The format specifier "%p" can leak kernel addresses.
Use "%pK" instead.
This patch proposes changes for remoteproc core only.
Acked-by: Suman Anna <s-anna@ti.com>
Signed-off-by: Loic Pallardy <loic.pallardy@st.com>
Signed-off-by: Bjorn Andersson <bjorn.andersson@linaro.org>
This patch offers the capability to dump memory carveouts associated
to one remoteprocessor.
Signed-off-by: Loic Pallardy <loic.pallardy@st.com>
Signed-off-by: Bjorn Andersson <bjorn.andersson@linaro.org>
This patch adds the capability to display the content of
the resource table associated to a remote processor firmware.
Signed-off-by: Loic Pallardy <loic.pallardy@st.com>
Signed-off-by: Bjorn Andersson <bjorn.andersson@linaro.org>
Since there is now an always available state file in sysfs with the same
function as this one in debugfs, remove the redundant entry.
Signed-off-by: Matt Redfearn <matt.redfearn@imgtec.com>
Signed-off-by: Bjorn Andersson <bjorn.andersson@linaro.org>
This patch fixes the existing alignment checkpatch check
warnings of the type "Alignment should match open parenthesis"
in the remoteproc core source files.
Signed-off-by: Suman Anna <s-anna@ti.com>
Signed-off-by: Bjorn Andersson <bjorn.andersson@linaro.org>
This functionality is especially useful during the testing phase. When
used in conjunction with Mailbox's Test Framework we can trivially conduct
end-to-end testing i.e. boot co-processor, send and receive messages to
the co-processor, then shut it down again (repeat as required).
Signed-off-by: Ludovic Barre <ludovic.barre@st.com>
Signed-off-by: Lee Jones <lee.jones@linaro.org>
Signed-off-by: Bjorn Andersson <bjorn.andersson@linaro.org>
If 'count' value is invalid, return -EINVAL.
Signed-off-by: Lee Jones <lee.jones@linaro.org>
[bjorn: changed commit message]
Signed-off-by: Bjorn Andersson <bjorn.andersson@linaro.org>
Recent gcc versions warn about reading from a negative offset of
an on-stack array:
drivers/remoteproc/remoteproc_debugfs.c: In function 'rproc_recovery_write':
drivers/remoteproc/remoteproc_debugfs.c:167:9: warning: 'buf[4294967295u]' may be used uninitialized in this function [-Wmaybe-uninitialized]
I don't see anything in sys_write() that prevents us from
being called with a zero 'count' argument, so we should
add an extra check in rproc_recovery_write() to prevent the
access and avoid the warning.
Signed-off-by: Arnd Bergmann <arnd@arndb.de>
Fixes: 2e37abb89a ("remoteproc: create a 'recovery' debugfs entry")
Signed-off-by: Ohad Ben-Cohen <ohad@wizery.com>
This patch fixes relevant checkpatch errors and warnings
in the remoteproc source files.
Signed-off-by: Suman Anna <s-anna@ti.com>
[drop 80-char-lines checkpatch fixes and update commit log accordingly]
Signed-off-by: Ohad Ben-Cohen <ohad@wizery.com>
copy_from_user() returns the number of bytes remaining to be copied, but
we want to return an error code here.
Signed-off-by: Dan Carpenter <dan.carpenter@oracle.com>
Signed-off-by: Ohad Ben-Cohen <ohad@wizery.com>
snprintf() returns the number of characters which would have been
printed if there were enough space. For example, on the first print if
we fill up the 28 character string then it would return a number more
than 30. Use scnprintf() instead because that returns the actual number
of characters printed.
Signed-off-by: Dan Carpenter <dan.carpenter@oracle.com>
Signed-off-by: Ohad Ben-Cohen <ohad@wizery.com>
Add a 'recovery' debugfs entry to dynamically disable/enable recovery
at runtime. This is useful when one is trying to debug an rproc crash;
without it, a recovery will immediately take place, making it harder
to debug the crash.
Contributions from Subramaniam Chanderashekarapuram.
Examples:
- disabling recovery:
$ echo disabled > <debugfs>/remoteproc/remoteproc0/recovery
- in case you want to recover a crash, but keep recovery disabled
(useful in debugging sessions when you expect additional crashes
you want to debug):
$ echo recover > <debugfs>/remoteproc/remoteproc0/recovery
- enabling recovery:
$ echo enabled > <debugfs>/remoteproc/remoteproc0/recovery
Signed-off-by: Fernando Guzman Lugo <fernando.lugo@ti.com>
[ohad: some white space, commentary and commit log changes]
Signed-off-by: Ohad Ben-Cohen <ohad@wizery.com>
For each registered rproc, maintain a generic remoteproc device whose
parent is the low level platform-specific device (commonly a pdev, but
it may certainly be any other type of device too).
