be2net: remove redundant D0 power state set

pci_enable_device() call sets device power state to D0; there is no need
doing it again.

Signed-off-by: Kalesh AP <kalesh.purayil@avagotech.com>
Signed-off-by: Sathya Perla <sathya.perla@avagotech.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
This commit is contained in:
Kalesh Purayil 2015-07-10 05:32:45 -04:00 committed by David S. Miller
parent ff9ed19d26
commit bc23d6b7ab
1 changed files with 0 additions and 2 deletions

View File

@ -5807,7 +5807,6 @@ static int be_pci_resume(struct pci_dev *pdev)
if (status) if (status)
return status; return status;
pci_set_power_state(pdev, PCI_D0);
pci_restore_state(pdev); pci_restore_state(pdev);
status = be_resume(adapter); status = be_resume(adapter);
@ -5887,7 +5886,6 @@ static pci_ers_result_t be_eeh_reset(struct pci_dev *pdev)
return PCI_ERS_RESULT_DISCONNECT; return PCI_ERS_RESULT_DISCONNECT;
pci_set_master(pdev); pci_set_master(pdev);
pci_set_power_state(pdev, PCI_D0);
pci_restore_state(pdev); pci_restore_state(pdev);
/* Check if card is ok and fw is ready */ /* Check if card is ok and fw is ready */