Added trigger buffer support to read continuous acceleration
and temperature data from device with data ready interrupt which
is mapped to INT1 pin.
Signed-off-by: Jagath Jog J <jagathjog1996@gmail.com>
Reviewed-by: Andy Shevchenko <andy.shevchenko@gmail.com>
Link: https://lore.kernel.org/r/20220505133021.22362-5-jagathjog1996@gmail.com
Signed-off-by: Jonathan Cameron <Jonathan.Cameron@huawei.com>
This is a conversion to device-managed by using devm_iio_device_register()
inside probe function. Previously the bma400 was not put into power down
mode in some error paths in probe where it now is, but that should cause
no harm.
The dev_set_drvdata() call, bma400_remove() function and hooks in the I2C
and SPI driver struct is removed as devm_iio_device_register() function is
used to automatically unregister on driver detach.
Signed-off-by: Jagath Jog J <jagathjog1996@gmail.com>
Reviewed-by: Andy Shevchenko <andy.shevchenko@gmail.com>
Link: https://lore.kernel.org/r/20220505133021.22362-4-jagathjog1996@gmail.com
Signed-off-by: Jonathan Cameron <Jonathan.Cameron@huawei.com>
In order to avoid unnecessary pollution of the global symbol namespace
move the core bma400 functions into a bma400 specific namespace
and import that into the two bus modules.
Signed-off-by: Jonathan Cameron <Jonathan.Cameron@huawei.com>
Cc: Linus Walleij <linus.walleij@linaro.org>
Link: https://lore.kernel.org/r/20220116180535.2367780-5-jic23@kernel.org
When an i2c or spi driver's remove function returns a non-zero error
code nothing happens apart from emitting a generic error message. Make
this error message more device specific and return zero instead in the
remove callbacks. As the return value of bma400_remove() is unused then,
change the function to not yield a return value.
Signed-off-by: Uwe Kleine-König <u.kleine-koenig@pengutronix.de>
Reviewed-by: Alexandru Ardelean <ardeleanalex@gmail.com>
Link: https://lore.kernel.org/r/20211013203223.2694577-2-u.kleine-koenig@pengutronix.de
Signed-off-by: Jonathan Cameron <Jonathan.Cameron@huawei.com>
Add a IIO driver for the Bosch BMA400 3-axes ultra-low power accelerometer.
The driver supports reading from the acceleration and temperature
registers. The driver also supports reading and configuring the output data
rate, oversampling ratio, and scale.
Signed-off-by: Dan Robertson <dan@dlrobertson.com>
Reviewed-by: Andy Shevchenko <andy.shevchenko@gmail.com>
Reviewed-by: Linus Walleij <linus.walleij@linaro.org>
Signed-off-by: Jonathan Cameron <Jonathan.Cameron@huawei.com>
Jagath Jog J