Merge branch 'master' of git://git.kernel.org/pub/scm/linux/kernel/git/linville/wireless into for-davem

drivers/net/wireless/iwlwifi/iwl-trans-pcie.c

@@ -990,29 +990,16 @@ static int iwl_trans_tx_stop(struct iwl_trans *trans)
 	return 0;
 }
 
-static void iwl_trans_pcie_disable_sync_irq(struct iwl_trans *trans)
+static void iwl_trans_pcie_stop_device(struct iwl_trans *trans)
 {
 	unsigned long flags;
-	struct iwl_trans_pcie *trans_pcie =
-		IWL_TRANS_GET_PCIE_TRANS(trans);
+	struct iwl_trans_pcie *trans_pcie = IWL_TRANS_GET_PCIE_TRANS(trans);
 
+	/* tell the device to stop sending interrupts */
 	spin_lock_irqsave(&trans->shrd->lock, flags);
 	iwl_disable_interrupts(trans);
 	spin_unlock_irqrestore(&trans->shrd->lock, flags);
 
-	/* wait to make sure we flush pending tasklet*/
-	synchronize_irq(bus(trans)->irq);
-	tasklet_kill(&trans_pcie->irq_tasklet);
-}
-
-static void iwl_trans_pcie_stop_device(struct iwl_trans *trans)
-{
-	/* stop and reset the on-board processor */
-	iwl_write32(bus(trans), CSR_RESET, CSR_RESET_REG_FLAG_NEVO_RESET);
-
-	/* tell the device to stop sending interrupts */
-	iwl_trans_pcie_disable_sync_irq(trans);
-
 	/* device going down, Stop using ICT table */
 	iwl_disable_ict(trans);
 
@@ -1039,6 +1026,20 @@ static void iwl_trans_pcie_stop_device(struct iwl_trans *trans)
 
 	/* Stop the device, and put it in low power state */
 	iwl_apm_stop(priv(trans));
+
+	/* Upon stop, the APM issues an interrupt if HW RF kill is set.
+	 * Clean again the interrupt here
+	 */
+	spin_lock_irqsave(&trans->shrd->lock, flags);
+	iwl_disable_interrupts(trans);
+	spin_unlock_irqrestore(&trans->shrd->lock, flags);
+
+	/* wait to make sure we flush pending tasklet*/
+	synchronize_irq(bus(trans)->irq);
+	tasklet_kill(&trans_pcie->irq_tasklet);
+
+	/* stop and reset the on-board processor */
+	iwl_write32(bus(trans), CSR_RESET, CSR_RESET_REG_FLAG_NEVO_RESET);
 }
 
 static int iwl_trans_pcie_tx(struct iwl_trans *trans, struct sk_buff *skb,

drivers/net/wireless/libertas/cfg.c

@@ -634,7 +634,7 @@ static int lbs_ret_scan(struct lbs_private *priv, unsigned long dummy,
 			if (channel &&
 			    !(channel->flags & IEEE80211_CHAN_DISABLED))
 				cfg80211_inform_bss(wiphy, channel,
-					bssid, le64_to_cpu(*(__le64 *)tsfdesc),
+					bssid, get_unaligned_le64(tsfdesc),
 					capa, intvl, ie, ielen,
 					LBS_SCAN_RSSI_TO_MBM(rssi),
 					GFP_KERNEL);

drivers/net/wireless/mwifiex/scan.c

@@ -819,8 +819,10 @@ mwifiex_scan_setup_scan_config(struct mwifiex_private *priv,
 			wildcard_ssid_tlv->header.len = cpu_to_le16(
 				(u16) (ssid_len + sizeof(wildcard_ssid_tlv->
 							 max_ssid_length)));
-			wildcard_ssid_tlv->max_ssid_length =
-				user_scan_in->ssid_list[ssid_idx].max_len;
+
+			/* max_ssid_length = 0 tells firmware to perform
+			   specific scan for the SSID filled */
+			wildcard_ssid_tlv->max_ssid_length = 0;
 
 			memcpy(wildcard_ssid_tlv->ssid,
 			       user_scan_in->ssid_list[ssid_idx].ssid,

net/mac80211/mlme.c

@@ -2288,6 +2288,7 @@ void ieee80211_sta_quiesce(struct ieee80211_sub_if_data *sdata)
 
 	cancel_work_sync(&ifmgd->request_smps_work);
 
