pinctrl: intel: Set default bias in case no particular value given

When GPIO library asks pin control to set the bias, it doesn't pass
any value of it and argument is considered boolean (and this is true
for ACPI GpioIo() / GpioInt() resources, by the way). Thus, individual
drivers must behave well, when they got the resistance value of 1 Ohm,
i.e. transforming it to sane default.

In case of Intel pin control hardware the 5 kOhm sounds plausible
because on one hand it's a minimum of resistors present in all
hardware generations and at the same time it's high enough to minimize
leakage current (will be only 200 uA with the above choice).

Fixes: e57725eabf ("pinctrl: intel: Add support for hardware debouncer")
Reported-by: Jamie McClymont <jamie@kwiius.com>
Signed-off-by: Andy Shevchenko <andriy.shevchenko@linux.intel.com>
Acked-by: Mika Westerberg <mika.westerberg@linux.intel.com>

drivers/pinctrl/intel/pinctrl-intel.c

@@ -683,6 +683,10 @@ static int intel_config_set_pull(struct intel_pinctrl *pctrl, unsigned int pin,
 
 		value |= PADCFG1_TERM_UP;
 
+		/* Set default strength value in case none is given */
+		if (arg == 1)
+			arg = 5000;
+
 		switch (arg) {
 		case 20000:
 			value |= PADCFG1_TERM_20K << PADCFG1_TERM_SHIFT;
@@ -705,6 +709,10 @@ static int intel_config_set_pull(struct intel_pinctrl *pctrl, unsigned int pin,
 	case PIN_CONFIG_BIAS_PULL_DOWN:
 		value &= ~(PADCFG1_TERM_UP | PADCFG1_TERM_MASK);
 
+		/* Set default strength value in case none is given */
+		if (arg == 1)
+			arg = 5000;
+
 		switch (arg) {
 		case 20000:
 			value |= PADCFG1_TERM_20K << PADCFG1_TERM_SHIFT;