43 lines
1.5 KiB
Plaintext
43 lines
1.5 KiB
Plaintext
Lantiq SoC Serial To Parallel (STP) GPIO controller
|
|
|
|
The Serial To Parallel (STP) is found on MIPS based Lantiq socs. It is a
|
|
peripheral controller used to drive external shift register cascades. At most
|
|
3 groups of 8 bits can be driven. The hardware is able to allow the DSL modem
|
|
to drive the 2 LSBs of the cascade automatically.
|
|
|
|
|
|
Required properties:
|
|
- compatible : Should be "lantiq,gpio-stp-xway"
|
|
- reg : Address and length of the register set for the device
|
|
- #gpio-cells : Should be two. The first cell is the pin number and
|
|
the second cell is used to specify optional parameters (currently
|
|
unused).
|
|
- gpio-controller : Marks the device node as a gpio controller.
|
|
|
|
Optional properties:
|
|
- lantiq,shadow : The default value that we shall assume as already set on the
|
|
shift register cascade.
|
|
- lantiq,groups : Set the 3 bit mask to select which of the 3 groups are enabled
|
|
in the shift register cascade.
|
|
- lantiq,dsl : The dsl core can control the 2 LSBs of the gpio cascade. This 2 bit
|
|
property can enable this feature.
|
|
- lantiq,phy1 : The gphy1 core can control 3 bits of the gpio cascade.
|
|
- lantiq,phy2 : The gphy2 core can control 3 bits of the gpio cascade.
|
|
- lantiq,rising : use rising instead of falling edge for the shift register
|
|
|
|
Example:
|
|
|
|
gpio1: stp@e100bb0 {
|
|
compatible = "lantiq,gpio-stp-xway";
|
|
reg = <0xE100BB0 0x40>;
|
|
#gpio-cells = <2>;
|
|
gpio-controller;
|
|
|
|
lantiq,shadow = <0xffff>;
|
|
lantiq,groups = <0x7>;
|
|
lantiq,dsl = <0x3>;
|
|
lantiq,phy1 = <0x7>;
|
|
lantiq,phy2 = <0x7>;
|
|
/* lantiq,rising; */
|
|
};
|