+	cancel_work_sync(&ifmgd->monitor_work);
 	cancel_work_sync(&ifmgd->beacon_connection_loss_work);
 	if (del_timer_sync(&ifmgd->timer))
 		set_bit(TMR_RUNNING_TIMER, &ifmgd->timers_running);
@@ -2296,7 +2297,6 @@ void ieee80211_sta_quiesce(struct ieee80211_sub_if_data *sdata)
 	if (del_timer_sync(&ifmgd->chswitch_timer))
 		set_bit(TMR_RUNNING_CHANSW, &ifmgd->timers_running);
 
-	cancel_work_sync(&ifmgd->monitor_work);
 	/* these will just be re-established on connection */
 	del_timer_sync(&ifmgd->conn_mon_timer);
 	del_timer_sync(&ifmgd->bcn_mon_timer);

net/mac80211/rx.c

@@ -141,8 +141,9 @@ ieee80211_add_rx_radiotap_header(struct ieee80211_local *local,
 	pos++;
 
 	/* IEEE80211_RADIOTAP_RATE */
-	if (status->flag & RX_FLAG_HT) {
+	if (!rate || status->flag & RX_FLAG_HT) {
 		/*
+		 * Without rate information don't add it. If we have,
 		 * MCS information is a separate field in radiotap,
 		 * added below. The byte here is needed as padding
 		 * for the channel though, so initialise it to 0.
@@ -163,12 +164,14 @@ ieee80211_add_rx_radiotap_header(struct ieee80211_local *local,
 	else if (status->flag & RX_FLAG_HT)
 		put_unaligned_le16(IEEE80211_CHAN_DYN | IEEE80211_CHAN_2GHZ,
 				   pos);
-	else if (rate->flags & IEEE80211_RATE_ERP_G)
+	else if (rate && rate->flags & IEEE80211_RATE_ERP_G)
 		put_unaligned_le16(IEEE80211_CHAN_OFDM | IEEE80211_CHAN_2GHZ,
 				   pos);
-	else
+	else if (rate)
 		put_unaligned_le16(IEEE80211_CHAN_CCK | IEEE80211_CHAN_2GHZ,
 				   pos);
+	else
+		put_unaligned_le16(IEEE80211_CHAN_2GHZ, pos);
 	pos += 2;
 
 	/* IEEE80211_RADIOTAP_DBM_ANTSIGNAL */

net/mac80211/util.c

@@ -881,6 +881,8 @@ struct sk_buff *ieee80211_build_probe_req(struct ieee80211_sub_if_data *sdata,
 	skb = ieee80211_probereq_get(&local->hw, &sdata->vif,
 				     ssid, ssid_len,
 				     buf, buf_len);
+	if (!skb)
+		goto out;
 
 	if (dst) {
 		mgmt = (struct ieee80211_mgmt *) skb->data;
@@ -889,6 +891,8 @@ struct sk_buff *ieee80211_build_probe_req(struct ieee80211_sub_if_data *sdata,
 	}
 
 	IEEE80211_SKB_CB(skb)->flags |= IEEE80211_TX_INTFL_DONT_ENCRYPT;
+
+ out:
 	kfree(buf);
 
 	return skb;

net/wireless/reg.c

@@ -2265,6 +2265,9 @@ void /* __init_or_exit */ regulatory_exit(void)
 
 	kfree(last_request);
 
+	last_request = NULL;
+	dev_set_uevent_suppress(&reg_pdev->dev, true);
+
 	platform_device_unregister(reg_pdev);
 
 	spin_lock_bh(&reg_pending_beacons_lock);