This patch will use list_empty(&ls->ls_cb_delay) to check for last list
iteration. In case of a multiply count of MAX_CB_QUEUE and the list is
empty we do a extra goto more which we can avoid by checking on
list_empty().
Signed-off-by: Alexander Aring <aahringo@redhat.com>
Signed-off-by: David Teigland <teigland@redhat.com>
This patch adds initial support for dlm tracepoints. It will introduce
tracepoints to dlm main functionality dlm_lock()/dlm_unlock() and their
complete ast() callback or blocking bast() callback.
The lock/unlock functionality has a start and end tracepoint, this is
because there exists a race in case if would have a tracepoint at the
end position only the complete/blocking callbacks could occur before. To
work with eBPF tracing and using their lookup hash functionality there
could be problems that an entry was not inserted yet. However use the
start functionality for hash insert and check again in end functionality
if there was an dlm internal error so there is no ast callback. In further
it might also that locks with local masters will occur those callbacks
immediately so we must have such functionality.
I did not make everything accessible yet, although it seems eBPF can be
used to access a lot of internal datastructures if it's aware of the
struct definitions of the running kernel instance. We still can change
it, if you do eBPF experiments e.g. time measurements between lock and
callback functionality you can simple use the local lkb_id field as hash
value in combination with the lockspace id if you have multiple
lockspaces. Otherwise you can simple use trace-cmd for some functionality,
e.g. `trace-cmd record -e dlm` and `trace-cmd report` afterwards.
Signed-off-by: Alexander Aring <aahringo@redhat.com>
Signed-off-by: David Teigland <teigland@redhat.com>
This patch makes dlm_callback_resume info printout less noisy by
accumulate all callback queues into one printout not in 25 times steps.
It seems this printout became lately quite noisy in relationship with
gfs2.
Before:
[241767.849302] dlm: bin: dlm_callback_resume 25
[241767.854846] dlm: bin: dlm_callback_resume 25
[241767.860373] dlm: bin: dlm_callback_resume 25
...
[241767.865920] dlm: bin: dlm_callback_resume 25
[241767.871352] dlm: bin: dlm_callback_resume 25
[241767.876733] dlm: bin: dlm_callback_resume 25
After the patch:
[ 385.485728] dlm: gfs2: dlm_callback_resume 175
if zero it will not be printed out.
Reported-by: Barry Marson <bmarson@redhat.com>
Signed-off-by: Alexander Aring <aahringo@redhat.com>
Signed-off-by: David Teigland <teigland@redhat.com>
Based on 1 normalized pattern(s):
this copyrighted material is made available to anyone wishing to use
modify copy or redistribute it subject to the terms and conditions
of the gnu general public license v 2
extracted by the scancode license scanner the SPDX license identifier
GPL-2.0-only
has been chosen to replace the boilerplate/reference in 45 file(s).
Signed-off-by: Thomas Gleixner <tglx@linutronix.de>
Reviewed-by: Richard Fontana <rfontana@redhat.com>
Reviewed-by: Allison Randal <allison@lohutok.net>
Reviewed-by: Steve Winslow <swinslow@gmail.com>
Reviewed-by: Alexios Zavras <alexios.zavras@intel.com>
Cc: linux-spdx@vger.kernel.org
Link: https://lkml.kernel.org/r/20190528170027.342746075@linutronix.de
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
Before this patch, recovery would cause all callbacks to be delayed,
put on a queue, and afterward they were all queued to the callback
work queue. This patch does the same thing, but occasionally takes
a break after 25 of them so it won't swamp the CPU at the expense
of other RT processes like corosync.
Signed-off-by: Bob Peterson <rpeterso@redhat.com>
Signed-off-by: David Teigland <teigland@redhat.com>
dlm_cb_seq is 64 bits. If dlm_cb_seq overflows and returns to 0,
dlm_rem_lkb_callback() will not work properly.
Signed-off-by: Tadashi Miyauchi <miyauchi@toshiba-tops.co.jp>
Signed-off-by: Tsutomu Owa <tsutomu.owa@toshiba.co.jp>
Signed-off-by: David Teigland <teigland@redhat.com>
This patch removes the WQ_UNBOUND flag (which implies WQ_HIGHPRI)
from the DLM's ast work queue, in favor of just WQ_HIGHPRI.
