- moves out of nouveau_bios.c and demagics the logical state definitions
- simplifies chipset-specific driver interface
- makes most of gpio irq handling common, will use for nv4x hpd later
- api extended to allow both direct gpio access, and access using the
logical function states
- api extended to allow for future use of gpio extender chips
- pre-nv50 was handled very badly, the main issue being that all GPIOs
were being treated as output-only.
- fixes nvd0 so gpio changes actually stick, magic reg needs bashing
Signed-off-by: Ben Skeggs <bskeggs@redhat.com>
We don't need more than the line id to determine the PWM controller, and
the GPIO interfaces are about to change somewhat.
Signed-off-by: Ben Skeggs <bskeggs@redhat.com>
The DCB table provided by the VBIOS on most MXM chips has a number of
entries which either need to be disabled, or modified according to the
MXM-SIS Output Device Descriptors.
The x86 vbios code usually takes care of this for us, however, with the
large number of laptops now with switchable graphics or optimus, a lot
of the time nouveau is responsible for POSTing the card instead - leaving
some fun situations like, plugging in a monitor and having nouveau decide
3 connectors actually just got plugged in..
No MXM-SIS fetching methods implemented yet.
Signed-off-by: Ben Skeggs <bskeggs@redhat.com>
Not much point parsing the vbios data into a struct which is only used once
to parse the data into another struct, go directly from vbios to
nouveau_i2c_chan.
Signed-off-by: Ben Skeggs <bskeggs@redhat.com>
This primary reason for this was mostly to avoid duplication of some of
this stuff by the MXM-SIS parser. However, some other cleanups will also
follow this as a result.
Signed-off-by: Ben Skeggs <bskeggs@redhat.com>
This area is horrifically complicated on these chipsets, and it's likely we
will need at least a few more tweaks yet.
Oh yes, and it's completely disabled on IGPs for the moment. From traces,
things look potentially different there yet again. Sigh...
Signed-off-by: Ben Skeggs <bskeggs@redhat.com>
Reporting an error is better than silently refusing to reclock.
V2: Use the same logic on nv40
Signed-off-by: Martin Peres <martin.peres@labri.fr>
Signed-off-by: Ben Skeggs <bskeggs@redhat.com>
Exposes the same connector properties as the Radeon implementation, however
their behaviour isn't exactly the same. The primary difference being that
unless both hborder/vborder have been defined by the user, the driver will
keep the aspect ratio of the overscanned area the same as the mode the
display is programmed for.
Enabled for digital outputs on GeForce 8 and up, excluding GF119.
Signed-off-by: Ben Skeggs <bskeggs@redhat.com>
The handling of the internal pwm fan controller is similar enough between
current chipsets that it makes sense to share the logic, and bugfixes :)
No hw backends converted yet, will automatically fall-through to the
"old" per-chipset fanspeed hooks for now.
Signed-off-by: Ben Skeggs <bskeggs@redhat.com>
Exposes the following sysfs entries:
- fan0_input: read the rotational speed of the fan (poll a bit during 250ms)
- pwm0: set the pwm duty cycle
- pwm0_min/max: set the minimum/maximum pwm value
v2 (Ben Skeggs):
- nv50 pwm controller code removed in favour of other more complete code
- FAN_RPM -> FAN_SENSE
- merged FAN_SENSE readout into common code, not at all nv50-specific
- protected fanspeed changes with perflvl_wr
- formatting tidying
- added some comments where things are shaky
v3 (Martin Peres)
- ensure duty min/max from thermal table are sane
Signed-off-by: Ben Skeggs <bskeggs@redhat.com>
Signed-off-by: Martin Peres <martin.peres@ensi-bourges.fr>
Merge in the upstream tree to bring in the mainline fixes.
Conflicts:
drivers/gpu/drm/exynos/exynos_drm_fbdev.c
drivers/gpu/drm/nouveau/nouveau_sgdma.c
ttm_backend will only exist with a ttm_tt, and ttm_tt
will only be of interest when bound to a backend. Merge them
to avoid code and data duplication.
V2 Rebase on top of memory accounting overhaul
V3 Rebase on top of more memory accounting changes
V4 Rebase on top of no memory account changes (where/when is my
delorean when i need it ?)
V5 make sure ttm is unbound before destroying, change commit
message on suggestion from Tormod Volden
Signed-off-by: Jerome Glisse <jglisse@redhat.com>
Reviewed-by: Konrad Rzeszutek Wilk <konrad.wilk@oracle.com>
Reviewed-by: Thomas Hellstrom <thellstrom@vmware.com>
Will need to be able to distinguish 2.0/2.1 from 3.0 soon. Also, move
the vbios parsing to nouveau_dp where it belongs.
Signed-off-by: Ben Skeggs <bskeggs@redhat.com>
Not used currently, but it will be used in preference to pre-determined
lane/bandwidth numbers at a later point.
Signed-off-by: Ben Skeggs <bskeggs@redhat.com>
I'm sure that out there somewhere, someone will need this. We currently
haven't seen an example of LVDS being on a non-0 SOR so far though.
Signed-off-by: Ben Skeggs <bskeggs@redhat.com>
NV30: Create framework for memtm
NV50: Improve reg creation,
NV50: Use P.version instead of card codename/stepping,
NVC0: Initial memtiming code for Fermi,
Renamed regs for consistency,
Overall redesign to improve readability,
Avoid kfree on null-pointer
Signed-off-by: Roy Spliet <r.spliet@student.tudelft.nl>
This is probably better than having to tell the common code about all the
clocks that exist on every chipset.
Signed-off-by: Ben Skeggs <bskeggs@redhat.com>
Francisco Jerez