pinctrl: nuvoton: Add driver for WPCM450

This driver is based on the one for NPCM7xx, because the WPCM450 is a
predecessor of those SoCs. Notable differences:

- On WPCM450, the GPIO registers are not organized in multiple banks,
  but rather placed continually into the same register block. This
  affects how register offsets are computed.
- Pinmux nodes can explicitly select GPIO mode, whereas in the npcm7xx
  driver, this happens automatically when a GPIO is requested.

Some functionality implemented in the hardware was (for now) left unused
in the driver, specifically blinking and pull-up/down.

Signed-off-by: Jonathan Neuschäfer <j.neuschaefer@gmx.net>
Reported-by: kernel test robot <lkp@intel.com>
Link: https://lore.kernel.org/r/20220129115228.2257310-6-j.neuschaefer@gmx.net
Signed-off-by: Linus Walleij <linus.walleij@linaro.org>

MAINTAINERS

@@ -2376,6 +2376,7 @@ S:	Maintained
 F:	Documentation/devicetree/bindings/*/*wpcm*
 F:	arch/arm/boot/dts/nuvoton-wpcm450*
 F:	arch/arm/mach-npcm/wpcm450.c
+F:	drivers/*/*/*wpcm*
 F:	drivers/*/*wpcm*
 
 ARM/NXP S32G ARCHITECTURE

drivers/pinctrl/Makefile

@@ -62,7 +62,7 @@ obj-y				+= mediatek/
 obj-$(CONFIG_PINCTRL_MESON)	+= meson/
 obj-y				+= mvebu/
 obj-y				+= nomadik/
-obj-$(CONFIG_ARCH_NPCM7XX)	+= nuvoton/
+obj-y				+= nuvoton/
 obj-$(CONFIG_PINCTRL_PXA)	+= pxa/
 obj-$(CONFIG_ARCH_QCOM)		+= qcom/
 obj-$(CONFIG_PINCTRL_RALINK)	+= ralink/

drivers/pinctrl/nuvoton/Kconfig

@@ -1,4 +1,22 @@
 # SPDX-License-Identifier: GPL-2.0-only
+
+config PINCTRL_WPCM450
+	tristate "Pinctrl and GPIO driver for Nuvoton WPCM450"
+	depends on ARCH_WPCM450 || COMPILE_TEST
+	select PINMUX
+	select PINCONF
+	select GENERIC_PINCONF
+	select GPIOLIB
+	select GPIO_GENERIC
+	select GPIOLIB_IRQCHIP
+	help
+	  Say Y or M here to enable pin controller and GPIO support for
+	  the Nuvoton WPCM450 SoC. This is strongly recommended when
+	  building a kernel that will run on this chip.
+
+	  If this driver is compiled as a module, it will be named
+	  pinctrl-wpcm450.
+
 config PINCTRL_NPCM7XX
 	bool "Pinctrl and GPIO driver for Nuvoton NPCM7XX"
 	depends on (ARCH_NPCM7XX || COMPILE_TEST) && OF

drivers/pinctrl/nuvoton/Makefile

@@ -1,4 +1,5 @@
 # SPDX-License-Identifier: GPL-2.0
 # Nuvoton pinctrl support
 
+obj-$(CONFIG_PINCTRL_WPCM450)	+= pinctrl-wpcm450.o
 obj-$(CONFIG_PINCTRL_NPCM7XX)	+= pinctrl-npcm7xx.o