The endianness flag is used on the CODEC side to specify an
ambivalence to endian, typically because it is lost over the hardware
link. This device receives audio over a SLIMbus DAI and as such should
have endianness applied.
Signed-off-by: Charles Keepax <ckeepax@opensource.cirrus.com>
Link: https://lore.kernel.org/r/20220504170905.332415-29-ckeepax@opensource.cirrus.com
Signed-off-by: Mark Brown <broonie@kernel.org>
Currently, rx_port_value is a single unsigned int that gets overwritten
when slim_rx_mux_put() is called for any RX mux, then the same value is
read when slim_rx_mux_get() is called for any of them. This results in
slim_rx_mux_get() reporting the last value set by slim_rx_mux_put()
regardless of which SLIM RX mux is in question.
Turn rx_port_value into an array and store a separate value for each
SLIM RX mux.
Signed-off-by: Yassine Oudjana <y.oudjana@protonmail.com>
Link: https://lore.kernel.org/r/20220104033356.343685-1-y.oudjana@protonmail.com
Signed-off-by: Mark Brown <broonie@kernel.org>
The versioning scheme was changed in an earlier patch, which caused the version
being used to initialize WCD9335 to be interpreted as if it was WCD937X, which
changed code paths causing broken headphones output. Pass WCD9335 instead of
WCD9335_VERSION_2_0 to wcd_clsh_ctrl_alloc to fix it.
Fixes: 19c5d1f6a0 ("ASoC: codecs: wcd-clsh: add new version support")
Signed-off-by: Yassine Oudjana <y.oudjana@protonmail.com>
Reviewed-by: Srinivas Kandagatla <srinivas.kandagatla@linaro.org>
Link: https://lore.kernel.org/r/20210925022339.786296-1-y.oudjana@protonmail.com
Signed-off-by: Mark Brown <broonie@kernel.org>
The probe calls 'wcd9335_setup_irqs()' to enable interrupts on all slave
ports.
This must be undone in the remove function.
Add a 'wcd9335_teardown_irqs()' function that undoes 'wcd9335_setup_irqs()'
function, and call it from the remove function.
Fixes: 20aedafdf4 ("ASoC: wcd9335: add support to wcd9335 codec")
Signed-off-by: Christophe JAILLET <christophe.jaillet@wanadoo.fr>
Message-Id: <8f761244d79bd4c098af8a482be9121d3a486d1b.1629091028.git.christophe.jaillet@wanadoo.fr>
Signed-off-by: Mark Brown <broonie@kernel.org>
If 'wcd9335_setup_irqs()' fails, me must release the memory allocated in
'wcd_clsh_ctrl_alloc()', as already done in the remove function.
Add an error handling path and the missing 'wcd_clsh_ctrl_free()' call.
Fixes: 20aedafdf4 ("ASoC: wcd9335: add support to wcd9335 codec")
Signed-off-by: Christophe JAILLET <christophe.jaillet@wanadoo.fr>
Message-Id: <6dc12372f09fabb70bf05941dbe6a1382dc93e43.1629091028.git.christophe.jaillet@wanadoo.fr>
Signed-off-by: Mark Brown <broonie@kernel.org>
There is no point in calling 'free_irq()' explicitly for
'WCD9335_IRQ_SLIMBUS' in the remove function.
The irqs are requested in 'wcd9335_setup_irqs()' using a resource managed
function (i.e. 'devm_request_threaded_irq()').
'wcd9335_setup_irqs()' requests all what is defined in the 'wcd9335_irqs'
structure.
This structure has only one entry for 'WCD9335_IRQ_SLIMBUS'.
So 'devm_request...irq()' + explicit 'free_irq()' would lead to a double
free.
Remove the unneeded 'free_irq()' from the remove function.
