In all 3 drivers there is a case where the driver knows the
bo is in SYSTEM so don't call the api that checks that.
Reviewed-by: Ben Skeggs <bskeggs@redhat.com>
Reviewed-by: Christian König <christian.koenig@amd.com>
Signed-off-by: Dave Airlie <airlied@redhat.com>
Link: https://patchwork.freedesktop.org/patch/msgid/20201019071314.1671485-4-airlied@gmail.com
This adds support for the TDO TL070WSH30 TFT-LCD panel module.
The panel has a 1024×600 resolution and uses 24 bit RGB per pixel.
It provides a MIPI DSI interface to the host, a built-in LED backlight
and touch controller.
Signed-off-by: Neil Armstrong <narmstrong@baylibre.com>
Reviewed-by: Sam Ravnborg <sam@ravnborg.org>
Link: https://patchwork.freedesktop.org/patch/msgid/20200915121912.4347-5-narmstrong@baylibre.com
Simple DSI panels can also have a reset GPIO signal in addition/instead of an
enable GPIO signal.
This adds an optional reset-gpios property.
Signed-off-by: Neil Armstrong <narmstrong@baylibre.com>
Reviewed-by: Sam Ravnborg <sam@ravnborg.org>
Acked-by: Rob Herring <robh@kernel.org>
Link: https://patchwork.freedesktop.org/patch/msgid/20200915121912.4347-3-narmstrong@baylibre.com
In function via_mem_alloc`s error branch, DRM_ERROR is protected
in the mutex_lock(&dev->struct_mutex) area.
>From the code, we see that DRM_ERROR is just an error log print
without any struct element, there is no need to protect this.
Signed-off-by: Bernard Zhao <bernard@vivo.com>
Signed-off-by: Sam Ravnborg <sam@ravnborg.org>
Link: https://patchwork.freedesktop.org/patch/msgid/20200814083021.8962-1-bernard@vivo.com
platform_get_irq() returns -ERRNO on error. In such case comparison
to 0 would pass the check.
Fixes: 179c02fe90 ("drm/tve200: Add new driver for TVE200")
Signed-off-by: Krzysztof Kozlowski <krzk@kernel.org>
Acked-by: Linus Walleij <linus.walleij@linaro.org>
Signed-off-by: Sam Ravnborg <sam@ravnborg.org>
Link: https://patchwork.freedesktop.org/patch/msgid/20200827071107.27429-2-krzk@kernel.org
platform_get_irq() returns -ERRNO on error. In such case comparison
to 0 would pass the check.
Fixes: 5fc537bfd0 ("drm/mcde: Add new driver for ST-Ericsson MCDE")
Signed-off-by: Krzysztof Kozlowski <krzk@kernel.org>
Acked-by: Linus Walleij <linus.walleij@linaro.org>
Signed-off-by: Sam Ravnborg <sam@ravnborg.org>
Link: https://patchwork.freedesktop.org/patch/msgid/20200827071107.27429-1-krzk@kernel.org
Eliminate the following coccicheck warning:
drivers/video/fbdev/fsl-diu-fb.c:1428:5-8: Unneeded variable: "res".
Return "0" on line 1450
Reported-by: Hulk Robot <hulkci@huawei.com>
Signed-off-by: Jason Yan <yanaijie@huawei.com>
Acked-by: Gustavo A. R. Silva <gustavoars@kernel.org>
Signed-off-by: Sam Ravnborg <sam@ravnborg.org>
Link: https://patchwork.freedesktop.org/patch/msgid/20200910140558.1191423-1-yanaijie@huawei.com
This eliminates the following sparse warning:
drivers/gpu/drm/panel/panel-sitronix-st7703.c:156:26: warning: symbol
'jh057n00900_panel_desc' was not declared. Should it be static?
Reported-by: Hulk Robot <hulkci@huawei.com>
Signed-off-by: Jason Yan <yanaijie@huawei.com>
Reviewed-by: Guido Günther <agx@sigxcpu.org>
[Use static const]
Signed-off-by: Sam Ravnborg <sam@ravnborg.org>
Link: https://patchwork.freedesktop.org/patch/msgid/20200912033809.142773-1-yanaijie@huawei.com
This eliminates the following sparse warning:
drivers/gpu/drm/bridge/adv7511/adv7511_audio.c:58:5: warning: symbol
'adv7511_hdmi_hw_params' was not declared. Should it be static?
Reported-by: Hulk Robot <hulkci@huawei.com>
Signed-off-by: Jason Yan <yanaijie@huawei.com>
Signed-off-by: Sam Ravnborg <sam@ravnborg.org>
Link: https://patchwork.freedesktop.org/patch/msgid/20200912033826.142923-1-yanaijie@huawei.com
This eliminates the following sparse warning:
drivers/gpu/drm/bridge/analogix/analogix_dp_reg.c:527:5: warning: symbol
'analogix_dp_start_aux_transaction' was not declared. Should it be
static?
Reported-by: Hulk Robot <hulkci@huawei.com>
Signed-off-by: Jason Yan <yanaijie@huawei.com>
Signed-off-by: Sam Ravnborg <sam@ravnborg.org>
Link: https://patchwork.freedesktop.org/patch/msgid/20200912033843.143240-1-yanaijie@huawei.com
Add the support for enabling optional regulator that may be used as VCC
source.
