UbiquitousOS
/
OpenCloudOS-Kernel
mirror of https://gitee.com/OpenCloudOS/OpenCloudOS-Kernel.git
11
0
Fork 0
Code Issues Projects Releases Wiki Activity
OpenCloudOS-Kernel/drivers/scsi/sata_uli.c

289 lines
7.7 KiB
C
Raw Blame History

/*
* sata_uli.c - ULi Electronics SATA
*
* The contents of this file are subject to the Open
* Software License version 1.1 that can be found at
* http://www.opensource.org/licenses/osl-1.1.txt and is included herein
* by reference.
*
* Alternatively, the contents of this file may be used under the terms
* of the GNU General Public License version 2 (the "GPL") as distributed
* in the kernel source COPYING file, in which case the provisions of
* the GPL are applicable instead of the above. If you wish to allow
* the use of your version of this file only under the terms of the
* GPL and not to allow others to use your version of this file under
* the OSL, indicate your decision by deleting the provisions above and
* replace them with the notice and other provisions required by the GPL.
* If you do not delete the provisions above, a recipient may use your
* version of this file under either the OSL or the GPL.
*
*/
#include <linux/config.h>
#include <linux/kernel.h>
#include <linux/module.h>
#include <linux/pci.h>
#include <linux/init.h>
#include <linux/blkdev.h>
#include <linux/delay.h>
#include <linux/interrupt.h>
#include "scsi.h"
#include <scsi/scsi_host.h>
#include <linux/libata.h>
#define DRV_NAME "sata_uli"
#define DRV_VERSION "0.5"
enum {
uli_5289 = 0,
uli_5287 = 1,
uli_5281 = 2,
/* PCI configuration registers */
ULI5287_BASE = 0x90, /* sata0 phy SCR registers */
ULI5287_OFFS = 0x10, /* offset from sata0->sata1 phy regs */
ULI5281_BASE = 0x60, /* sata0 phy SCR registers */
ULI5281_OFFS = 0x60, /* offset from sata0->sata1 phy regs */
};
static int uli_init_one (struct pci_dev *pdev, const struct pci_device_id *ent);
static u32 uli_scr_read (struct ata_port *ap, unsigned int sc_reg);
static void uli_scr_write (struct ata_port *ap, unsigned int sc_reg, u32 val);
static struct pci_device_id uli_pci_tbl[] = {
{ PCI_VENDOR_ID_AL, 0x5289, PCI_ANY_ID, PCI_ANY_ID, 0, 0, uli_5289 },
{ PCI_VENDOR_ID_AL, 0x5287, PCI_ANY_ID, PCI_ANY_ID, 0, 0, uli_5287 },
{ PCI_VENDOR_ID_AL, 0x5281, PCI_ANY_ID, PCI_ANY_ID, 0, 0, uli_5281 },
{ } /* terminate list */
};
static struct pci_driver uli_pci_driver = {
.name = DRV_NAME,
.id_table = uli_pci_tbl,
.probe = uli_init_one,
.remove = ata_pci_remove_one,
};
static Scsi_Host_Template uli_sht = {
.module = THIS_MODULE,
.name = DRV_NAME,
.ioctl = ata_scsi_ioctl,
.queuecommand = ata_scsi_queuecmd,
.eh_strategy_handler = ata_scsi_error,
.can_queue = ATA_DEF_QUEUE,
.this_id = ATA_SHT_THIS_ID,
.sg_tablesize = LIBATA_MAX_PRD,
.max_sectors = ATA_MAX_SECTORS,
.cmd_per_lun = ATA_SHT_CMD_PER_LUN,
.emulated = ATA_SHT_EMULATED,
.use_clustering = ATA_SHT_USE_CLUSTERING,
.proc_name = DRV_NAME,
.dma_boundary = ATA_DMA_BOUNDARY,
.slave_configure = ata_scsi_slave_config,
.bios_param = ata_std_bios_param,
.ordered_flush = 1,
};
static struct ata_port_operations uli_ops = {
.port_disable = ata_port_disable,
.tf_load = ata_tf_load,
.tf_read = ata_tf_read,
.check_status = ata_check_status,
.exec_command = ata_exec_command,
.dev_select = ata_std_dev_select,
.phy_reset = sata_phy_reset,
.bmdma_setup = ata_bmdma_setup,
.bmdma_start = ata_bmdma_start,
.bmdma_stop = ata_bmdma_stop,
.bmdma_status = ata_bmdma_status,
.qc_prep = ata_qc_prep,
.qc_issue = ata_qc_issue_prot,
.eng_timeout = ata_eng_timeout,
.irq_handler = ata_interrupt,
.irq_clear = ata_bmdma_irq_clear,
.scr_read = uli_scr_read,
.scr_write = uli_scr_write,
.port_start = ata_port_start,
.port_stop = ata_port_stop,
.host_stop = ata_host_stop,
};
static struct ata_port_info uli_port_info = {
.sht = &uli_sht,
.host_flags = ATA_FLAG_SATA | ATA_FLAG_SATA_RESET |
ATA_FLAG_NO_LEGACY,
