Gitee limit the repo's size to 3GB, to reduce the size of the code,
sync codes to ock 5.4.119-20.0009.21 in one commit.
Signed-off-by: Jianping Liu <frankjpliu@tencent.com>
This patch supports some type of machine drivers that set 0 to mclk
when sound device goes to idle state. After applied this patch,
sysclk == 0 means there is no constraint of sound rate and other
values will set constraints which is derived by sysclk setting.
Original code refuses sysclk == 0 setting. But some boards and SoC
(such as RockPro64 and RockChip I2S) has connected SoC MCLK out to
ES8316 MCLK in. In this case, SoC side I2S will choose suitable
frequency of MCLK such as fs * mclk-fs when user starts playing or
capturing.
Bad scenario as follows (mclk-fs = 256):
- Initialize sysclk by correct value (Ex. 12.288MHz)
- ES8316 set constraints of PCM rate by sysclk
48kHz (1/256), 32kHz (1/384), 30.720kHz (1/400),
24kHz (1/512), 16kHz (1/768), 12kHz (1/1024)
- Play 48kHz sound, it's acceptable
- Sysclk is not changed
- Play 32kHz sound, it's acceptable
- Set sysclk by 8.192MHz (= fs * mclk-fs = 32k * 256)
- ES8316 set constraints of PCM rate by sysclk
32kHz (1/256), 21.33kHz (1/384), 20.48kHz (1/400),
16kHz (1/512), 10.66kHz (1/768), 8kHz (1/1024)
- Play 48kHz again, but it's NOT acceptable because constraints
list does not allow 48kHz
Signed-off-by: Katsuhiro Suzuki <katsuhiro@katsuster.net>
Link: https://lore.kernel.org/r/20190907163653.9382-2-katsuhiro@katsuster.net
Signed-off-by: Mark Brown <broonie@kernel.org>
This patch removes redundant null checks for optional MCLK clock.
And fix DT binding document for changing clock property to optional
from required.
Signed-off-by: Katsuhiro Suzuki <katsuhiro@katsuster.net>
Link: https://lore.kernel.org/r/20190907163653.9382-1-katsuhiro@katsuster.net
Signed-off-by: Mark Brown <broonie@kernel.org>
This patch introduce clock property for MCLK master freq control.
Driver will set rate of MCLK master if set_sysclk is called and
changing sysclk by board driver.
[Modified slightly to apply without an earlier patch in the series due
to context diffs -- broonie]
Signed-off-by: Katsuhiro Suzuki <katsuhiro@katsuster.net>
Link: https://lore.kernel.org/r/20190903165322.20791-2-katsuhiro@katsuster.net
Signed-off-by: Mark Brown <broonie@kernel.org>
This patch fixes inverted Left-Right channel of headphone mixer
volume by wrong shift_left, shift_right values.
Signed-off-by: Katsuhiro Suzuki <katsuhiro@katsuster.net>
Reviewed-by: Daniel Drake <drake@endlessm.com>
Link: https://lore.kernel.org/r/20190826153900.25969-2-katsuhiro@katsuster.net
Signed-off-by: Mark Brown <broonie@kernel.org>
Based on 2 normalized pattern(s):
this program is free software you can redistribute it and or modify
it under the terms of the gnu general public license version 2 as
published by the free software foundation
this program is free software you can redistribute it and or modify
it under the terms of the gnu general public license version 2 as
published by the free software foundation #
extracted by the scancode license scanner the SPDX license identifier
GPL-2.0-only
has been chosen to replace the boilerplate/reference in 4122 file(s).
Signed-off-by: Thomas Gleixner <tglx@linutronix.de>
Reviewed-by: Enrico Weigelt <info@metux.net>
Reviewed-by: Kate Stewart <kstewart@linuxfoundation.org>
Reviewed-by: Allison Randal <allison@lohutok.net>
Cc: linux-spdx@vger.kernel.org
Link: https://lkml.kernel.org/r/20190604081206.933168790@linutronix.de
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
On some devices (Teclast X98+ II tablet, maybe others), the jack
detection has been wired backwards, so when the ES8316 reports
headphones being present it means they are actually not plugged.
