255 lines
6.1 KiB
C
255 lines
6.1 KiB
C
/* SPDX-License-Identifier: GPL-2.0 */
|
|
#ifndef DW_SPI_HEADER_H
|
|
#define DW_SPI_HEADER_H
|
|
|
|
#include <linux/io.h>
|
|
#include <linux/scatterlist.h>
|
|
#include <linux/gpio.h>
|
|
|
|
/* Register offsets */
|
|
#define DW_SPI_CTRL0 0x00
|
|
#define DW_SPI_CTRL1 0x04
|
|
#define DW_SPI_SSIENR 0x08
|
|
#define DW_SPI_MWCR 0x0c
|
|
#define DW_SPI_SER 0x10
|
|
#define DW_SPI_BAUDR 0x14
|
|
#define DW_SPI_TXFLTR 0x18
|
|
#define DW_SPI_RXFLTR 0x1c
|
|
#define DW_SPI_TXFLR 0x20
|
|
#define DW_SPI_RXFLR 0x24
|
|
#define DW_SPI_SR 0x28
|
|
#define DW_SPI_IMR 0x2c
|
|
#define DW_SPI_ISR 0x30
|
|
#define DW_SPI_RISR 0x34
|
|
#define DW_SPI_TXOICR 0x38
|
|
#define DW_SPI_RXOICR 0x3c
|
|
#define DW_SPI_RXUICR 0x40
|
|
#define DW_SPI_MSTICR 0x44
|
|
#define DW_SPI_ICR 0x48
|
|
#define DW_SPI_DMACR 0x4c
|
|
#define DW_SPI_DMATDLR 0x50
|
|
#define DW_SPI_DMARDLR 0x54
|
|
#define DW_SPI_IDR 0x58
|
|
#define DW_SPI_VERSION 0x5c
|
|
#define DW_SPI_DR 0x60
|
|
|
|
/* Bit fields in CTRLR0 */
|
|
#define SPI_DFS_OFFSET 0
|
|
|
|
#define SPI_FRF_OFFSET 4
|
|
#define SPI_FRF_SPI 0x0
|
|
#define SPI_FRF_SSP 0x1
|
|
#define SPI_FRF_MICROWIRE 0x2
|
|
#define SPI_FRF_RESV 0x3
|
|
|
|
#define SPI_MODE_OFFSET 6
|
|
#define SPI_SCPH_OFFSET 6
|
|
#define SPI_SCOL_OFFSET 7
|
|
|
|
#define SPI_TMOD_OFFSET 8
|
|
#define SPI_TMOD_MASK (0x3 << SPI_TMOD_OFFSET)
|
|
#define SPI_TMOD_TR 0x0 /* xmit & recv */
|
|
#define SPI_TMOD_TO 0x1 /* xmit only */
|
|
#define SPI_TMOD_RO 0x2 /* recv only */
|
|
#define SPI_TMOD_EPROMREAD 0x3 /* eeprom read mode */
|
|
|
|
#define SPI_SLVOE_OFFSET 10
|
|
#define SPI_SRL_OFFSET 11
|
|
#define SPI_CFS_OFFSET 12
|
|
|
|
/* Bit fields in SR, 7 bits */
|
|
#define SR_MASK 0x7f /* cover 7 bits */
|
|
#define SR_BUSY (1 << 0)
|
|
#define SR_TF_NOT_FULL (1 << 1)
|
|
#define SR_TF_EMPT (1 << 2)
|
|
#define SR_RF_NOT_EMPT (1 << 3)
|
|
#define SR_RF_FULL (1 << 4)
|
|
#define SR_TX_ERR (1 << 5)
|
|
#define SR_DCOL (1 << 6)
|
|
|
|
/* Bit fields in ISR, IMR, RISR, 7 bits */
|
|
#define SPI_INT_TXEI (1 << 0)
|
|
#define SPI_INT_TXOI (1 << 1)
|
|
#define SPI_INT_RXUI (1 << 2)
|
|
#define SPI_INT_RXOI (1 << 3)
|
|
#define SPI_INT_RXFI (1 << 4)
|
|
#define SPI_INT_MSTI (1 << 5)
|
|
|
|
/* Bit fields in DMACR */
|
|
#define SPI_DMA_RDMAE (1 << 0)
|
|
#define SPI_DMA_TDMAE (1 << 1)
|
|
|
|
/* TX RX interrupt level threshold, max can be 256 */
|
|
#define SPI_INT_THRESHOLD 32
|
|
|
|
enum dw_ssi_type {
|
|
SSI_MOTO_SPI = 0,
|
|
SSI_TI_SSP,
|
|
SSI_NS_MICROWIRE,
|
|
};
|
|
|
|
struct dw_spi;
|
|
struct dw_spi_dma_ops {
|
|
int (*dma_init)(struct dw_spi *dws);
|
|
void (*dma_exit)(struct dw_spi *dws);
|
|
int (*dma_setup)(struct dw_spi *dws, struct spi_transfer *xfer);
|
|
bool (*can_dma)(struct spi_controller *master, struct spi_device *spi,
|
|
struct spi_transfer *xfer);
|
|
int (*dma_transfer)(struct dw_spi *dws, struct spi_transfer *xfer);
|
|
void (*dma_stop)(struct dw_spi *dws);
|
|
};
|
|
|
|
struct dw_spi {
|
|
struct spi_controller *master;
|
|
enum dw_ssi_type type;
|
|
|
|
void __iomem *regs;
|
|
unsigned long paddr;
|
|
int irq;
|
|
u32 fifo_len; /* depth of the FIFO buffer */
|
|
u32 max_freq; /* max bus freq supported */
|
|
|
|
u32 reg_io_width; /* DR I/O width in bytes */
|
|
u16 bus_num;
|
|
u16 num_cs; /* supported slave numbers */
|
|
|
|
/* Current message transfer state info */
|
|
size_t len;
|
|
void *tx;
|
|
void *tx_end;
|
|
void *rx;
|
|
void *rx_end;
|
|
int dma_mapped;
|
|
u8 n_bytes; /* current is a 1/2 bytes op */
