm-svn: 292353
Rename from addOperand to just add, to match the other method that has been
added to MachineInstrBuilder for adding more than just 1 operand.
See https://reviews.llvm.org/D28057 for the whole discussion.
Differential Revision: https://reviews.llvm.org/D28556
llvm-svn: 291891
A store of an extracted element or a load which gets inserted into a vector,
will be combined into a vector load/store element instruction.
Therefore, isFoldableMemAccessOffset(), which is called by LSR, should
return false in these cases.
Reviewer: Ulrich Weigand
llvm-svn: 291673
Add assembler support for all atomic instructions that weren't already
supported. Some of those could be used to implement codegen for 128-bit
atomic operations, but this isn't done here yet.
llvm-svn: 288526
Add assembler support for instructions manipulating the FPC.
Also add codegen support via the GCC compatibility builtins:
__builtin_s390_sfpc
__builtin_s390_efpc
llvm-svn: 288525
Move setting of hasSideEffects out of SystemZInstrFormats.td,
to allow use of the format classes for instructions where this
flag shouldn't be set. NFC.
llvm-svn: 288524
Recommitting r288293 with some extra fixes for GlobalISel code.
Most of the exception handling members in MachineModuleInfo is actually
per function data (talks about the "current function") so it is better
to keep it at the function instead of the module.
This is a necessary step to have machine module passes work properly.
Also:
- Rename TidyLandingPads() to tidyLandingPads()
- Use doxygen member groups instead of "//===- EH ---"... so it is clear
where a group ends.
- I had to add an ugly const_cast at two places in the AsmPrinter
because the available MachineFunction pointers are const, but the code
wants to call tidyLandingPads() in between
(markFunctionEnd()/endFunction()).
Differential Revision: https://reviews.llvm.org/D27227
llvm-svn: 288405
Now that we have fixups that only fill parts of a byte, it turns
out we have to mask off the bits outside the fixup area when
applying them. Failing to do so caused invalid object code to
be emitted for bprp with a negative 12-bit displacement.
llvm-svn: 288374
Most of the exception handling members in MachineModuleInfo is actually
per function data (talks about the "current function") so it is better
to keep it at the function instead of the module.
This is a necessary step to have machine module passes work properly.
Also:
- Rename TidyLandingPads() to tidyLandingPads()
- Use doxygen member groups instead of "//===- EH ---"... so it is clear
where a group ends.
- I had to add an ugly const_cast at two places in the AsmPrinter
because the available MachineFunction pointers are const, but the code
wants to call tidyLandingPads() in between
(markFunctionEnd()/endFunction()).
Differential Revision: https://reviews.llvm.org/D27227
llvm-svn: 288293
This is per function data so it is better kept at the function instead
of the module.
This is a necessary step to have machine module passes work properly.
Differential Revision: https://reviews.llvm.org/D27185
llvm-svn: 288291
This adds assembler support for the instructions provided by the
execution-hint facility (NIAI and BP(R)P). This required adding
support for the new relocation types for 12-bit and 24-bit PC-
relative offsets used by the BP(R)P instructions.
llvm-svn: 288031
This patch adds assembler support for the remaining branch instructions:
the non-relative branch on count variants, and all variants of branch
on index.
The only one of those that can be readily exploited for code generation
is BRCTH (branch on count using a high 32-bit register as count). Do
use it, however, it is necessary to also introduce a hew CHIMux pseudo
to allow comparisons of a 32-bit value agains a short immediate to go
into a high register as well (implemented via CHI/CIH).
This causes a bit of codegen changes overall, but those have proven to
be neutral (or even beneficial) in performance measurements.
llvm-svn: 288029
This patch moves formation of LOC-type instructions from (late)
IfConversion to the early if-conversion pass, and in some cases
additionally creates them directly from select instructions
during DAG instruction selection.
To make early if-conversion work, the patch implements the
canInsertSelect / insertSelect callbacks. It also implements
the commuteInstructionImpl and FoldImmediate callbacks to
enable generation of the full range of LOC instructions.
Finally, the patch adds support for all instructions of the
load-store-on-condition-2 facility, which allows using LOC
instructions also for high registers.
Due to the use of the GRX32 register class to enable high registers,
we now also have to handle the cases where there are still no single
hardware instructions (conditional move from a low register to a high
register or vice versa). These are converted back to a branch sequence
after register allocation. Since the expandRAPseudos callback is not
allowed to create new basic blocks, this requires a simple new pass,
modelled after the ARM/AArch64 ExpandPseudos pass.