Use a quirk around this incorrect behaviour, which can be enabled
through the 'everest,jack-detect-inverted' boolean device property.
Signed-off-by: Paul Cercueil <paul@crapouillou.net>
Signed-off-by: Mark Brown <broonie@kernel.org>
Fix warnings with W=1
If these variables are useful this driver should be modified to expose
them.
Signed-off-by: Pierre-Louis Bossart <pierre-louis.bossart@linux.intel.com>
Signed-off-by: Mark Brown <broonie@kernel.org>
Export the DAC functionality to mix left + right together and then output
the same (mixed) signal on both outputs.
Various (x86) tablets with an ES8316 codec use a single speaker
connected between the headhpone LOUT and ROUT pins, expecting the output
to be in a mono differential mode. Presumably this is done to use the
power of both the left and right outputs to allow the speaker to be
louder.
The ES8316 codec does not have a differential output mode, but we can
emulate this by making both channels output the same through the mono mix
switch, combined with setting the Playback Polarity control to "R Invert",
which applias a 180 degrees phase inversion to the right channel.
Signed-off-by: Hans de Goede <hdegoede@redhat.com>
Signed-off-by: Mark Brown <broonie@kernel.org>
Adding jack-detect support may seem weird for a codec with only
a single output, but it is necessary. The ES8316 appnote showing
the intended usage uses a jack-receptacle which physically disconnects
the speakers from the output when a jack is plugged in.
But all 3 devices using the es8316 which I have (2 Cherry Trail
devices and one Bay Trail CR device), use an analog mux to disconnect
the speakers, driven by a GPIO. In order to enable/disable the speakers
at the right time, we need jack-detect.
The same goes for the microphone where we must correctly set the mux
for the single ADC to either the internal or the headset microphone.
All devices I have support the es8316's builtin jack-detect functionality.
Signed-off-by: Hans de Goede <hdegoede@redhat.com>
Signed-off-by: Mark Brown <broonie@kernel.org>
snd_soc_dai_ops are not supposed to change at runtime. All functions
working with snd_soc_dai_ops provided by <sound/soc-dai.h> work with
const snd_soc_dai_ops. So mark the non-const structs as const.
Signed-off-by: Arvind Yadav <arvind.yadav.cs@gmail.com>
Signed-off-by: Mark Brown <broonie@kernel.org>
Declare snd_soc_codec_driver structures as const as they are only passed
as an argument to the function snd_soc_register_codec. This argument is
of type const, so declare the structures with this property as const.
In file codecs/sn95031.c, snd_soc_codec_driver structure is also used in
a copy operation along with getting passed to snd_soc_register_codec.
So, it can be made const too.
Done using Coccinelle:
@match disable optional_qualifier@
identifier s;
position p;
@@
static struct snd_soc_codec_driver s@p={...};
@good1@
identifier match.s;
position p;
@@
snd_soc_register_codec(...,&s@p,...)
@bad@
identifier match.s;
position p!={match.p,good1.p};
@@
s@p
@depends on !bad disable optional_qualifier@
identifier match.s;
@@
static
+const
struct snd_soc_codec_driver s={...};
Signed-off-by: Bhumika Goyal <bhumirks@gmail.com>
Signed-off-by: Mark Brown <broonie@kernel.org>
Add a codec driver for the Everest ES8316, based on code provided by
David Yang from Everest Semi.
I limited the functionality to items where the vendor code was clear,
and things that can be tested on the Weibu F3C (Intel Cherry Trail).
As a result the initial implementation only supports running in slave
mode at single speed (up to 48kHz sample rate) using I2S. HPD is not
supported.
Signed-off-by: David Yang <yangxiaohua@everest-semi.com>
[drake@endlessm.com: significant cleanups and simplifications,
remove dead/unclear code]
Signed-off-by: Daniel Drake <drake@endlessm.com>
Signed-off-by: Mark Brown <broonie@kernel.org>
Jianping Liu