From a01c7f6709925919e2e3c6c190a92692f63f74e4 Mon Sep 17 00:00:00 2001 From: Alan Brady Date: Wed, 24 Aug 2016 11:33:47 -0700 Subject: [PATCH] i40e: fix "dump port" command when NPAR enabled When using the debugfs to issue the "dump port" command with NPAR enabled, the firmware reports back with invalid argument. The issue occurs because the pf->mac_seid was used to perform the query. This is fine when NPAR is disabled because the switch ID == pf->mac_seid, however this is not the case when NPAR is enabled. This fix instead goes through the VSI to determine the correct ID to use in either case. Change-ID: I0cd67913a7f2c4a2962e06d39e32e7447cc55b6a Signed-off-by: Alan Brady Tested-by: Andrew Bowers Signed-off-by: Jeff Kirsher --- drivers/net/ethernet/intel/i40e/i40e_debugfs.c | 7 ++++++- 1 file changed, 6 insertions(+), 1 deletion(-) diff --git a/drivers/net/ethernet/intel/i40e/i40e_debugfs.c b/drivers/net/ethernet/intel/i40e/i40e_debugfs.c index 05cf9a719bab..8555f04002da 100644 --- a/drivers/net/ethernet/intel/i40e/i40e_debugfs.c +++ b/drivers/net/ethernet/intel/i40e/i40e_debugfs.c @@ -1054,6 +1054,7 @@ static ssize_t i40e_dbg_command_write(struct file *filp, struct i40e_dcbx_config *r_cfg = &pf->hw.remote_dcbx_config; int i, ret; + u32 switch_id; bw_data = kzalloc(sizeof( struct i40e_aqc_query_port_ets_config_resp), @@ -1063,8 +1064,12 @@ static ssize_t i40e_dbg_command_write(struct file *filp, goto command_write_done; } + vsi = pf->vsi[pf->lan_vsi]; + switch_id = + vsi->info.switch_id & I40E_AQ_VSI_SW_ID_MASK; + ret = i40e_aq_query_port_ets_config(&pf->hw, - pf->mac_seid, + switch_id, bw_data, NULL); if (ret) { dev_info(&pf->pdev->dev,