drm/i915: vlv: don't unmask IIR[DISPLAY_PIPE_A/B_VBLANK] interrupt
Bspec and the code suggests that the interrupt signaled by IIR[7,5] (DISPLAY_PIPE_A/B_VBLANK) is a first level IRQ flag for the second level PIPEA/BSTAT[2] (Start of Vertical Blank) interrupt. Measuring the relative timings of when IIR[7] and PIPEASTAT[1,2] get set and checking the effect of unmasking different pipestat and IIR events shows that this isn't so: First, ISR/IIR[7] gets set independently of PIPEASTAT[18] (Start of Vertical Blank Enable) or any other pipestat enable bit, so it isn't a first level IRQ bit showing the state of PIPEASTAT[2], but is connected directly to the timing generator. Second, setting only PIPEASTAT[18] and leaving all other pipestat events disabled, IIR[6] (DISPLAY_PIPE_A_EVENT) gets set close to the moment when PIPEASTAT[2] gets set, so the former is a first level interrupt flag for the latter. The bspec is rather unclear about this, but I also assume that IIR[6] signals all pipestat A events, except PIPEASTAT[31] (FIFO Under-run Status). Third, IIR[7] is set close to the moment when PIPEASTAT[1] (Framestart Interrupt) gets set, in the mode I used about 12usec after PIPEASTAT[2] and IIR[6] gets set. This means the IIR[7] isn't marking the start of vblank, but rather signals the framestart event. Based on the above, we don't need to unmask IIR[7] when waiting for start of vblank events, but we can rely on IIR[6] being always unmasked, which will signal when PIPEASTAT[2] gets set. Doing this will also get rid of the overhead of getting an interrupt and servicing IIR[7], which is atm raised always some time after IIR[6]/PIPEASTAT[2] is raised. Signed-off-by: Imre Deak <imre.deak@intel.com> Reviewed-by: Jesse Barnes <jbarnes@virtuousgeek.org> Signed-off-by: Daniel Vetter <daniel.vetter@ffwll.ch>
This commit is contained in:
parent
a57c774ab2
commit
b7e634cc8d
|
@ -2297,18 +2297,11 @@ static int valleyview_enable_vblank(struct drm_device *dev, int pipe)
|
|||
{
|
||||
drm_i915_private_t *dev_priv = (drm_i915_private_t *) dev->dev_private;
|
||||
unsigned long irqflags;
|
||||
u32 imr;
|
||||
|
||||
if (!i915_pipe_enabled(dev, pipe))
|
||||
return -EINVAL;
|
||||
|
||||
spin_lock_irqsave(&dev_priv->irq_lock, irqflags);
|
||||
imr = I915_READ(VLV_IMR);
|
||||
if (pipe == PIPE_A)
|
||||
imr &= ~I915_DISPLAY_PIPE_A_VBLANK_INTERRUPT;
|
||||
else
|
||||
imr &= ~I915_DISPLAY_PIPE_B_VBLANK_INTERRUPT;
|
||||
I915_WRITE(VLV_IMR, imr);
|
||||
i915_enable_pipestat(dev_priv, pipe,
|
||||
PIPE_START_VBLANK_INTERRUPT_ENABLE);
|
||||
spin_unlock_irqrestore(&dev_priv->irq_lock, irqflags);
|
||||
|
@ -2366,17 +2359,10 @@ static void valleyview_disable_vblank(struct drm_device *dev, int pipe)
|
|||
{
|
||||
drm_i915_private_t *dev_priv = (drm_i915_private_t *) dev->dev_private;
|
||||
unsigned long irqflags;
|
||||
u32 imr;
|
||||
|
||||
spin_lock_irqsave(&dev_priv->irq_lock, irqflags);
|
||||
i915_disable_pipestat(dev_priv, pipe,
|
||||
PIPE_START_VBLANK_INTERRUPT_ENABLE);
|
||||
imr = I915_READ(VLV_IMR);
|
||||
if (pipe == PIPE_A)
|
||||
imr |= I915_DISPLAY_PIPE_A_VBLANK_INTERRUPT;
|
||||
else
|
||||
imr |= I915_DISPLAY_PIPE_B_VBLANK_INTERRUPT;
|
||||
I915_WRITE(VLV_IMR, imr);
|
||||
spin_unlock_irqrestore(&dev_priv->irq_lock, irqflags);
|
||||
}
|
||||
|
||||
|
|
Loading…
Reference in New Issue