Overall, this patch causes significantly more LOC-type instructions
to be used, and results in a measurable performance improvement.
llvm-svn: 288028
Summary:
* ARM is omitted from this patch because this check appears to expose bugs in this target.
* Mips is omitted from this patch because this check either detects bugs or deliberate
emission of instructions that don't satisfy their predicates. One deliberate
use is the SYNC instruction where the version with an operand is correctly
defined as requiring MIPS32 while the version without an operand is defined
as an alias of 'SYNC 0' and requires MIPS2.
* X86 is omitted from this patch because it doesn't use the tablegen-erated
MCCodeEmitter infrastructure.
Patches for ARM and Mips will follow.
Depends on D25617
Reviewers: tstellarAMD, jmolloy
Subscribers: wdng, jmolloy, aemerson, rengolin, arsenm, jyknight, nemanjai, nhaehnle, tstellarAMD, llvm-commits
Differential Revision: https://reviews.llvm.org/D25618
llvm-svn: 287439
This adds support for the compare logical and trap (memory)
instructions that were added as part of the miscellaneous
instruction extensions feature with zEC12.
llvm-svn: 286587
This adds support for the LZRF/LZRG/LLZRGF instructions that were
added on z13, and uses them for code generation were appropriate.
SystemZDAGToDAGISel::tryRISBGZero is updated again to prefer LLZRGF
over RISBG where both would be possible.
llvm-svn: 286586
This adds support for the 31-to-64-bit zero extension instructions
LLGT and LLGTR and uses them for code generation where appropriate.
Since this operation can also be performed via RISBG, we have to
update SystemZDAGToDAGISel::tryRISBGZero so that we prefer LLGT
over RISBG in case both are possible. The patch includes some
simplification to the tryRISBGZero code; this is not intended
to cause any (further) functional change in codegen.
llvm-svn: 286585
The name/comment of the third argument to the ScheduleDAGMI constructor
is RemoveKillFlags and not IsPostRA. Only the comments are changed.
Review: A Trick
llvm-svn: 286350
This completes assembler / disassembler support for all BFP
instructions provided by the floating-point extensions facility.
The instructions added here are not currently used for codegen.
llvm-svn: 286285
Add several instructions that operate on the program mask
or the addressing mode. These are not really needed for
code generation under Linux, but are provided for completeness
for the assembler/disassembler.
llvm-svn: 286284
Add the 16 access registers as LLVM registers. This allows removing
a lot of special cases in the assembler and disassembler where we
were handling access registers; this can all just use the generic
register code now.
Also add a bunch of instructions to operate on access registers,
for assembler/disassembler use only. No change in code generation
intended.
llvm-svn: 286283
Define a couple of additional semantic classes and use them
throughout the .td files to make them more consistent and
more easily readable.
No functional change.
llvm-svn: 286268
This changes the InstRR (and related) patterns to no longer
automatically add an "r" at the end of the mnemonic. This
makes the .td files more obviously understandable, and also
allows using the patterns for those few instructions that
do not follow the *r scheme.
Also add some more sub-formats of the RRF format class, to
match operand names and sequence from the PoP better.
No functional change.
llvm-svn: 286267
Now that we've added instruction format subclasses like
InstRIb, it makes sense to rename the old InstRI to InstRIa.
Similar for InstRX, InstRXY, InstRS, InstRSY, and InstSS.
No functional change.
llvm-svn: 286266
Rework patterns for branches, call & return instructions,
compare-and-branch, compare-and-trap, and conditional move
instructions.
In particular, simplify creation of patterns for the extended
opcodes of instructions that take a CC mask.
Also, use semantical instruction classes for all the instructions
instead of open-coding them in SystemZInstrInfo.td.
Adds a couple of the basic branch instructions (that are unused
for codegen) for the assembler/disassembler.
llvm-svn: 286263
* Use a generic vector unit to model the issue unit more accurately.
* Update some vector instructions that actually use the vector unit for more
than one cycle.
Review: Ulrich Weigand
llvm-svn: 286112
IssueWidth updated to reflect the capacity of the issue unit correctly.
Correct number of FX and LS units modelled (2, was 1).
Review: Ulrich Weigand
llvm-svn: 286109
Jonas Paulsson