When compiling the Marvell CN10K DDR PMU driver with CONFIG_OF=n, the
build fails:
| drivers/perf/marvell_cn10k_ddr_pmu.c:723:35: error: 'cn10k_ddr_pmu_of_match' undeclared here (not in a function); did you mean 'cn10k_ddr_pmu_driver'?
Use `of_match_ptr()` to avoid referencing the non-existent match table
in this configuration.
Link: https://lore.kernel.org/r/202203091424.Vfe8J4W9-lkp@intel.com
Reported-by: kernel test robot <lkp@intel.com>
Signed-off-by: Will Deacon <will@kernel.org>
As DDR perf event counters are not per core, so they should be accessed
only by one core at a time. Select new core when previously owning core
is going offline.
Signed-off-by: Bharat Bhushan <bbhushan2@marvell.com>
Reviewed-by: Bhaskara Budiredla <bbudiredla@marvell.com>
Link: https://lore.kernel.org/r/20220211045346.17894-5-bbhushan2@marvell.com
Signed-off-by: Will Deacon <will@kernel.org>
CN10k DSS h/w perfmon does not support event overflow interrupt, so
periodic timer is being used. Each event counter is 48bit, which in worst
case scenario can increment at maximum 5.6 GT/s. At this rate it may take
many hours to overflow these counters. Therefore polling period for
overflow is set to 100 sec, which can be changed using sysfs parameter.
Two fixed event counters starts counting from zero on overflow, so
overflow condition is when new count less than previous count. While
eight programmable event counters freezes at maximum value. Also individual
counter cannot be restarted, so need to restart all eight counters.
Signed-off-by: Bharat Bhushan <bbhushan2@marvell.com>
Reviewed-by: Bhaskara Budiredla <bbudiredla@marvell.com>
Link: https://lore.kernel.org/r/20220211045346.17894-4-bbhushan2@marvell.com
Signed-off-by: Will Deacon <will@kernel.org>
Marvell CN10k DRAM Subsystem (DSS) supports eight event counters for
monitoring performance and software can program each counter to monitor
any of the defined performance event. Performance events are for
interface between the DDR controller and the PHY, interface between the
DDR Controller and the CHI interconnect, or within the DDR Controller.
Additionally DSS also supports two fixed performance event counters, one
for number of ddr reads and other for ddr writes.
This patch add basic support for these performance monitoring events
on CN10k.
Signed-off-by: Bharat Bhushan <bbhushan2@marvell.com>
Reviewed-by: Bhaskara Budiredla <bbudiredla@marvell.com>
Link: https://lore.kernel.org/r/20220211045346.17894-3-bbhushan2@marvell.com
Signed-off-by: Will Deacon <will@kernel.org>
Will Deacon