The host1x driver prints out "disassembly" dumps of the command FIFO
and gather contents on submission timeouts. However, the output has
been quite difficult to read with unnecessary newlines and occasional
missing parentheses.
Fix these problems by using pr_cont to remove unnecessary newlines
and by fixing other small issues.
Signed-off-by: Mikko Perttunen <mperttunen@nvidia.com>
Reviewed-by: Dmitry Osipenko <digetx@gmail.com>
Tested-by: Dmitry Osipenko <digetx@gmail.com>
Signed-off-by: Thierry Reding <treding@nvidia.com>
This is largely a rewrite of the Host1x channel allocation code, bringing
several changes:
- The previous code could deadlock due to an interaction
between the 'reflock' mutex and CDMA timeout handling.
This gets rid of the mutex.
- Support for more than 32 channels, required for Tegra186
- General refactoring, including better encapsulation
of channel ownership handling into channel.c
Signed-off-by: Mikko Perttunen <mperttunen@nvidia.com>
Reviewed-by: Dmitry Osipenko <digetx@gmail.com>
Tested-by: Dmitry Osipenko <digetx@gmail.com>
Signed-off-by: Thierry Reding <treding@nvidia.com>
Insert a number of blank lines in places where they increase readability
of the code. Also collapse various variable declarations to shorten some
functions and finally rewrite some code for readability.
Signed-off-by: Thierry Reding <treding@nvidia.com>
Fix a couple of occurrences where no blank line was used to separate
variable declarations from code or where block comments were wrongly
formatted.
Signed-off-by: Thierry Reding <treding@nvidia.com>
The number of channels, syncpoints, bases and mlocks can never be
negative, so use unsigned int instead of int. Also make loop variables
the same type for consistency.
Signed-off-by: Thierry Reding <treding@nvidia.com>
When debugfs support isn't enabled, gcc complains about some variables
being unused. To avoid further #ifdefery, move debugfs specific setup
code into static functions and use IS_ENABLED(CONFIG_DEBUG_FS) to have
the compiler, rather than the preprocessor, discard them when unused.
The advantage of doing it this way is that all the code will be
compile-tested whether or not debugfs support is enabled.
Signed-off-by: Thierry Reding <treding@nvidia.com>
Add support for host1x debugging. Adds debugfs entries, and dumps
channel state to UART in case of stuck job.
Signed-off-by: Arto Merilainen <amerilainen@nvidia.com>
Signed-off-by: Terje Bergstrom <tbergstrom@nvidia.com>
Reviewed-by: Thierry Reding <thierry.reding@avionic-design.de>
Tested-by: Thierry Reding <thierry.reding@avionic-design.de>
Tested-by: Erik Faye-Lund <kusmabite@gmail.com>
Signed-off-by: Thierry Reding <thierry.reding@avionic-design.de>
Mikko Perttunen