If either _alt_hps2fpga_enable_set() or fpga_bridge_register() fail in
alt_fpga_bridge_probe(), the clock remains enabled and prepared. Also,
in the error path for _alt_hps2fpga_enable_set() a call to
fpga_bridge_unregister() is made even though the bridge was not
registered yet.
Remove the unnecessary call to fpga_bridge_unregister() and call
clk_disable_unprepare() in both error paths in order to make sure the
clock gets properly disabled and unprepared.
Signed-off-by: Tobias Klauser <tklauser@distanz.ch>
Acked-by: Moritz Fischer <mdf@kernel.org>
Signed-off-by: Alan Tull <atull@kernel.org>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
Supports Altera SOCFPGA bridges:
* fpga2sdram
* fpga2hps
* hps2fpga
* lwhps2fpga
Allows enabling/disabling the bridges through the FPGA
Bridge Framework API functions.
The fpga2sdram driver only supports enabling and disabling
of the ports that been configured early on. This is due to
a hardware limitation where the read, write, and command
ports on the fpga2sdram bridge can only be reconfigured
while there are no transactions to the sdram, i.e. when
running out of OCRAM before the kernel boots.
Device tree property 'init-val' configures the driver to
enable or disable the bridge during probe. If the property
does not exist, the driver will leave the bridge in its
current state.
Signed-off-by: Alan Tull <atull@opensource.altera.com>
Signed-off-by: Matthew Gerlach <mgerlach@altera.com>
Signed-off-by: Dinh Nguyen <dinguyen@opensource.altera.com>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
Tobias Klauser