With this in hand, the resulting device hierarchy might then look like:
omap-rproc.0
|
- remoteproc0 <---- new !
|
- virtio0
|
- virtio1
|
- rpmsg0
|
- rpmsg1
|
- rpmsg2
Where:
- omap-rproc.0 is the low level device that's bound to the
driver which invokes rproc_register()
- remoteproc0 is the result of this patch, and will be added by the
remoteproc framework when rproc_register() is invoked
- virtio0 and virtio1 are vdevs that are registered by remoteproc
when it realizes that they are supported by the firmware
of the physical remote processor represented by omap-rproc.0
- rpmsg0, rpmsg1 and rpmsg2 are rpmsg devices that represent rpmsg
channels, and are registerd by the rpmsg bus when it gets notified
about their existence
Technically, this patch:
- changes 'struct rproc' to contain this generic remoteproc.x device
- creates a new "remoteproc" type, to which this new generic remoteproc.x
device belong to.
- adds a super simple enumeration method for the indices of the
remoteproc.x devices
- updates all dev_* messaging to use the generic remoteproc.x device
instead of the low level platform-specific device
- updates all dma_* allocations to use the parent of remoteproc.x (where
the platform-specific memory pools, most commonly CMA, are to be found)
Adding this generic device has several merits:
- we can now add remoteproc runtime PM support simply by hooking onto the
new "remoteproc" type
- all remoteproc log messages will now carry a common name prefix
instead of having a platform-specific one
- having a device as part of the rproc struct makes it possible to simplify
refcounting (see subsequent patch)
Thanks to Stephen Boyd <sboyd@codeaurora.org> for suggesting and
discussing these ideas in one of the remoteproc review threads and
to Fernando Guzman Lugo <fernando.lugo@ti.com> for trying them out
with the (upcoming) runtime PM support for remoteproc.
Cc: Fernando Guzman Lugo <fernando.lugo@ti.com>
Reviewed-by: Stephen Boyd <sboyd@codeaurora.org>
Signed-off-by: Ohad Ben-Cohen <ohad@wizery.com>
Many users of debugfs copy the implementation of default_open() when
they want to support a custom read/write function op. This leads to a
proliferation of the default_open() implementation across the entire
tree.
Now that the common implementation has been consolidated into libfs we
can replace all the users of this function with simple_open().
This replacement was done with the following semantic patch:
<smpl>
@ open @
identifier open_f != simple_open;
identifier i, f;
@@
-int open_f(struct inode *i, struct file *f)
-{
(
-if (i->i_private)
-f->private_data = i->i_private;
|
-f->private_data = i->i_private;
)
-return 0;
-}
@ has_open depends on open @
identifier fops;
identifier open.open_f;
@@
struct file_operations fops = {
...
-.open = open_f,
+.open = simple_open,
...
};
</smpl>
[akpm@linux-foundation.org: checkpatch fixes]
Signed-off-by: Stephen Boyd <sboyd@codeaurora.org>
Cc: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
Cc: Al Viro <viro@zeniv.linux.org.uk>
Cc: Julia Lawall <Julia.Lawall@lip6.fr>
Acked-by: Ingo Molnar <mingo@elte.hu>
Signed-off-by: Andrew Morton <akpm@linux-foundation.org>
Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>
Expose several remote processor properties (name, state, trace buffer)
that are helpful for debugging.
This part is extracted to a separate patch just to keep the review load
down.
Designed with Brian Swetland <swetland@google.com>.
Signed-off-by: Ohad Ben-Cohen <ohad@wizery.com>
Acked-by: Grant Likely <grant.likely@secretlab.ca>
Cc: Brian Swetland <swetland@google.com>
Cc: Arnd Bergmann <arnd@arndb.de>
Cc: Tony Lindgren <tony@atomide.com>
Cc: Russell King <linux@arm.linux.org.uk>
Cc: Rusty Russell <rusty@rustcorp.com.au>
Cc: Andrew Morton <akpm@linux-foundation.org>
Cc: Greg KH <greg@kroah.com>
Cc: Stephen Boyd <sboyd@codeaurora.org>
Loic Pallardy