This fixes an out-of-boundary condition when the classified
band equals q->bands. Caught by Alexey
Signed-off-by: Jamal Hadi Salim <hadi@cyberus.ca>
Signed-off-by: David S. Miller <davem@davemloft.net>
When we relinquish queue_lock in qdisc_restart and then retake it for
requeueing, we might race against dev_deactivate and end up requeueing
onto noop_qdisc. This causes a warning to be printed.
This patch fixes this by checking this before we requeue. As an added
bonus, we can remove the same check in __qdisc_run which was added to
prevent dev->gso_skb from being requeued when we're shutting down.
Even though we've had to add a new conditional in its place, it's better
because it only happens on requeues rather than every single time that
qdisc_run is called.
For this to work we also need to move the clearing of gso_skb up in
dev_deactivate as now qdisc_restart can occur even after we wait for
__LINK_STATE_QDISC_RUNNING to clear (but it won't do anything as long
as the queue and gso_skb is already clear).
Signed-off-by: Herbert Xu <herbert@gondor.apana.org.au>
Signed-off-by: David S. Miller <davem@davemloft.net>
Now that we return the queue length after NETDEV_TX_OK we better
make sure that we have the right queue. Otherwise we can cause a
stall after a really quick dev_deactive/dev_activate.
Signed-off-by: Herbert Xu <herbert@gondor.apana.org.au>
Signed-off-by: David S. Miller <davem@davemloft.net>
The current return value scheme and associated comment was invented
back in the 20th century when we still had that tbusy flag. Things
have changed quite a bit since then (even Tony Blair is moving on
now, not to mention the new French president).
All we need to indicate now is whether the caller should continue
processing the queue. Therefore it's sufficient if we return 0 if
we want to stop and non-zero otherwise.
This is based on a patch by Krishna Kumar.
Signed-off-by: Herbert Xu <herbert@gondor.apana.org.au>
Signed-off-by: David S. Miller <davem@davemloft.net>
When transmit fails with NETDEV_TX_LOCKED the skb is requeued
to dev->qdisc again. The dev->qdisc pointer is protected by
the queue lock which needs to be dropped when attempting to
transmit and acquired again before requeing. The problem is
that qdisc_restart() fetches the dev->qdisc pointer once and
stores it in the `q' variable which is invalidated when
dropping the queue_lock, therefore the variable needs to be
refreshed before requeueing.
Signed-off-by: Thomas Graf <tgraf@suug.ch>
Signed-off-by: David S. Miller <davem@davemloft.net>
Optimize teql_enqueue so that it first checks limits before enqueing.
Signed-off-by: Krishna Kumar <krkumar2@in.ibm.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
Cleanup of dev_base list use, with the aim to simplify making device
list per-namespace. In almost every occasion, use of dev_base variable
and dev->next pointer could be easily replaced by for_each_netdev
loop. A few most complicated places were converted to using
first_netdev()/next_netdev().
Signed-off-by: Pavel Emelianov <xemul@openvz.org>
Acked-by: Kirill Korotaev <dev@openvz.org>
Signed-off-by: David S. Miller <davem@davemloft.net>
Spring cleaning time...
There seems to be a lot of places in the network code that have
extra bogus semicolons after conditionals. Most commonly is a
bogus semicolon after: switch() { }
Signed-off-by: Stephen Hemminger <shemminger@linux-foundation.org>
Signed-off-by: David S. Miller <davem@davemloft.net>
Switch ingress queueing back to use ingress_lock. qdisc_lock_tree now locks
both the ingress and egress qdiscs on the device. All changes to data that
might be used on both ingress and egress needs to be protected by using
qdisc_lock_tree instead of manually taking dev->queue_lock. Additionally
the qdisc stats_lock needs to be initialized to ingress_lock for ingress
qdiscs.
Signed-off-by: Patrick McHardy <kaber@trash.net>
Signed-off-by: David S. Miller <davem@davemloft.net>
Since we're now holding the rtnl during the entire dump operation, we
can remove qdisc_tree_lock, whose only purpose is to protect dump
callbacks from concurrent changes to the qdisc tree.
Signed-off-by: Patrick McHardy <kaber@trash.net>
Signed-off-by: David S. Miller <davem@davemloft.net>
We're holding dev->queue_lock in qdisc_watchdog_schedule and
qdisc_watchdog_cancel, no need for the barriers.
Signed-off-by: Patrick McHardy <kaber@trash.net>
Signed-off-by: David S. Miller <davem@davemloft.net>
Uninline tcf_destroy and add a helper function to destroy an entire filter
chain.
Signed-off-by: Patrick McHardy <kaber@trash.net>
Signed-off-by: David S. Miller <davem@davemloft.net>
netem checks PSCHED_TLESS(cb->time_to_send, now) to find out whether it is
allowed to send a packet, which is equivalent to cb->time_to_send < now.
Use !PSCHED_TLESS(now, cb->time_to_send) instead to properly handle
cb->time_to_send == now.
Signed-off-by: Patrick McHardy <kaber@trash.net>
Signed-off-by: David S. Miller <davem@davemloft.net>
Get rid of some of my creative spelling.
Signed-off-by: Stephen Hemminger <shemminger@linux-foundation.org>
Signed-off-by: David S. Miller <davem@davemloft.net>
If possible, avoid having to do a transmit softirq when a qdisc
watchdog decides to re-enable. The watchdog routine runs off
a timer, so it is already in the same effective context as
the softirq.
