hollalinux
/
linux-sg2042
mirror of https://github.com/sophgo/linux-riscv.git
1
0
Fork 0
Code Issues Packages Projects Releases Wiki Activity
linux-sg2042/drivers/soc/Makefile

17 lines
465 B
Makefile
Raw Normal View History

soc: qcom: Add GSBI driver The GSBI (General Serial Bus Interface) driver controls the overarching configuration of the shared serial bus infrastructure on APQ8064, IPQ8064, and earlier QCOM processors. The GSBI supports UART, I2C, SPI, and UIM functionality in various combinations. Signed-off-by: Andy Gross <agross@codeaurora.org> Signed-off-by: Kumar Gala <galak@codeaurora.org>
2014-04-25 00:31:21 +08:00
#
# Makefile for the Linux Kernel SOC specific device drivers.
#
ARM: bcm2835: add rpi power domain driver This patch adds support for several power domains on Raspberry Pi, including USB (so it can be enabled even if the bootloader didn't do it), and graphics. This patch is the combined work of Eric Anholt (who wrote USB support inside of the Raspberry Pi firmware driver, and wrote the non-USB domain support) and Alexander Aring (who separated the original USB work out from the firmware driver). Signed-off-by: Alexander Aring <alex.aring@gmail.com> Signed-off-by: Eric Anholt <eric@anholt.net> Reviewed-by: Ulf Hansson <ulf.hansson@linaro.org> Reviewed-by: Kevin Hilman <khilman@linaro.org>
2015-12-17 08:26:47 +08:00
obj-y += bcm/
soc: add stubs for brcmstb SoC's Used on BCM7xxx Set-Top Box chips (e.g., BCM7445). Signed-off-by: Brian Norris <computersforpeace@gmail.com> Signed-off-by: Florian Fainelli <f.fainelli@gmail.com>
2015-06-19 08:11:32 +08:00
obj-$(CONFIG_SOC_BRCMSTB) += brcmstb/
soc: dove: add legacy support to PMU driver Add support for legacy non-DT Dove to the PMU driver, so that we can transition the legacy support over. [gregory.clement@free-electrons.com: removed pm_genpd_poweroff_unused] Acked-by: Arnd Bergmann <arnd@arndb.de> Signed-off-by: Russell King <rmk+kernel@arm.linux.org.uk> Signed-off-by: Gregory CLEMENT <gregory.clement@free-electrons.com>
2015-12-08 18:43:28 +08:00
obj-$(CONFIG_ARCH_DOVE) += dove/
ARM: dove: create a proper PMU driver for power domains, PMU IRQs and resets The PMU device contains an interrupt controller, power control and resets. The interrupt controller is a little sub-standard in that there is no race free way to clear down pending interrupts, so we try to avoid problems by reducing the window as much as possible, and clearing as infrequently as possible. The interrupt support is implemented using an IRQ domain, and the parent interrupt referenced in the standard DT way. The power domains and reset support is closely related - there is a defined sequence for powering down a domain which is tightly coupled with asserting the reset. Hence, it makes sense to group these two together, and in order to avoid any locking contention disrupting this sequence, we avoid the use of syscon or regmap. This patch adds the core PMU driver: power domains must be defined in the DT file in order to make use of them. The reset controller can be referenced in the standard way for reset controllers. Signed-off-by: Russell King <rmk+kernel@arm.linux.org.uk> Signed-off-by: Andrew Lunn <andrew@lunn.ch> Signed-off-by: Gregory CLEMENT <gregory.clement@free-electrons.com>
2015-07-16 02:59:36 +08:00
obj-$(CONFIG_MACH_DOVE) += dove/
QE: Move QE from arch/powerpc to drivers/soc ls1 has qe and ls1 has arm cpu. move qe from arch/powerpc to drivers/soc/fsl to adapt to powerpc and arm Signed-off-by: Zhao Qiang <qiang.zhao@freescale.com> Signed-off-by: Scott Wood <scottwood@freescale.com>
2015-11-30 10:48:57 +08:00
obj-y += fsl/
soc: mediatek: Add PMIC wrapper for MT8135 and MT8173 SoCs This adds support for the PMIC wrapper found on MediaTek MT8135 and MT8173 SoCs. The PMIC wrapper is found on MT6xxx SoCs aswell but these are currently not supported. On MediaTek MT8135, MT8173 and other SoCs the PMIC is connected via SPI. The SPI master interface is not directly visible to the CPU, but only through the PMIC wrapper inside the SoC. The communication between the SoC and the PMIC can optionally be encrypted. Also a non standard Dual IO SPI mode can be used to increase speed. The MT8135 also supports a special feature named "IP Pairing". With IP Pairing the pins of some SoC internal peripherals can be on the PMIC. The signals of these pins are routed over the SPI bus using the pwrap bridge. Because of these optional non SPI conform features the PMIC driver is not implemented as a SPI bus master driver. Signed-off-by: Flora Fu, MediaTek Signed-off-by: Sascha Hauer <s.hauer@pengutronix.de> Signed-off-by: Matthias Brugger <matthias.bgg@gmail.com>
2015-03-17 18:14:34 +08:00
obj-$(CONFIG_ARCH_MEDIATEK) += mediatek/
soc: qcom: Add GSBI driver The GSBI (General Serial Bus Interface) driver controls the overarching configuration of the shared serial bus infrastructure on APQ8064, IPQ8064, and earlier QCOM processors. The GSBI supports UART, I2C, SPI, and UIM functionality in various combinations. Signed-off-by: Andy Gross <agross@codeaurora.org> Signed-off-by: Kumar Gala <galak@codeaurora.org>
2014-04-25 00:31:21 +08:00