Signed-off-by: Biju Das <biju.das.jz@bp.renesas.com>
Reviewed-by: Laurent Pinchart <laurent.pinchart@ideasonboard.com>
[Replaced 'error' variable with 'ret']
[Renamed regulator from 'vcc' to 'power']
Signed-off-by: Laurent Pinchart <laurent.pinchart+renesas@ideasonboard.com>
Reviewed-by: Biju Das <biju.das.jz@bp.renesas.com>
Signed-off-by: Sam Ravnborg <sam@ravnborg.org>
Link: https://patchwork.freedesktop.org/patch/msgid/20200922105526.5252-1-laurent.pinchart+renesas@ideasonboard.com
Fixes gcc '-Wunused-but-set-variable' warning:
drivers/video/fbdev/sis/300vtbl.h:1064:28: warning:
‘SiS300_CHTVVCLKSONTSC’ defined but not used [-Wunused-const-variable=]
Reported-by: Hulk Robot <hulkci@huawei.com>
Signed-off-by: Li Heng <liheng40@huawei.com>
Signed-off-by: Sam Ravnborg <sam@ravnborg.org>
Link: https://patchwork.freedesktop.org/patch/msgid/1600957106-13741-1-git-send-email-liheng40@huawei.com
On some panels hooked up to the ti-sn65dsi86 bridge chip we found that
link training was failing. Specifically, we'd see:
ti_sn65dsi86 2-002d: [drm:ti_sn_bridge_enable] *ERROR* Link training failed, link is off (-5)
The panel was hooked up to a logic analyzer and it was found that, as
part of link training, the bridge chip was writing a 0x1 to DPCD
address 00600h and the panel responded NACK. As can be seen in header
files, the write of 0x1 to DPCD address 0x600h means we were trying to
write the value DP_SET_POWER_D0 to the register DP_SET_POWER. The
panel vendor says that a NACK in this case is not unexpected and means
"not ready, try again".
In testing, we found that this panel would respond with a NACK in
about 1/25 times. Adding the retry logic worked fine and the most
number of tries needed was 3. Just to be safe, we'll add 10 tries
here and we'll add a little blurb to the logs if we ever need more
than 5.
Signed-off-by: Douglas Anderson <dianders@chromium.org>
Tested-By: Steev Klimaszewski <steev@kali.org>
Signed-off-by: Sam Ravnborg <sam@ravnborg.org>
Link: https://patchwork.freedesktop.org/patch/msgid/20201002135920.1.I2adbc90b2db127763e2444bd5a4e5bf30e1db8e5@changeid
Because clk_prepare_enable() and clk_disable_unprepare() already checked
NULL clock parameter, so the additional checks are unnecessary, just
remove them.
Signed-off-by: Xu Wang <vulab@iscas.ac.cn>
Signed-off-by: Thomas Zimmermann <tzimmermann@suse.de>
Link: https://patchwork.freedesktop.org/patch/msgid/20201014085722.26069-1-vulab@iscas.ac.cn
Because clk_prepare_enable() and clk_disable_unprepare() already checked
NULL clock parameter, so the additional checks are unnecessary, just
remove them.
Signed-off-by: Xu Wang <vulab@iscas.ac.cn>
Signed-off-by: Thomas Zimmermann <tzimmermann@suse.de>
Link: https://patchwork.freedesktop.org/patch/msgid/20201014084920.25813-1-vulab@iscas.ac.cn
Inspired by a patch by Chris Wilson for vgem. Plus this gives us vmap
at the gem bo level, which we need for generic fbdev emulation.
Luckily shmem also tracks ->vaddr, so we just need to adjust the code
all over a bit to make this fit.
Also wire up handle_to_fd, dunno why that was missing.
v2:
- Drop now unused container_of #define (Melissa)
- Make sure we keep creating cached objects, this is for testing
(Thomas)
Signed-off-by: Daniel Vetter <daniel.vetter@intel.com>
Cc: Chris Wilson <chris@chris-wilson.co.uk>
Cc: Maarten Lankhorst <maarten.lankhorst@linux.intel.com>
Cc: Maxime Ripard <mripard@kernel.org>
Cc: Thomas Zimmermann <tzimmermann@suse.de>
Cc: David Airlie <airlied@linux.ie>
Cc: Daniel Vetter <daniel@ffwll.ch>
Cc: Rodrigo Siqueira <rodrigosiqueiramelo@gmail.com>
Cc: Melissa Wen <melissa.srw@gmail.com>
Cc: Haneen Mohammed <hamohammed.sa@gmail.com>
Acked-by: Thomas Zimmermann <tzimmermann@suse.de>
Reviewed-by: Melissa Wen <melissa.srw@gmail.com>
Link: https://patchwork.freedesktop.org/patch/msgid/20201013111027.375999-1-daniel.vetter@ffwll.ch
The only thing we support is xrgb8888.
Acked-by: Thomas Zimmermann <tzimmermann@suse.de>
Reviewed-by: Melissa Wen <melissa.srw@gmail.com>
Signed-off-by: Daniel Vetter <daniel.vetter@intel.com>
Cc: Rodrigo Siqueira <rodrigosiqueiramelo@gmail.com>
Cc: Melissa Wen <melissa.srw@gmail.com>
Cc: Haneen Mohammed <hamohammed.sa@gmail.com>
Cc: Daniel Vetter <daniel@ffwll.ch>
Link: https://patchwork.freedesktop.org/patch/msgid/20201009232156.3916879-1-daniel.vetter@ffwll.ch
The dma-buf API have been used under the assumption that the sg lists
returned from dma_buf_map_attachment() are fully page aligned. Lots of
stuff can break otherwise all over the place. Clarify this in the
documentation and add a check when DMA API debug is enabled.
Signed-off-by: Jianxin Xiong <jianxin.xiong@intel.com>
Reviewed-by: Christian König <christian.koenig@amd.com>
Signed-off-by: Daniel Vetter <daniel.vetter@ffwll.ch>
Link: https://patchwork.freedesktop.org/patch/msgid/1602692161-107096-1-git-send-email-jianxin.xiong@intel.com
Dave Airlie