42 lines
1.2 KiB
Plaintext
42 lines
1.2 KiB
Plaintext
|
Atmel NAND flash
|
||
|
|
||
|
Required properties:
|
||
|
- compatible : "atmel,at91rm9200-nand".
|
||
|
- reg : should specify localbus address and size used for the chip,
|
||
|
and if availlable the ECC.
|
||
|
- atmel,nand-addr-offset : offset for the address latch.
|
||
|
- atmel,nand-cmd-offset : offset for the command latch.
|
||
|
- #address-cells, #size-cells : Must be present if the device has sub-nodes
|
||
|
representing partitions.
|
||
|
|
||
|
- gpios : specifies the gpio pins to control the NAND device. detect is an
|
||
|
optional gpio and may be set to 0 if not present.
|
||
|
|
||
|
Optional properties:
|
||
|
- nand-ecc-mode : String, operation mode of the NAND ecc mode, soft by default.
|
||
|
Supported values are: "none", "soft", "hw", "hw_syndrome", "hw_oob_first",
|
||
|
"soft_bch".
|
||
|
- nand-bus-width : 8 or 16 bus width if not present 8
|
||
|
- nand-on-flash-bbt: boolean to enable on flash bbt option if not present false
|
||
|
|
||
|
Examples:
|
||
|
nand0: nand@40000000,0 {
|
||
|
compatible = "atmel,at91rm9200-nand";
|
||
|
#address-cells = <1>;
|
||
|
#size-cells = <1>;
|
||
|
reg = <0x40000000 0x10000000
|
||
|
0xffffe800 0x200
|
||
|
>;
|
||
|
atmel,nand-addr-offset = <21>;
|
||
|
atmel,nand-cmd-offset = <22>;
|
||
|
nand-on-flash-bbt;
|
||
|
nand-ecc-mode = "soft";
|
||
|
gpios = <&pioC 13 0
|
||
|
&pioC 14 0
|
||
|
0
|
||
|
>;
|
||
|
partition@0 {
|
||
|
...
|
||
|
};
|
||
|
};
|