|
|
u32 dma_width;
|
|
irqreturn_t (*transfer_handler)(struct dw_spi *dws);
|
|
u32 current_freq; /* frequency in hz */
|
|
|
|
/* DMA info */
|
|
int dma_inited;
|
|
struct dma_chan *txchan;
|
|
struct dma_chan *rxchan;
|
|
unsigned long dma_chan_busy;
|
|
dma_addr_t dma_addr; /* phy address of the Data register */
|
|
const struct dw_spi_dma_ops *dma_ops;
|
|
void *dma_tx;
|
|
void *dma_rx;
|
|
|
|
/* Bus interface info */
|
|
void *priv;
|
|
#ifdef CONFIG_DEBUG_FS
|
|
struct dentry *debugfs;
|
|
#endif
|
|
};
|
|
|
|
static inline u32 dw_readl(struct dw_spi *dws, u32 offset)
|
|
{
|
|
return __raw_readl(dws->regs + offset);
|
|
}
|
|
|
|
static inline u16 dw_readw(struct dw_spi *dws, u32 offset)
|
|
{
|
|
return __raw_readw(dws->regs + offset);
|
|
}
|
|
|
|
static inline void dw_writel(struct dw_spi *dws, u32 offset, u32 val)
|
|
{
|
|
__raw_writel(val, dws->regs + offset);
|
|
}
|
|
|
|
static inline void dw_writew(struct dw_spi *dws, u32 offset, u16 val)
|
|
{
|
|
__raw_writew(val, dws->regs + offset);
|
|
}
|
|
|
|
static inline u32 dw_read_io_reg(struct dw_spi *dws, u32 offset)
|
|
{
|
|
switch (dws->reg_io_width) {
|
|
case 2:
|
|
return dw_readw(dws, offset);
|
|
case 4:
|
|
default:
|
|
return dw_readl(dws, offset);
|
|
}
|
|
}
|
|
|
|
static inline void dw_write_io_reg(struct dw_spi *dws, u32 offset, u32 val)
|
|
{
|
|
switch (dws->reg_io_width) {
|
|
case 2:
|
|
dw_writew(dws, offset, val);
|
|
break;
|
|
case 4:
|
|
default:
|
|
dw_writel(dws, offset, val);
|
|
break;
|
|
}
|
|
}
|
|
|
|
static inline void spi_enable_chip(struct dw_spi *dws, int enable)
|
|
{
|
|
dw_writel(dws, DW_SPI_SSIENR, (enable ? 1 : 0));
|
|
}
|
|
|
|
static inline void spi_set_clk(struct dw_spi *dws, u16 div)
|
|
{
|
|
dw_writel(dws, DW_SPI_BAUDR, div);
|
|
}
|
|
|
|
/* Disable IRQ bits */
|
|
static inline void spi_mask_intr(struct dw_spi *dws, u32 mask)
|
|
{
|
|
u32 new_mask;
|
|
|
|
new_mask = dw_readl(dws, DW_SPI_IMR) & ~mask;
|
|
dw_writel(dws, DW_SPI_IMR, new_mask);
|
|
}
|
|
|
|
/* Enable IRQ bits */
|
|
static inline void spi_umask_intr(struct dw_spi *dws, u32 mask)
|
|
{
|
|
u32 new_mask;
|
|
|
|
new_mask = dw_readl(dws, DW_SPI_IMR) | mask;
|
|
dw_writel(dws, DW_SPI_IMR, new_mask);
|
|
}
|
|
|
|
/*
|
|
* This does disable the SPI controller, interrupts, and re-enable the
|
|
* controller back. Transmit and receive FIFO buffers are cleared when the
|
|
* device is disabled.
|
|
*/
|
|
static inline void spi_reset_chip(struct dw_spi *dws)
|
|
{
|
|
spi_enable_chip(dws, 0);
|
|
spi_mask_intr(dws, 0xff);
|
|
spi_enable_chip(dws, 1);
|
|
}
|
|
|
|
static inline void spi_shutdown_chip(struct dw_spi *dws)
|
|
{
|
|
spi_enable_chip(dws, 0);
|
|
spi_set_clk(dws, 0);
|
|
}
|
|
|
|
/*
|
|
* Each SPI slave device to work with dw_api controller should
|
|
* has such a structure claiming its working mode (poll or PIO/DMA),
|
|
* which can be save in the "controller_data" member of the
|
|
* struct spi_device.
|
|
*/
|
|
struct dw_spi_chip {
|
|
u8 poll_mode; /* 1 for controller polling mode */
|
|
u8 type; /* SPI/SSP/MicroWire */
|
|
void (*cs_control)(u32 command);
|
|
};
|
|
|
|
extern int dw_spi_add_host(struct device *dev, struct dw_spi *dws);
|
|
extern void dw_spi_remove_host(struct dw_spi *dws);
|
|
extern int dw_spi_suspend_host(struct dw_spi *dws);
|
|
extern int dw_spi_resume_host(struct dw_spi *dws);
|
|
|
|
/* platform related setup */
|
|
extern int dw_spi_mid_init(struct dw_spi *dws); /* Intel MID platforms */
|
|
#endif /* DW_SPI_HEADER_H */
|