Commit Graph

2 Commits

Author SHA1 Message Date
Stephen Warren 805504abdc ARM: bcm2835: enable GPIO/pinctrl
Enable GPIO and pinctrl in Kconfig.

Add required <mach/gpio.h> for gpiolib.

Instantiate the BCM2835 GPIO module in bcm2835.dtsi.

Add a pinctrl definition to bcm2835-rpi-b.dts that sets up all of the
board's required pinmux configuration. GPIO aren't specified; that's
left to gpio_request().

Signed-off-by: Stephen Warren <swarren@wwwdotorg.org>
Acked-by: Linus Walleij <linus.walleij@linaro.org>
2012-10-25 20:42:51 -06:00
Simon Arlott ec9653b847 ARM: add infra-structure for BCM2835 and Raspberry Pi
The BCM2835 is an ARM SoC from Broadcom. This patch adds very basic
support for this SoC.

http://www.broadcom.com/products/BCM2835
http://www.raspberrypi.org/wp-content/uploads/2012/02/BCM2835-ARM-Peripherals.pdf

Note that the documentation in the latter .pdf assumes the MMU setup
that's used on the "VideoCore" companion processor, and does not document
physical peripheral addresses. Subtract 0x5e000000 to obtain the physical
addresses. This is accounted for by the ranges property in the /soc node
in the device tree.

The BCM2835 SoC is used in the Raspberry Pi. This patch also adds a
minimal device tree for this board; enough to see some very early kernel
boot messages through earlyprintk. However, this patch does not yet
provide a useful booting system.

http://www.raspberrypi.org/.

This patch was extracted from git://github.com/lp0/linux.git branch
rpi-split from 3-4 months ago, and significantly stripped down and
modified since.

Signed-off-by: Chris Boot <bootc@bootc.net>
Signed-off-by: Simon Arlott <simon@fire.lp0.eu>
Signed-off-by: Dom Cobley <popcornmix@gmail.com>
Signed-off-by: Dom Cobley <dc4@broadcom.com>
Signed-off-by: Stephen Warren <swarren@wwwdotorg.org>
Acked-by: Arnd Bergmann <arnd@arndb.de>
2012-09-19 19:08:27 -06:00