This has been shown to cause a 19 percent performance increase for
simultaneous inode creates on GFS2 with fs_mark.
Signed-off-by: Bob Peterson <rpeterso@redhat.com>
Signed-off-by: David Teigland <teigland@redhat.com>
The log messages relating to the progress of recovery
are minimal and very often useful. Change these to
the KERN_INFO level so they are always available.
Signed-off-by: David Teigland <teigland@redhat.com>
Include appropriate header file fs/dlm/ast.h in fs/dlm/ast.c because it
contains function prototypes of some functions defined in fs/dlm/ast.c.
This also eliminates the following warning in fs/dlm/ast:
fs/dlm/ast.c:52:5: warning: no previous prototype for ‘dlm_add_lkb_callback’ [-Wmissing-prototypes]
fs/dlm/ast.c:113:5: warning: no previous prototype for ‘dlm_rem_lkb_callback’ [-Wmissing-prototypes]
fs/dlm/ast.c:174:6: warning: no previous prototype for ‘dlm_add_cb’ [-Wmissing-prototypes]
fs/dlm/ast.c:212:6: warning: no previous prototype for ‘dlm_callback_work’ [-Wmissing-prototypes]
fs/dlm/ast.c:267:5: warning: no previous prototype for ‘dlm_callback_start’ [-Wmissing-prototypes]
fs/dlm/ast.c:278:6: warning: no previous prototype for ‘dlm_callback_stop’ [-Wmissing-prototypes]
fs/dlm/ast.c:284:6: warning: no previous prototype for ‘dlm_callback_suspend’ [-Wmissing-prototypes]
fs/dlm/ast.c:292:6: warning: no previous prototype for ‘dlm_callback_resume’ [-Wmissing-prototypes]
Signed-off-by: Rashika Kheria <rashika.kheria@gmail.com>
Reviewed-by: Josh Triplett <josh@joshtriplett.org>
Signed-off-by: David Teigland <teigland@redhat.com>
dbf2576e37 ("workqueue: make all workqueues non-reentrant") made
WQ_NON_REENTRANT no-op and the flag is going away. Remove its usages.
This patch doesn't introduce any behavior changes.
Signed-off-by: Tejun Heo <tj@kernel.org>
Signed-off-by: David Teigland <teigland@redhat.com>
The "nodir" mode (statically assign master nodes instead
of using the resource directory) has always been highly
experimental, and never seriously used. This commit
fixes a number of problems, making nodir much more usable.
- Major change to recovery: recover all locks and restart
all in-progress operations after recovery. In some
cases it's not possible to know which in-progess locks
to recover, so recover all. (Most require recovery
in nodir mode anyway since rehashing changes most
master nodes.)
- Change the way nodir mode is enabled, from a command
line mount arg passed through gfs2, into a sysfs
file managed by dlm_controld, consistent with the
other config settings.
- Allow recovering MSTCPY locks on an rsb that has not
yet been turned into a master copy.
- Ignore RCOM_LOCK and RCOM_LOCK_REPLY recovery messages
from a previous, aborted recovery cycle. Base this
on the local recovery status not being in the state
where any nodes should be sending LOCK messages for the
current recovery cycle.
- Hold rsb lock around dlm_purge_mstcpy_locks() because it
may run concurrently with dlm_recover_master_copy().
- Maintain highbast on process-copy lkb's (in addition to
the master as is usual), because the lkb can switch
back and forth between being a master and being a
process copy as the master node changes in recovery.
- When recovering MSTCPY locks, flag rsb's that have
non-empty convert or waiting queues for granting
at the end of recovery. (Rename flag from LOCKS_PURGED
to RECOVER_GRANT and similar for the recovery function,
because it's not only resources with purged locks
that need grant a grant attempt.)
- Replace a couple of unnecessary assertion panics with
error messages.
Signed-off-by: David Teigland <teigland@redhat.com>
Allow multiple workqueue items (locks with callbacks) to be
processed concurrently. There should be no reason not to
take advantage of this workqueue feature.
Signed-off-by: David Teigland <teigland@redhat.com>
Instead of creating our own kthread (dlm_astd) to deliver
callbacks for all lockspaces, use a per-lockspace workqueue
to deliver the callbacks. This eliminates complications and
slowdowns from many lockspaces sharing the same thread.
