linux-sg2042/arch/avr32/mach-at32ap/include/mach/board.h

134 lines
3.7 KiB
C

/*
* Platform data definitions.
*/
#ifndef __ASM_ARCH_BOARD_H
#define __ASM_ARCH_BOARD_H
#include <linux/types.h>
#define GPIO_PIN_NONE (-1)
/*
* Clock rates for various on-board oscillators. The number of entries
* in this array is chip-dependent.
*/
extern unsigned long at32_board_osc_rates[];
/*
* This used to add essential system devices, but this is now done
* automatically. Please don't use it in new board code.
*/
static inline void __deprecated at32_add_system_devices(void)
{
}
#define ATMEL_MAX_UART 4
extern struct platform_device *atmel_default_console_device;
/* Flags for selecting USART extra pins */
#define ATMEL_USART_RTS 0x01
#define ATMEL_USART_CTS 0x02
#define ATMEL_USART_CLK 0x04
struct atmel_uart_data {
short use_dma_tx; /* use transmit DMA? */
short use_dma_rx; /* use receive DMA? */
void __iomem *regs; /* virtual base address, if any */
};
void at32_map_usart(unsigned int hw_id, unsigned int line, int flags);
struct platform_device *at32_add_device_usart(unsigned int id);
struct eth_platform_data {
u32 phy_mask;
u8 is_rmii;
};
struct platform_device *
at32_add_device_eth(unsigned int id, struct eth_platform_data *data);
struct spi_board_info;
struct platform_device *
at32_add_device_spi(unsigned int id, struct spi_board_info *b, unsigned int n);
void at32_spi_setup_slaves(unsigned int bus_num, struct spi_board_info *b, unsigned int n);
struct atmel_lcdfb_info;
struct platform_device *
at32_add_device_lcdc(unsigned int id, struct atmel_lcdfb_info *data,
unsigned long fbmem_start, unsigned long fbmem_len,
u64 pin_mask);
struct usba_platform_data;
struct platform_device *
at32_add_device_usba(unsigned int id, struct usba_platform_data *data);
struct ide_platform_data {
u8 cs;
};
struct platform_device *
at32_add_device_ide(unsigned int id, unsigned int extint,
struct ide_platform_data *data);
/* mask says which PWM channels to mux */
struct platform_device *at32_add_device_pwm(u32 mask);
/* depending on what's hooked up, not all SSC pins will be used */
#define ATMEL_SSC_TK 0x01
#define ATMEL_SSC_TF 0x02
#define ATMEL_SSC_TD 0x04
#define ATMEL_SSC_TX (ATMEL_SSC_TK | ATMEL_SSC_TF | ATMEL_SSC_TD)
#define ATMEL_SSC_RK 0x10
#define ATMEL_SSC_RF 0x20
#define ATMEL_SSC_RD 0x40
#define ATMEL_SSC_RX (ATMEL_SSC_RK | ATMEL_SSC_RF | ATMEL_SSC_RD)
struct platform_device *
at32_add_device_ssc(unsigned int id, unsigned int flags);
struct i2c_board_info;
struct platform_device *at32_add_device_twi(unsigned int id,
struct i2c_board_info *b,
unsigned int n);
struct mci_platform_data;
struct platform_device *
at32_add_device_mci(unsigned int id, struct mci_platform_data *data);
struct ac97c_platform_data;
struct platform_device *
at32_add_device_ac97c(unsigned int id, struct ac97c_platform_data *data,
unsigned int flags);
struct atmel_abdac_pdata;
struct platform_device *
at32_add_device_abdac(unsigned int id, struct atmel_abdac_pdata *data);
struct platform_device *at32_add_device_psif(unsigned int id);
struct cf_platform_data {
int detect_pin;
int reset_pin;
int vcc_pin;
int ready_pin;
u8 cs;
};
struct platform_device *
at32_add_device_cf(unsigned int id, unsigned int extint,
struct cf_platform_data *data);
/* NAND / SmartMedia */
struct atmel_nand_data {
int enable_pin; /* chip enable */
int det_pin; /* card detect */
int rdy_pin; /* ready/busy */
u8 rdy_pin_active_low; /* rdy_pin value is inverted */
u8 ale; /* address line number connected to ALE */
u8 cle; /* address line number connected to CLE */
u8 bus_width_16; /* buswidth is 16 bit */
struct mtd_partition *(*partition_info)(int size, int *num_partitions);
};
struct platform_device *
at32_add_device_nand(unsigned int id, struct atmel_nand_data *data);
#endif /* __ASM_ARCH_BOARD_H */