Introduce an "auto-boot" flag on rprocs to make it possible to flag
remote processors without vdevs to automatically boot once the firmware
is found.
Preserve previous behavior of the wkup_m3 processor being explicitly
booted by a consumer.
Cc: Lee Jones <lee.jones@linaro.org>
Cc: Loic Pallardy <loic.pallardy@st.com>
Cc: Suman Anna <s-anna@ti.com>
Signed-off-by: Bjorn Andersson <bjorn.andersson@linaro.org>
Use MODULE_DEVICE_TABLE with wkup_m3_rproc_of_match so the module alias
is exported and the wkup_m3_rproc driver can automatically probe.
Signed-off-by: Dave Gerlach <d-gerlach@ti.com>
Signed-off-by: Ohad Ben-Cohen <ohad@wizery.com>
Add a remoteproc driver to load the firmware and boot a small
Wakeup M3 processor present on TI AM33xx and AM43xx SoCs. This
Wakeup M3 remote processor is an integrated Cortex M3 that allows
the SoC to enter the lowest possible power state by taking control
from the MPU after it has gone into its own low power state and
shutting off any additional peripherals.
The Wakeup M3 processor has two internal memory regions - 16 kB of
unified instruction memory called UMEM used to store executable
code, and 8 kB of data memory called DMEM used for all data sections.
The Wakeup M3 processor executes its code entirely from within the
UMEM and uses the DMEM for any data. It does not use any external
memory or any other external resources. The device address view has
the UMEM at address 0x0 and DMEM at address 0x80000, and these are
computed automatically within the driver based on relative address
calculation from the corresponding device tree IOMEM resources.
These device addresses are used to aid the core remoteproc ELF
loader code to properly translate and load the firmware segments
through the .rproc_da_to_va ops.
Signed-off-by: Dave Gerlach <d-gerlach@ti.com>
Signed-off-by: Suman Anna <s-anna@ti.com>
Signed-off-by: Ohad Ben-Cohen <ohad@wizery.com>
Bjorn Andersson