From fdb0436c35b86759da6d7fce27323e3cdced0e13 Mon Sep 17 00:00:00 2001 From: Olliver Schinagl Date: Tue, 11 Dec 2018 17:17:07 +0200 Subject: [PATCH] dt-bindings: mfd: axp20x: add support for regulator-ramp-delay for AXP209 The AXP209 supports ramping up voltages on several regulators such as DCDC2 and LDO3, therefore we can use the standard 'regulator-ramp-delay' property for those 2 regulators. Note that the voltage ramp only works when the regulator is already enabled. E.g. when going from say 0.7 V to 3.6 V. When turning on the regulator, no voltage ramp is performed in hardware. What this means, is that if the bootloader brings up the voltage at 0.7 V, the ramp delay property is properly applied. If however, the bootloader leaves the power off, no ramp delay is applied when the power is enabled by the regulator framework. Signed-off-by: Olliver Schinagl Signed-off-by: Priit Laes Acked-for-MFD-by: Lee Jones Signed-off-by: Mark Brown --- Documentation/devicetree/bindings/mfd/axp20x.txt | 6 ++++++ 1 file changed, 6 insertions(+) diff --git a/Documentation/devicetree/bindings/mfd/axp20x.txt b/Documentation/devicetree/bindings/mfd/axp20x.txt index 188f0373d441..c6266052d23f 100644 --- a/Documentation/devicetree/bindings/mfd/axp20x.txt +++ b/Documentation/devicetree/bindings/mfd/axp20x.txt @@ -32,6 +32,12 @@ Required properties: - interrupt-controller: The PMIC has its own internal IRQs - #interrupt-cells: Should be set to 1 +Supported common regulator properties, see ../regulator/regulator.txt for +more information: +- regulator-ramp-delay: sets the ramp up delay in uV/us + AXP20x/DCDC2: 1600, 800 + AXP20x/LDO3: 1600, 800 + Optional properties: - x-powers,dcdc-freq: defines the work frequency of DC-DC in KHz AXP152/20X: range: 750-1875, Default: 1.5 MHz