Fixes: 20aedafdf4 ("ASoC: wcd9335: add support to wcd9335 codec")
Signed-off-by: Christophe JAILLET <christophe.jaillet@wanadoo.fr>
Message-Id: <0614d63bc00edd7e81dd367504128f3d84f72efa.1629091028.git.christophe.jaillet@wanadoo.fr>
Signed-off-by: Mark Brown <broonie@kernel.org>
The snd_soc_dai_ops structures is only stored in the ops field of a
snd_soc_dai_driver structure, so make the snd_soc_dai_ops structure
const to allow the compiler to put it in read-only memory.
Reported-by: Hulk Robot <hulkci@huawei.com>
Signed-off-by: Ye Bin <yebin10@huawei.com>
Link: https://lore.kernel.org/r/20210408062644.802988-1-yebin10@huawei.com
Signed-off-by: Mark Brown <broonie@kernel.org>
The '>=' expression itself is bool, no need to convert it to bool.
Fix the following coccicheck warning:
./sound/soc/codecs/wcd9335.c:3982:25-30: WARNING: conversion to bool not needed here
Reported-by: Tosk Robot <tencent_os_robot@tencent.com>
Signed-off-by: Kaixu Xia <kaixuxia@tencent.com>
Link: https://lore.kernel.org/r/1604652816-1330-1-git-send-email-kaixuxia@tencent.com
Signed-off-by: Mark Brown <broonie@kernel.org>
digital gain range is -84dB min to 40dB max, however this was not
correctly specified in the range.
Fix this by with correct range!
Fixes: 8c4f021d80 ("ASoC: wcd9335: add basic controls")
Signed-off-by: Srinivas Kandagatla <srinivas.kandagatla@linaro.org>
Link: https://lore.kernel.org/r/20201028154340.17090-2-srinivas.kandagatla@linaro.org
Signed-off-by: Mark Brown <broonie@kernel.org>
We need to use snd_soc_component_read()
instead of snd_soc_component_read32()
This patch renames _read32() to _read()
Signed-off-by: Kuninori Morimoto <kuninori.morimoto.gx@renesas.com>
Reviewed-by: Srinivas Kandagatla <srinivas.kandagatla@linaro.org>
Link: https://lore.kernel.org/r/87lfkn4mdy.wl-kuninori.morimoto.gx@renesas.com
Signed-off-by: Mark Brown <broonie@kernel.org>
slimbus addresses are 16 bit wide, masking page numbers
to wcd register at offset of 12 will limit the number for pages.
So it becomes impossible to write to page 0x10 registers.
Remove masking 0x800 (slimbus address range) from register address
and making use of window parameters in regmap config should fix it
and also will represent the registers exactly inline with Datasheet.
Remove this unnessary masking and make the registers be inline
with datasheet.
Signed-off-by: Srinivas Kandagatla <srinivas.kandagatla@linaro.org>
Link: https://lore.kernel.org/r/20200306152633.25836-1-srinivas.kandagatla@linaro.org
Signed-off-by: Mark Brown <broonie@kernel.org>
All these functions declares and initializes variable ret with
'0' and without modifying 'ret' variable, it is returned.
This patch removes this redundancy and returns '0' directly.
Signed-off-by: Saiyam Doshi <saiyamdoshi.in@gmail.com>
Link: https://lore.kernel.org/r/20190909174541.GA22718@SD
Signed-off-by: Mark Brown <broonie@kernel.org>
On this codec SLIMBus RX path supports 384000 rate on primary interpolator.
Add this missing rate as supported rate.
Signed-off-by: Srinivas Kandagatla <srinivas.kandagatla@linaro.org>
Link: https://lore.kernel.org/r/20190822095653.7200-3-srinivas.kandagatla@linaro.org
Signed-off-by: Mark Brown <broonie@kernel.org>
Add IRQF_ONESHOT to ensure "Interrupt is not reenabled after the hardirq
handler finished".
fixes below issue reported by coccicheck
sound/soc/codecs/wcd9335.c:4068:8-33: ERROR: Threaded IRQ with no
primary handler requested without IRQF_ONESHOT
Signed-off-by: Hariprasad Kelam <hariprasad.kelam@gmail.com>
Link: https://lore.kernel.org/r/20190710021627.GA13396@hari-Inspiron-1545
Signed-off-by: Mark Brown <broonie@kernel.org>
In wcd9335_codec_enable_dec(), 'widget_name' is allocated by kstrndup().