Signed-off-by: Stephen Hemminger <shemminger@linux-foundation.org>
Signed-off-by: David S. Miller <davem@davemloft.net>
The netem code would call getnstimeofday() and dequeue/requeue after
every packet, even if it was waiting. Avoid this overhead by using
the throttled flag.
Signed-off-by: Stephen Hemminger <shemminger@linux-foundation.org>
Signed-off-by: David S. Miller <davem@davemloft.net>
In most cases, the next packet will be sent after the
last one. So optimize that case.
Signed-off-by: Stephen Hemminger <shemminger@linux-foundation.org>
Signed-off-by: David S. Miller <davem@davemloft.net>
The random number generator always generates 32 bit values.
The time values are limited by psched_tdiff_t
Signed-off-by: Stephen Hemminger <shemminger@linux-foundation.org>
Signed-off-by: David S. Miller <davem@davemloft.net>
If you setup netem to just delay packets; "tc qdisc ls" will report
the reordering as 100%. Well it's a lie, reorder isn't used unless
gap is set, so just set value to 0 so the output of utility
is correct.
Signed-off-by: Stephen Hemminger <shemminger@linux-foundation.org>
Signed-off-by: David S. Miller <davem@davemloft.net>
So that it is also an offset from skb->head, reduces its size from 8 to 4 bytes
on 64bit architectures, allowing us to combine the 4 bytes hole left by the
layer headers conversion, reducing struct sk_buff size to 256 bytes, i.e. 4
64byte cachelines, and since the sk_buff slab cache is SLAB_HWCACHE_ALIGN...
:-)
Many calculations that previously required that skb->{transport,network,
mac}_header be first converted to a pointer now can be done directly, being
meaningful as offsets or pointers.
Signed-off-by: Arnaldo Carvalho de Melo <acme@redhat.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
net/sched/sch_api.c: In function 'psched_show':
net/sched/sch_api.c:1219: warning: format '%08x' expects type 'unsigned int', but argument 6 has type 's64'
Signed-off-by: Patrick McHardy <kaber@trash.net>
Signed-off-by: David S. Miller <davem@davemloft.net>
q->now is increased during dequeue and doesn't contain the current time
afterwards, resulting in a too large timeout value for the qdisc watchdog.
Use "now" instead, which still contains the current time.
Signed-off-by: Patrick McHardy <kaber@trash.net>
Signed-off-by: David S. Miller <davem@davemloft.net>
The timer resolution exported in /proc/net/psched is used by userspace to
calculate HTB's burst values. Currently it is set to HZ, since we're now
using hrtimers, use KTIME_MONOTONIC_RES, which makes HTB use smaller burst
values.
This patch also affects libnl, which incorrectly uses this value for
the SFQ perturbation parameter, which is always in seconds, and some
routing cache values, which are in USER_HZ, so both cases are broken
anyway.
Signed-off-by: Patrick McHardy <kaber@trash.net>
Signed-off-by: David S. Miller <davem@davemloft.net>
Now that all packet schedulers have been converted to hrtimers most users
of PSCHED_JIFFIE2US and PSCHED_US2JIFFIE are gone. The remaining users use
it to convert external time units to packet scheduler clock ticks, so use
PSCHED_TICKS_PER_SEC instead.
Signed-off-by: Patrick McHardy <kaber@trash.net>
Signed-off-by: David S. Miller <davem@davemloft.net>
Switch delay_timer to hrtimer.
The class penalty parameter is changed to use psched ticks as units.
Since iproute never supported using this and the only existing user
(libnl) incorrectly assumes psched ticks as units anyway, this
shouldn't break anything.
Signed-off-by: Patrick McHardy <kaber@trash.net>
Signed-off-by: David S. Miller <davem@davemloft.net>
cbq_undelay_prio is supposed to return a time delta, but returns the
current time for non-active priorities, causing cbq_undelay to mark
the priority as active and schedule a timer for twice the current
time.
Signed-off-by: Patrick McHardy <kaber@trash.net>
Signed-off-by: David S. Miller <davem@davemloft.net>
Get rid of the manual clock source selection mess and use ktime. Also
use a scalar representation, which allows to clean up pkt_sched.h a bit
more and results in less ktime_to_ns() calls in most cases.
The PSCHED_US2JIFFIE/PSCHED_JIFFIE2US macros are implemented quite
inefficient by this patch, following patches will convert all qdiscs
to hrtimers and get rid of them entirely.
Signed-off-by: Patrick McHardy <kaber@trash.net>
Signed-off-by: David S. Miller <davem@davemloft.net>
Now the skb->nh union has just one member, .raw, i.e. it is just like the
skb->mac union, strange, no? I'm just leaving it like that till the transport
layer is done with, when we'll rename skb->mac.raw to skb->mac_header (or
->mac_header_offset?), ditto for ->{h,nh}.
Signed-off-by: Arnaldo Carvalho de Melo <acme@redhat.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
For the places where we need a pointer to the network header, it is still legal
to touch skb->nh.raw directly if just adding to, subtracting from or setting it
to another layer header.
Signed-off-by: Arnaldo Carvalho de Melo <acme@redhat.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
For the quite common 'skb->nh.raw - skb->data' sequence.
Signed-off-by: Arnaldo Carvalho de Melo <acme@redhat.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
Userspace uses an integer for TCA_TCINDEX_SHIFT, the kernel was changed
to expect and use a u16 value in 2.6.11, which broke compatibility on
big endian machines. Change back to use int.
Reported by Ole Reinartz <ole.reinartz@gmx.de>
Signed-off-by: Patrick McHardy <kaber@trash.net>
Signed-off-by: David S. Miller <davem@davemloft.net>
Jamal Hadi Salim