obj-$(CONFIG_ARCH_QCOM) += qcom/
soc: rockchip: power-domain: Add power domain driver This driver is found on RK3288 SoCs. In order to meet high performance and low power requirements, a power management unit is designed or saving power when RK3288 in low power mode. The RK3288 PMU is dedicated for managing the power of the whole chip. PMU can work in the Low Power Mode by setting bit[0] of PMU_PWRMODE_CON register. After setting the register, PMU would enter the Low Power mode. In the low power mode, pmu will auto power on/off the specified power domain, send idle req to specified power domain, shut down/up pll and so on. All of above are configurable by setting corresponding registers. Signed-off-by: Caesar Wang <wxt@rock-chips.com> Reviewed-by: Kevin Hilman <khilman@linaro.org> [replace dsb() with dsb(sy) for arm64 buildability; sy is the default, so no functional change; adapt to per-user clocks in genpd] Signed-off-by: Heiko Stuebner <heiko@sntech.de>
2015-09-08 14:18:22 +08:00
obj-$(CONFIG_ARCH_ROCKCHIP) += rockchip/
drivers: soc: sunxi: Introduce SoC driver to map SRAMs The Allwinner SoCs have a handful of SRAM that can be either mapped to be accessible by devices or the CPU. That mapping is controlled by an SRAM controller, and that mapping might not be set by the bootloader, for example if the device wasn't used at all, or if we're using solutions like the U-Boot's Falcon Boot. We could also imagine changing this at runtime for example to change the mapping of these SRAMs to use them for suspend/resume or runtime memory rate change, if that ever happens. These use cases require some API in the kernel to control that mapping, exported through a drivers/soc driver. This driver also implement a debugfs file that shows the SRAM found in the system, the current mapping and the SRAM that have been claimed by some drivers in the kernel. Signed-off-by: Maxime Ripard <maxime.ripard@free-electrons.com> Acked-by: Arnd Bergmann <arnd@arndb.de> Acked-by: Hans de Goede <hdegoede@redhat.com> Tested-by: Hans de Goede <hdegoede@redhat.com> Signed-off-by: Arnd Bergmann <arnd@arndb.de>
2015-06-01 17:04:26 +08:00
obj-$(CONFIG_ARCH_SUNXI) += sunxi/
soc/tegra: Add efuse driver for Tegra Implement fuse driver for Tegra20, Tegra30, Tegra114 and Tegra124. This replaces functionality previously provided in arch/arm/mach-tegra, which is removed in this patch. While at it, move the only user of the global tegra_revision variable over to tegra_sku_info.revision and export tegra_fuse_readl() to allow drivers to read calibration fuses. Signed-off-by: Peter De Schrijver <pdeschrijver@nvidia.com> Signed-off-by: Stephen Warren <swarren@nvidia.com> Signed-off-by: Thierry Reding <treding@nvidia.com>
2014-06-12 23:36:37 +08:00
obj-$(CONFIG_ARCH_TEGRA) += tegra/
soc: ti: add Keystone Navigator QMSS driver The QMSS (Queue Manager Sub System) found on Keystone SOCs is one of the main hardware sub system which forms the backbone of the Keystone Multi-core Navigator. QMSS consist of queue managers, packed-data structure processors(PDSP), linking RAM, descriptor pools and infrastructure Packet DMA. The Queue Manager is a hardware module that is responsible for accelerating management of the packet queues. Packets are queued/de-queued by writing or reading descriptor address to a particular memory mapped location. The PDSPs perform QMSS related functions like accumulation, QoS, or event management. Linking RAM registers are used to link the descriptors which are stored in descriptor RAM. Descriptor RAM is configurable as internal or external memory. The QMSS driver manages the PDSP setups, linking RAM regions, queue pool management (allocation, push, pop and notify) and descriptor pool management. The specifics on the device tree bindings for QMSS can be found in: Documentation/devicetree/bindings/soc/keystone-navigator-qmss.txt Cc: Greg Kroah-Hartman <gregkh@linuxfoundation.org> Cc: Kumar Gala <galak@codeaurora.org> Cc: Olof Johansson <olof@lixom.net> Cc: Arnd Bergmann <arnd@arndb.de> Cc: Grant Likely <grant.likely@linaro.org> Cc: Rob Herring <robh+dt@kernel.org> Cc: Mark Rutland <mark.rutland@arm.com> Signed-off-by: Sandeep Nair <sandeep_n@ti.com> Signed-off-by: Santosh Shilimkar <santosh.shilimkar@ti.com>
2014-02-28 23:47:50 +08:00
obj-$(CONFIG_SOC_TI) += ti/
soc: add driver for the ARM RealView This adds a SoC driver to be used by the ARM RealView reference boards. We create the "versatile" directory to hold the different ARM reference designs as per the pattern of the clk directory layout. The driver utilze the syscon to get to the register needed. After this we can use sysfs to get at some SoC properties on RealView DT variants like this: > cd /sysbus/soc/devices/soc0 > ls board family machine power subsystem build fpga manufacturer soc_id uevent > cat family Versatile > cat fpga Multi-layer AXI > cat board HBI-0147 > cat build 03 Signed-off-by: Linus Walleij <linus.walleij@linaro.org> Signed-off-by: Arnd Bergmann <arnd@arndb.de> Conflicts: drivers/soc/Kconfig drivers/soc/Makefile
2014-07-25 21:04:52 +08:00
obj-$(CONFIG_PLAT_VERSATILE) += versatile/