However, according to doc: "Note: Use kmemdup_nul() instead if the size
is known exactly." So we should use kmemdup_nul() here instead of
kstrndup().
Signed-off-by: Gen Zhang <blackgod016574@gmail.com>
Signed-off-by: Mark Brown <broonie@kernel.org>
The call to of_parse_phandle returns a node pointer with refcount
incremented thus it must be explicitly decremented after the last
usage.
Detected by coccinelle with the following warnings:
./sound/soc/codecs/wcd9335.c:5193:2-8: ERROR: missing of_node_put; acquired a node pointer with refcount incremented on line 5183, but without a correspon ding object release within this function.
Signed-off-by: Wen Yang <wen.yang99@zte.com.cn>
Cc: Liam Girdwood <lgirdwood@gmail.com>
Cc: Mark Brown <broonie@kernel.org>
Cc: Jaroslav Kysela <perex@perex.cz>
Cc: Takashi Iwai <tiwai@suse.com>
Cc: Srinivas Kandagatla <srinivas.kandagatla@linaro.org>
Cc: Vinod Koul <vkoul@kernel.org>
Cc: Dan Carpenter <dan.carpenter@oracle.com> (commit_signer:1/11=9%,authored:1/11=9%)
Cc: alsa-devel@alsa-project.org
Cc: linux-kernel@vger.kernel.org
Signed-off-by: Mark Brown <broonie@kernel.org>
These are arrays, not pointers, and they can't be NULL.
Signed-off-by: Dan Carpenter <dan.carpenter@oracle.com>
Signed-off-by: Mark Brown <broonie@kernel.org>
This patch adds audio routing for both playback and capture.
Signed-off-by: Srinivas Kandagatla <srinivas.kandagatla@linaro.org>
Reviewed-by: Vinod Koul <vkoul@kernel.org>
Signed-off-by: Mark Brown <broonie@kernel.org>
This patch adds required dapm widgets for playback.
Signed-off-by: Srinivas Kandagatla <srinivas.kandagatla@linaro.org>
Reviewed-by: Vinod Koul <vkoul@kernel.org>
Signed-off-by: Mark Brown <broonie@kernel.org>
This patch adds basic controls found in wcd9335 codec.
Signed-off-by: Srinivas Kandagatla <srinivas.kandagatla@linaro.org>
Reviewed-by: Vinod Koul <vkoul@kernel.org>
Signed-off-by: Mark Brown <broonie@kernel.org>
CLASS-H controller/Amplifier is common accorss Qualcomm WCD codec series.
This patchset adds basic CLASS-H controller apis for WCD codecs after
wcd9335 to use.
Signed-off-by: Srinivas Kandagatla <srinivas.kandagatla@linaro.org>
Reviewed-by: Vinod Koul <vkoul@kernel.org>
Signed-off-by: Mark Brown <broonie@kernel.org>
Qualcomm WCD9335 Codec is a standalone Hi-Fi audio codec IC,
It supports both I2S/I2C and SLIMbus audio interfaces.
On slimbus interface it supports two data lanes; 16 Tx ports
and 8 Rx ports. It has Seven DACs and nine dedicated interpolators,
Seven (six audio ADCs, and one VBAT ADC), Multibutton headset
control (MBHC), Active noise cancellation and Sidetone paths
and processing.
This patchset adds very basic support for playback and capture
via the 9 interpolators and ADC respectively.
Signed-off-by: Srinivas Kandagatla <srinivas.kandagatla@linaro.org>
Reviewed-by: Vinod Koul <vkoul@kernel.org>
Signed-off-by: Mark Brown <broonie@kernel.org>
Charles Keepax