Driver for IXP4xx built-in Ethernet ports

Adds a driver for built-in IXP4xx Ethernet ports.

Signed-off-by: Krzysztof Hałasa <khc@pm.waw.pl>
Signed-off-by: Jeff Garzik <jgarzik@redhat.com>

arch/arm/mach-ixp4xx/ixp4xx_npe.c

@@ -448,7 +448,9 @@ int npe_send_message(struct npe *npe, const void *msg, const char *what)
 		return -ETIMEDOUT;
 	}
 
+#if DEBUG_MSG > 1
 	debug_msg(npe, "Sending a message took %i cycles\n", cycles);
+#endif
 	return 0;
 }
 
@@ -484,7 +486,9 @@ int npe_recv_message(struct npe *npe, void *msg, const char *what)
 		return -ETIMEDOUT;
 	}
 
+#if DEBUG_MSG > 1
 	debug_msg(npe, "Receiving a message took %i cycles\n", cycles);
+#endif
 	return 0;
 }
 

arch/arm/mach-ixp4xx/ixp4xx_qmgr.c

@@ -184,6 +184,8 @@ void qmgr_release_queue(unsigned int queue)
 	case 3: mask[0] = 0xFF; break;
 	}
 
+	mask[1] = mask[2] = mask[3] = 0;
+
 	while (addr--)
 		shift_mask(mask);
 

drivers/net/arm/Kconfig

@@ -47,3 +47,11 @@ config EP93XX_ETH
 	help
 	  This is a driver for the ethernet hardware included in EP93xx CPUs.
 	  Say Y if you are building a kernel for EP93xx based devices.
+
+config IXP4XX_ETH
+	tristate "Intel IXP4xx Ethernet support"
+	depends on ARM && ARCH_IXP4XX && IXP4XX_NPE && IXP4XX_QMGR
+	select MII
+	help
+	  Say Y here if you want to use built-in Ethernet ports
+	  on IXP4xx processor.

drivers/net/arm/Makefile

@@ -9,3 +9,4 @@ obj-$(CONFIG_ARM_ETHER3)	+= ether3.o
 obj-$(CONFIG_ARM_ETHER1)	+= ether1.o
 obj-$(CONFIG_ARM_AT91_ETHER)	+= at91_ether.o
 obj-$(CONFIG_EP93XX_ETH)	+= ep93xx_eth.o
+obj-$(CONFIG_IXP4XX_ETH)	+= ixp4xx_eth.o