drm/i915: Convert intel_dsi to use atomic state
Signed-off-by: Maarten Lankhorst <maarten.lankhorst@linux.intel.com> Link: http://patchwork.freedesktop.org/patch/msgid/1470755054-32699-11-git-send-email-maarten.lankhorst@linux.intel.com [mlankhorst: Unbreak bxt_dsi_get_pipe_config] Reviewed-by: Daniel Vetter <daniel.vetter@ffwll.ch>
This commit is contained in:
parent
ae9a911bb0
commit
5eff0edf32
|
@ -534,16 +534,15 @@ static void intel_dsi_enable(struct intel_encoder *encoder)
|
|||
intel_panel_enable_backlight(intel_dsi->attached_connector);
|
||||
}
|
||||
|
||||
static void intel_dsi_prepare(struct intel_encoder *intel_encoder);
|
||||
static void intel_dsi_prepare(struct intel_encoder *intel_encoder,
|
||||
struct intel_crtc_state *pipe_config);
|
||||
|
||||
static void intel_dsi_pre_enable(struct intel_encoder *encoder,
|
||||
struct intel_crtc_state *pipe_config,
|
||||
struct drm_connector_state *conn_state)
|
||||
{
|
||||
struct drm_device *dev = encoder->base.dev;
|
||||
struct drm_i915_private *dev_priv = to_i915(dev);
|
||||
struct drm_i915_private *dev_priv = to_i915(encoder->base.dev);
|
||||
struct intel_dsi *intel_dsi = enc_to_intel_dsi(&encoder->base);
|
||||
struct intel_crtc *crtc = to_intel_crtc(encoder->base.crtc);
|
||||
enum port port;
|
||||
|
||||
DRM_DEBUG_KMS("\n");
|
||||
|
@ -553,9 +552,9 @@ static void intel_dsi_pre_enable(struct intel_encoder *encoder,
|
|||
* lock. It needs to be fully powered down to fix it.
|
||||
*/
|
||||
intel_disable_dsi_pll(encoder);
|
||||
intel_enable_dsi_pll(encoder, crtc->config);
|
||||
intel_enable_dsi_pll(encoder, pipe_config);
|
||||
|
||||
intel_dsi_prepare(encoder);
|
||||
intel_dsi_prepare(encoder, pipe_config);
|
||||
|
||||
/* Panel Enable over CRC PMIC */
|
||||
if (intel_dsi->gpio_panel)
|
||||
|
@ -828,6 +827,7 @@ static void bxt_dsi_get_pipe_config(struct intel_encoder *encoder,
|
|||
u16 crtc_htotal_sw, crtc_hsync_start_sw, crtc_hsync_end_sw,
|
||||
crtc_hblank_start_sw, crtc_hblank_end_sw;
|
||||
|
||||
/* FIXME: hw readout should not depend on SW state */
|
||||
intel_crtc = to_intel_crtc(encoder->base.crtc);
|
||||
adjusted_mode_sw = &intel_crtc->config->base.adjusted_mode;
|
||||
|
||||
|
@ -1113,14 +1113,15 @@ static u32 pixel_format_to_reg(enum mipi_dsi_pixel_format fmt)
|
|||
}
|
||||
}
|
||||
|
||||
static void intel_dsi_prepare(struct intel_encoder *intel_encoder)
|
||||
static void intel_dsi_prepare(struct intel_encoder *intel_encoder,
|
||||
struct intel_crtc_state *pipe_config)
|
||||
{
|
||||
struct drm_encoder *encoder = &intel_encoder->base;
|
||||
struct drm_device *dev = encoder->dev;
|
||||
struct drm_i915_private *dev_priv = to_i915(dev);
|
||||
struct intel_crtc *intel_crtc = to_intel_crtc(encoder->crtc);
|
||||
struct intel_crtc *intel_crtc = to_intel_crtc(pipe_config->base.crtc);
|
||||
struct intel_dsi *intel_dsi = enc_to_intel_dsi(encoder);
|
||||
const struct drm_display_mode *adjusted_mode = &intel_crtc->config->base.adjusted_mode;
|
||||
const struct drm_display_mode *adjusted_mode = &pipe_config->base.adjusted_mode;
|
||||
enum port port;
|
||||
unsigned int bpp = mipi_dsi_pixel_format_to_bpp(intel_dsi->pixel_format);
|
||||
u32 val, tmp;
|
||||
|
@ -1357,7 +1358,7 @@ static int intel_dsi_set_property(struct drm_connector *connector,
|
|||
intel_connector->panel.fitting_mode = val;
|
||||
}
|
||||
|
||||
crtc = intel_attached_encoder(connector)->base.crtc;
|
||||
crtc = connector->state->crtc;
|
||||
if (crtc && crtc->state->enable) {
|
||||
/*
|
||||
* If the CRTC is enabled, the display will be changed
|
||||
|
|
Loading…
Reference in New Issue