diff --git a/Documentation/devicetree/bindings/net/smsc-lan91c111.txt b/Documentation/devicetree/bindings/net/smsc-lan91c111.txt index 0f8487b88822..e77e167593db 100644 --- a/Documentation/devicetree/bindings/net/smsc-lan91c111.txt +++ b/Documentation/devicetree/bindings/net/smsc-lan91c111.txt @@ -11,3 +11,5 @@ Optional properties: are supported on the device. Valid value for SMSC LAN91c111 are 1, 2 or 4. If it's omitted or invalid, the size would be 2 meaning 16-bit access only. +- power-gpios: GPIO to control the PWRDWN pin +- reset-gpios: GPIO to control the RESET pin diff --git a/arch/arm/boot/dts/omap3-n900.dts b/arch/arm/boot/dts/omap3-n900.dts index 9b0494a8ab45..286bbf620c77 100644 --- a/arch/arm/boot/dts/omap3-n900.dts +++ b/arch/arm/boot/dts/omap3-n900.dts @@ -665,6 +665,8 @@ bank-width = <2>; pinctrl-names = "default"; pinctrl-0 = <ðernet_pins>; + power-gpios = <&gpio3 22 GPIO_ACTIVE_HIGH>; /* gpio86 */ + reset-gpios = <&gpio6 4 GPIO_ACTIVE_HIGH>; /* gpio164 */ gpmc,device-width = <2>; gpmc,sync-clk-ps = <0>; gpmc,cs-on-ns = <0>; diff --git a/arch/arm/mach-omap2/pdata-quirks.c b/arch/arm/mach-omap2/pdata-quirks.c index c95346c94829..cec9d6c6442c 100644 --- a/arch/arm/mach-omap2/pdata-quirks.c +++ b/arch/arm/mach-omap2/pdata-quirks.c @@ -252,9 +252,6 @@ static void __init nokia_n900_legacy_init(void) platform_device_register(&omap3_rom_rng_device); } - - /* Only on some development boards */ - gpio_request_one(164, GPIOF_OUT_INIT_LOW, "smc91x reset"); } static void __init omap3_tao3530_legacy_init(void) diff --git a/drivers/net/ethernet/smsc/smc91x.c b/drivers/net/ethernet/smsc/smc91x.c index 5e94d00b96b3..2c62208077fe 100644 --- a/drivers/net/ethernet/smsc/smc91x.c +++ b/drivers/net/ethernet/smsc/smc91x.c @@ -81,6 +81,7 @@ static const char version[] = #include #include #include +#include #include #include @@ -2188,6 +2189,41 @@ static const struct of_device_id smc91x_match[] = { {}, }; MODULE_DEVICE_TABLE(of, smc91x_match); + +/** + * of_try_set_control_gpio - configure a gpio if it exists + */ +static int try_toggle_control_gpio(struct device *dev, + struct gpio_desc **desc, + const char *name, int index, + int value, unsigned int nsdelay) +{ + struct gpio_desc *gpio = *desc; + int res; + + gpio = devm_gpiod_get_index(dev, name, index); + if (IS_ERR(gpio)) { + if (PTR_ERR(gpio) == -ENOENT) { + *desc = NULL; + return 0; + } + + return PTR_ERR(gpio); + } + res = gpiod_direction_output(gpio, !value); + if (res) { + dev_err(dev, "unable to toggle gpio %s: %i\n", name, res); + devm_gpiod_put(dev, gpio); + gpio = NULL; + return res; + } + if (nsdelay) + usleep_range(nsdelay, 2 * nsdelay); + gpiod_set_value_cansleep(gpio, value); + *desc = gpio; + + return 0; +} #endif /* @@ -2237,6 +2273,28 @@ static int smc_drv_probe(struct platform_device *pdev) struct device_node *np = pdev->dev.of_node; u32 val; + /* Optional pwrdwn GPIO configured? */ + ret = try_toggle_control_gpio(&pdev->dev, &lp->power_gpio, + "power", 0, 0, 100); + if (ret) + return ret; + + /* + * Optional reset GPIO configured? Minimum 100 ns reset needed + * according to LAN91C96 datasheet page 14. + */ + ret = try_toggle_control_gpio(&pdev->dev, &lp->reset_gpio, + "reset", 0, 0, 100); + if (ret) + return ret; + + /* + * Need to wait for optional EEPROM to load, max 750 us according + * to LAN91C96 datasheet page 55. + */ + if (lp->reset_gpio) + usleep_range(750, 1000); + /* Combination of IO widths supported, default to 16-bit */ if (!of_property_read_u32(np, "reg-io-width", &val)) { if (val & 1) diff --git a/drivers/net/ethernet/smsc/smc91x.h b/drivers/net/ethernet/smsc/smc91x.h index 47dce918eb0f..2a38dacbbd27 100644 --- a/drivers/net/ethernet/smsc/smc91x.h +++ b/drivers/net/ethernet/smsc/smc91x.h @@ -298,6 +298,9 @@ struct smc_local { struct sk_buff *pending_tx_skb; struct tasklet_struct tx_task; + struct gpio_desc *power_gpio; + struct gpio_desc *reset_gpio; + /* version/revision of the SMC91x chip */ int version;