Signed-off-by: David Teigland <teigland@redhat.com>
Change how callbacks are recorded for locks. Previously, information
about multiple callbacks was combined into a couple of variables that
indicated what the end result should be. In some situations, we
could not tell from this combined state what the exact sequence of
callbacks were, and would end up either delivering the callbacks in
the wrong order, or suppress redundant callbacks incorrectly. This
new approach records all the data for each callback, leaving no
uncertainty about what needs to be delivered.
Signed-off-by: David Teigland <teigland@redhat.com>
When both blocking and completion callbacks are queued for lock,
the dlm would always deliver the completion callback (cast) first.
In some cases the blocking callback (bast) is queued before the
cast, though, and should be delivered first. This patch keeps
track of the order in which they were queued and delivers them
in that order.
This patch also keeps track of the granted mode in the last cast
and eliminates the following bast if the bast mode is compatible
with the preceding cast mode. This happens when a remotely mastered
lock is demoted, e.g. EX->NL, in which case the local node queues
a cast immediately after sending the demote message. In this way
a cast can be queued for a mode, e.g. NL, that makes an in-transit
bast extraneous.
Signed-off-by: David Teigland <teigland@redhat.com>
fs/dlm/ast.c: In function 'dlm_astd':
fs/dlm/ast.c:64: warning: 'bastmode' may be used uninitialized in this function
Cleans code up.
Signed-off-by: Andrew Morton <akpm@linux-foundation.org>
Signed-off-by: David Teigland <teigland@redhat.com>
The lkb bastmode value is set in the context of processing the
lock, and read by the dlm_astd thread. Because it's accessed
in these two separate contexts, the writing/reading ought to
be done under a lock. This is simple to do by setting it and
reading it when the lkb is added to and removed from dlm_astd's
callback list which is properly locked.
Signed-off-by: David Teigland <teigland@redhat.com>
Just before delivering a blocking callback (bast), the dlm_astd
thread checks again that the granted mode of the lkb actually
blocks the mode requested by the bast. The idea behind this was
originally that the granted mode may have changed since the bast
was queued, making the callback now unnecessary. Reasons for
removing this extra check are:
- dlm_astd doesn't lock the rsb before reading the lkb grmode, so
it's not technically safe (this removes the long standing FIXME)
- after running some tests, it doesn't appear the check ever actually
eliminates a bast
- delivering an unnecessary blocking callback isn't a bad thing and
can happen anyway
Signed-off-by: David Teigland <teigland@redhat.com>
This is a one-liner to use cond_resched() rather than schedule()
in the ast delivery loop. It should not be necessary to schedule
every time, so this will save some cpu time while continuing to
allow scheduling when required.
Signed-off-by: Steven Whitehouse <swhiteho@redhat.com>
Signed-off-by: David Teigland <teigland@redhat.com>
Every file should include the headers containing the prototypes for
it's global functions.
Signed-off-by: Adrian Bunk <bunk@stusta.de>
Signed-off-by: David Teigland <teigland@redhat.com>
Signed-off-by: Steven Whitehouse <swhiteho@redhat.com>
The down-conversion optimization was resulting in the lkb flags being
cleared because the stub message reply had no flags value set. Copy the
current flags into the stub message so they'll be copied back into the lkb
as part of processing the fake reply. Also add an assertion to catch this
error more directly if it exists elsewhere.
Signed-off-by: David Teigland <teigland@redhat.com>
Signed-off-by: Steven Whitehouse <swhiteho@redhat.com>
This changes the way the dlm handles user locks. The core dlm is now
aware of user locks so they can be dealt with more efficiently. There is
no more dlm_device module which previously managed its own duplicate copy
of every user lock.
Signed-off-by: Patrick Caulfield <pcaulfie@redhat.com>
Signed-off-by: David Teigland <teigland@redhat.com>
Signed-off-by: Steven Whitehouse <swhiteho@redhat.com>
This is the core of the distributed lock manager which is required
to use GFS2 as a cluster filesystem. It is also used by CLVM and
can be used as a standalone lock manager independantly of either
of these two projects.
It implements VAX-style locking modes.
Signed-off-by: David Teigland <teigland@redhat.com>
Signed-off-by: Steve Whitehouse <swhiteho@redhat.com>
Alexander Aring