.pio_mask = 0x03, //support pio mode 4 (FIXME)
.udma_mask = 0x7f, //support udma mode 6
.port_ops = &uli_ops,
};
MODULE_AUTHOR("Peer Chen");
MODULE_DESCRIPTION("low-level driver for ULi Electronics SATA controller");
MODULE_LICENSE("GPL");
MODULE_DEVICE_TABLE(pci, uli_pci_tbl);
MODULE_VERSION(DRV_VERSION);
static unsigned int get_scr_cfg_addr(struct ata_port *ap, unsigned int sc_reg)
{
return ap->ioaddr.scr_addr + (4 * sc_reg);
}
static u32 uli_scr_cfg_read (struct ata_port *ap, unsigned int sc_reg)
{
struct pci_dev *pdev = to_pci_dev(ap->host_set->dev);
unsigned int cfg_addr = get_scr_cfg_addr(ap, sc_reg);
u32 val;
pci_read_config_dword(pdev, cfg_addr, &val);
return val;
}
static void uli_scr_cfg_write (struct ata_port *ap, unsigned int scr, u32 val)
{
struct pci_dev *pdev = to_pci_dev(ap->host_set->dev);
unsigned int cfg_addr = get_scr_cfg_addr(ap, scr);
pci_write_config_dword(pdev, cfg_addr, val);
}
static u32 uli_scr_read (struct ata_port *ap, unsigned int sc_reg)
{
if (sc_reg > SCR_CONTROL)
return 0xffffffffU;
return uli_scr_cfg_read(ap, sc_reg);
}
static void uli_scr_write (struct ata_port *ap, unsigned int sc_reg, u32 val)
{
if (sc_reg > SCR_CONTROL) //SCR_CONTROL=2, SCR_ERROR=1, SCR_STATUS=0
return;
uli_scr_cfg_write(ap, sc_reg, val);
}
/* move to PCI layer, integrate w/ MSI stuff */
static void pci_enable_intx(struct pci_dev *pdev)
{
u16 pci_command;
pci_read_config_word(pdev, PCI_COMMAND, &pci_command);
if (pci_command & PCI_COMMAND_INTX_DISABLE) {
pci_command &= ~PCI_COMMAND_INTX_DISABLE;
pci_write_config_word(pdev, PCI_COMMAND, pci_command);
}
}
static int uli_init_one (struct pci_dev *pdev, const struct pci_device_id *ent)
{
struct ata_probe_ent *probe_ent;
struct ata_port_info *ppi;
int rc;
unsigned int board_idx = (unsigned int) ent->driver_data;
int pci_dev_busy = 0;
rc = pci_enable_device(pdev);
if (rc)
return rc;
rc = pci_request_regions(pdev, DRV_NAME);
if (rc) {
pci_dev_busy = 1;
goto err_out;
}
rc = pci_set_dma_mask(pdev, ATA_DMA_MASK);
if (rc)
goto err_out_regions;
rc = pci_set_consistent_dma_mask(pdev, ATA_DMA_MASK);
if (rc)
goto err_out_regions;
ppi = &uli_port_info;
probe_ent = ata_pci_init_native_mode(pdev, &ppi);
if (!probe_ent) {
rc = -ENOMEM;
goto err_out_regions;
}
switch (board_idx) {
case uli_5287:
probe_ent->port[0].scr_addr = ULI5287_BASE;
probe_ent->port[1].scr_addr = ULI5287_BASE + ULI5287_OFFS;
probe_ent->n_ports = 4;
probe_ent->port[2].cmd_addr = pci_resource_start(pdev, 0) + 8;
probe_ent->port[2].altstatus_addr =
probe_ent->port[2].ctl_addr =
(pci_resource_start(pdev, 1) | ATA_PCI_CTL_OFS) + 4;
probe_ent->port[2].bmdma_addr = pci_resource_start(pdev, 4) + 16;
probe_ent->port[2].scr_addr = ULI5287_BASE + ULI5287_OFFS*4;
probe_ent->port[3].cmd_addr = pci_resource_start(pdev, 2) + 8;
probe_ent->port[3].altstatus_addr =
probe_ent->port[3].ctl_addr =
(pci_resource_start(pdev, 3) | ATA_PCI_CTL_OFS) + 4;
probe_ent->port[3].bmdma_addr = pci_resource_start(pdev, 4) + 24;
probe_ent->port[3].scr_addr = ULI5287_BASE + ULI5287_OFFS*5;
ata_std_ports(&probe_ent->port[2]);
ata_std_ports(&probe_ent->port[3]);
break;
case uli_5289:
probe_ent->port[0].scr_addr = ULI5287_BASE;
probe_ent->port[1].scr_addr = ULI5287_BASE + ULI5287_OFFS;
break;
case uli_5281:
probe_ent->port[0].scr_addr = ULI5281_BASE;
probe_ent->port[1].scr_addr = ULI5281_BASE + ULI5281_OFFS;
break;
default:
BUG();
break;
}
pci_set_master(pdev);
pci_enable_intx(pdev);
/* FIXME: check ata_device_add return value */
ata_device_add(probe_ent);
kfree(probe_ent);
return 0;
err_out_regions:
pci_release_regions(pdev);
err_out:
if (!pci_dev_busy)
pci_disable_device(pdev);
return rc;
}
static int __init uli_init(void)
{
return pci_module_init(&uli_pci_driver);
}
static void __exit uli_exit(void)
{
pci_unregister_driver(&uli_pci_driver);
}
module_init(uli_init);
module_exit(uli_exit);
Reference in New Issue View Git Blame Copy Permalink