pinctrl: cherryview: fix issues caused by dynamic gpio irqs mapping
New GPIO IRQs are allocated and mapped dynamically by default when GPIO IRQ infrastructure is used by cherryview-pinctrl driver. This causes issues on some Intel platforms [1][2] with broken BIOS which hardcodes Linux IRQ numbers in their ACPI tables. On such platforms cherryview-pinctrl driver should allocate and map all GPIO IRQs at probe time. Side effect - "Cannot allocate irq_descs @ IRQ%d, assuming pre-allocated\n" can be seen at boot log. NOTE. It still may fail if boot sequence will changed and some interrupt controller will be probed before cherryview-pinctrl which will shift Linux IRQ numbering (expected with CONFIG_SPARCE_IRQ enabled). [1] https://bugzilla.kernel.org/show_bug.cgi?id=194945 [2] https://lkml.org/lkml/2017/9/28/153 Cc: Andy Shevchenko <andy.shevchenko@gmail.com> Cc: Chris Gorman <chrisjohgorman@gmail.com> Cc: Mika Westerberg <mika.westerberg@linux.intel.com> Cc: Heikki Krogerus <heikki.krogerus@linux.intel.com> Signed-off-by: Grygorii Strashko <grygorii.strashko@ti.com> Reported-by: Chris Gorman <chrisjohgorman@gmail.com> Reported-by: Mika Westerberg <mika.westerberg@linux.intel.com> Tested-by: Chris Gorman <chrisjohgorman@gmail.com> Acked-by: Mika Westerberg <mika.westerberg@linux.intel.com> Signed-off-by: Linus Walleij <linus.walleij@linaro.org>
This commit is contained in:
parent
83b31c2a5f
commit
845e405e5e
|
@ -1577,6 +1577,7 @@ static int chv_gpio_probe(struct chv_pinctrl *pctrl, int irq)
|
|||
struct gpio_chip *chip = &pctrl->chip;
|
||||
bool need_valid_mask = !dmi_check_system(chv_no_valid_mask);
|
||||
int ret, i, offset;
|
||||
int irq_base;
|
||||
|
||||
*chip = chv_gpio_chip;
|
||||
|
||||
|
@ -1622,7 +1623,18 @@ static int chv_gpio_probe(struct chv_pinctrl *pctrl, int irq)
|
|||
/* Clear all interrupts */
|
||||
chv_writel(0xffff, pctrl->regs + CHV_INTSTAT);
|
||||
|
||||
ret = gpiochip_irqchip_add(chip, &chv_gpio_irqchip, 0,
|
||||
if (!need_valid_mask) {
|
||||
irq_base = devm_irq_alloc_descs(pctrl->dev, -1, 0,
|
||||
chip->ngpio, NUMA_NO_NODE);
|
||||
if (irq_base < 0) {
|
||||
dev_err(pctrl->dev, "Failed to allocate IRQ numbers\n");
|
||||
return irq_base;
|
||||
}
|
||||
} else {
|
||||
irq_base = 0;
|
||||
}
|
||||
|
||||
ret = gpiochip_irqchip_add(chip, &chv_gpio_irqchip, irq_base,
|
||||
handle_bad_irq, IRQ_TYPE_NONE);
|
||||
if (ret) {
|
||||
dev_err(pctrl->dev, "failed to add IRQ chip\n");
|
||||
|
|
Loading…
Reference in New Issue