The upper and lower variables are set as link lists to add into the sparse
array. If they are NULL, after the needed allocations are done, then there
is nothing to add. But they need to be initialized to NULL for this to
work.
Link: https://lore.kernel.org/all/221bc7ba-a475-1cb9-1bbe-730bb9c2d448@canonical.com/
Fixes: 8d6e90983a ("tracing: Create a sparse bitmask for pid filtering")
Reported-by: Colin Ian King <colin.king@canonical.com>
Signed-off-by: Steven Rostedt (VMware) <rostedt@goodmis.org>
When the trace_pid_list was created, the default pid max was 32768.
Creating a bitmask that can hold one bit for all 32768 took up 4096 (one
page). Having a one page bitmask was not much of a problem, and that was
used for mapping pids. But today, systems are bigger and can run more
tasks, and now the default pid_max is usually set to 4194304. Which means
to handle that many pids requires 524288 bytes. Worse yet, the pid_max can
be set to 2^30 (1073741824 or 1G) which would take 134217728 (128M) of
memory to store this array.
Since the pid_list array is very sparsely populated, it is a huge waste of
memory to store all possible bits for each pid when most will not be set.
Instead, use a page table scheme to store the array, and allow this to
handle up to 30 bit pids.
The pid_mask will start out with 256 entries for the first 8 MSB bits.
This will cost 1K for 32 bit architectures and 2K for 64 bit. Each of
these will have a 256 array to store the next 8 bits of the pid (another
1 or 2K). These will hold an 2K byte bitmask (which will cover the LSB
14 bits or 16384 pids).
When the trace_pid_list is allocated, it will have the 1/2K upper bits
allocated, and then it will allocate a cache for the next upper chunks and
the lower chunks (default 6 of each). Then when a bit is "set", these
chunks will be pulled from the free list and added to the array. If the
free list gets down to a lever (default 2), it will trigger an irqwork
that will refill the cache back up.
On clearing a bit, if the clear causes the bitmask to be zero, that chunk
will then be placed back into the free cache for later use, keeping the
need to allocate more down to a minimum.
Signed-off-by: Steven Rostedt (VMware) <rostedt@goodmis.org>
Instead of having the logic that does trace_pid_list open coded, wrap it in
abstract functions. This will allow a rewrite of the logic that implements
the trace_pid_list without affecting the users.
Note, this causes a change in behavior. Every time a pid is written into
the set_*_pid file, it creates a new list and uses RCU to update it. If
pid_max is lowered, but there was a pid currently in the list that was
higher than pid_max, those pids will now be removed on updating the list.
The old behavior kept that from happening.
The rewrite of the pid_list logic will no longer depend on pid_max,
and will return the old behavior.
Signed-off-by: Steven Rostedt (VMware) <rostedt@goodmis.org>
Steven Rostedt (VMware)