Commit 6cfcd5563b ("clocksource/drivers/timer-ti-dm: Fix suspend and
resume for am3 and am4") exposed a new issue for type2 dual mode timers
on at least omap5 where the clockevent will stop when the SoC starts
entering idle states during the boot.
Turns out we are wrongly first enabling the system timer and then
resetting it, while we must also re-enable it after reset. The current
sequence leaves the timer module in a partially initialized state. This
issue went unnoticed earlier with ti-sysc driver reconfiguring the timer
module until we fixed the issue of ti-sysc reconfiguring system timers.
Let's fix the issue by calling dmtimer_systimer_enable() from reset for
both type1 and type2 timers, and switch the order of reset and enable in
dmtimer_systimer_setup(). Let's also move dmtimer_systimer_enable() and
dmtimer_systimer_disable() to do this without adding forward declarations.
Fixes: 6cfcd5563b ("clocksource/drivers/timer-ti-dm: Fix suspend and resume for am3 and am4")
Reported-by: H. Nikolaus Schaller" <hns@goldelico.com>
Signed-off-by: Tony Lindgren <tony@atomide.com>
Signed-off-by: Daniel Lezcano <daniel.lezcano@linaro.org>
Link: https://lore.kernel.org/r/20200817092428.6176-1-tony@atomide.com
Carlos Hernandez <ceh@ti.com> reported that we now have a suspend and
resume regresssion on am3 and am4 compared to the earlier kernels. While
suspend and resume works with v5.8-rc3, we now get errors with rtcwake:
pm33xx pm33xx: PM: Could not transition all powerdomains to target state
...
rtcwake: write error
This is because we now fail to idle the system timer clocks that the
idle code checks and the error gets propagated to the rtcwake.
Turns out there are several issues that need to be fixed:
1. Ignore no-idle and no-reset configured timers for the ti-sysc
interconnect target driver as otherwise it will keep the system timer
clocks enabled
2. Toggle the system timer functional clock for suspend for am3 and am4
(but not for clocksource on am3)
3. Only reconfigure type1 timers in dmtimer_systimer_disable()
4. Use of_machine_is_compatible() instead of of_device_is_compatible()
for checking the SoC type
Fixes: 52762fbd1c ("clocksource/drivers/timer-ti-dm: Add clockevent and clocksource support")
Reported-by: Carlos Hernandez <ceh@ti.com>
Signed-off-by: Tony Lindgren <tony@atomide.com>
Tested-by: Carlos Hernandez <ceh@ti.com>
Signed-off-by: Daniel Lezcano <daniel.lezcano@linaro.org>
Link: https://lore.kernel.org/r/20200713162601.6829-1-tony@atomide.com
We can get a warning for dmtimer_clocksource_init() with 'pa' set but
not used. This was used in the earlier revisions of the code but no
longer needed, so let's remove the unused pa and of_translate_address().
Let's also do it for dmtimer_clockevent_init() that has a similar issue.
Reported-by: kbuild test robot <lkp@intel.com>
Signed-off-by: Tony Lindgren <tony@atomide.com>
Signed-off-by: Daniel Lezcano <daniel.lezcano@linaro.org>
Link: https://lore.kernel.org/r/20200519155157.12804-1-tony@atomide.com
We can move the TI dmtimer clockevent and clocksource to live under
drivers/clocksource if we rely only on the clock framework, and handle
the module configuration directly in the clocksource driver based on the
device tree data.
This removes the early dependency with system timers to the interconnect
related code, and we can probe pretty much everything else later on at
the module_init level.
Let's first add a new driver for timer-ti-dm-systimer based on existing
arch/arm/mach-omap2/timer.c. Then let's start moving SoCs to probe with
device tree data while still keeping the old timer.c. And eventually we
can just drop the old timer.c.
Let's take the opportunity to switch to use readl/writel as pointed out
by Daniel Lezcano <daniel.lezcano@linaro.org>. This allows further
clean-up of the timer-ti-dm code the a lot of the shared helpers can
just become static to the non-syster related code.
Note the boards can optionally configure different timer source clocks
if needed with assigned-clocks and assigned-clock-parents.
Cc: linux-kernel@vger.kernel.org
Cc: linux-omap@vger.kernel.org
Cc: Daniel Lezcano <daniel.lezcano@linaro.org>
Cc: Grygorii Strashko <grygorii.strashko@ti.com>
Cc: Keerthy <j-keerthy@ti.com>
Cc: Lokesh Vutla <lokeshvutla@ti.com>
Cc: Rob Herring <robh@kernel.org>
Cc: Tero Kristo <t-kristo@ti.com>
Cc: Thomas Gleixner <tglx@linutronix.de>
Signed-off-by: Tony Lindgren <tony@atomide.com>
Signed-off-by: Daniel Lezcano <daniel.lezcano@linaro.org>
Link: https://lore.kernel.org/r/20200507172330.18679-3-tony@atomide.com
Tony Lindgren