Usual set of driver fixes. A bit more than usual because I was

unavailable for a while.
 -----BEGIN PGP SIGNATURE-----
 
 iQIzBAABCgAdFiEEOZGx6rniZ1Gk92RdFA3kzBSgKbYFAmTg7RsACgkQFA3kzBSg
 KbbVXw/9GjnFwj0sazyKuHJdE3l3lP5RbWPhO9lF4pwSG2XAyVMLjpcsN27LvrKl
 eu19hAu0a6C/PlUgYieCak/yl/9Xv08gxAcyI+PquAVtJ2XuWtsDUc0y1Rq2O53v
 xFtQEy5eARWH3hI7f2rBbZWpgIXit7Xd+WLNRREttQgRRN8L9qmOwiZKuG2S2UQa
 QMFn6qcOccwtkkvv992sZ4Pw54d9nOFCxKNim0TCiEKL9lgIelnrCJzqpw+yFRz/
 a/bDtb2lLJGHeaSsjCH4dyobecLLXd/DtJSenCCGJUpfQ9cU9AqZDH/EUKQEUHyQ
 p+LbixN/0viDZALwMzsXxPp+HuSouYr9m6s0ZstMUO73y9ydhaSoquq0f5eRjKbI
 PRyhtBw55QLduoOITPcyPMwBxEIxXWhoNbF4hRnpdIRzLQ/JB+kO5a3RZ4BYFMP1
 Rjz3vBKf2xzxlHJStYltNexmgPQ8PsfC6b7VJdyTOV74KUBADvWXPlBH/1tsppDX
 wwQMrYE7ouzhJ1ypq6sDj7/ERjw9+0+XVbnlyEi6S9XXx1OkzHN6HMZWC34LCXiR
 NXowjvU3O22wTnK3jzo2rIbJ+FPOYcaLcqV87vBCWigEByJ9jGxrwBBy2y4qsmyI
 MpwwiXEuODdA1OEByxkCY3U5bfIjdW7QzPGb6tJEPJNWjFOHG3w=
 =mRg9
 -----END PGP SIGNATURE-----

Merge tag 'i2c-for-6.5-rc7' of git://git.kernel.org/pub/scm/linux/kernel/git/wsa/linux

Pull i2c fixes from Wolfram Sang:
 "Usual set of driver fixes. A bit more than usual because I was
  unavailable for a while"

* tag 'i2c-for-6.5-rc7' of git://git.kernel.org/pub/scm/linux/kernel/git/wsa/linux:
  i2c: bcm-iproc: Fix bcm_iproc_i2c_isr deadlock issue
  i2c: Update documentation to use .probe() again
  i2c: sun6i-p2wi: Fix an error message in probe()
  i2c: hisi: Only handle the interrupt of the driver's transfer
  i2c: tegra: Fix i2c-tegra DMA config option processing
  i2c: tegra: Fix failure during probe deferral cleanup
  i2c: designware: Handle invalid SMBus block data response length value
  i2c: designware: Correct length byte validation logic
  i2c: imx-lpi2c: return -EINVAL when i2c peripheral clk doesn't work

Documentation/i2c/writing-clients.rst

@@ -46,7 +46,7 @@ driver model device node, and its I2C address.
 	},
 
 	.id_table	= foo_idtable,
-	.probe_new	= foo_probe,
+	.probe		= foo_probe,
 	.remove		= foo_remove,
 	/* if device autodetection is needed: */
 	.class		= I2C_CLASS_SOMETHING,

drivers/i2c/busses/i2c-bcm-iproc.c

@@ -233,13 +233,14 @@ static inline u32 iproc_i2c_rd_reg(struct bcm_iproc_i2c_dev *iproc_i2c,
 				   u32 offset)
 {
 	u32 val;
+	unsigned long flags;
 
 	if (iproc_i2c->idm_base) {
-		spin_lock(&iproc_i2c->idm_lock);
+		spin_lock_irqsave(&iproc_i2c->idm_lock, flags);
 		writel(iproc_i2c->ape_addr_mask,
 		       iproc_i2c->idm_base + IDM_CTRL_DIRECT_OFFSET);
 		val = readl(iproc_i2c->base + offset);
-		spin_unlock(&iproc_i2c->idm_lock);
+		spin_unlock_irqrestore(&iproc_i2c->idm_lock, flags);
 	} else {
 		val = readl(iproc_i2c->base + offset);
 	}
@@ -250,12 +251,14 @@ static inline u32 iproc_i2c_rd_reg(struct bcm_iproc_i2c_dev *iproc_i2c,
 static inline void iproc_i2c_wr_reg(struct bcm_iproc_i2c_dev *iproc_i2c,
 				    u32 offset, u32 val)
 {
+	unsigned long flags;
+
 	if (iproc_i2c->idm_base) {
-		spin_lock(&iproc_i2c->idm_lock);
+		spin_lock_irqsave(&iproc_i2c->idm_lock, flags);
 		writel(iproc_i2c->ape_addr_mask,
 		       iproc_i2c->idm_base + IDM_CTRL_DIRECT_OFFSET);
 		writel(val, iproc_i2c->base + offset);
-		spin_unlock(&iproc_i2c->idm_lock);
+		spin_unlock_irqrestore(&iproc_i2c->idm_lock, flags);
 	} else {
 		writel(val, iproc_i2c->base + offset);
 	}

drivers/i2c/busses/i2c-designware-master.c

@@ -588,9 +588,21 @@ i2c_dw_read(struct dw_i2c_dev *dev)
 			u32 flags = msgs[dev->msg_read_idx].flags;
 
 			regmap_read(dev->map, DW_IC_DATA_CMD, &tmp);
+			tmp &= DW_IC_DATA_CMD_DAT;
 			/* Ensure length byte is a valid value */
-			if (flags & I2C_M_RECV_LEN &&
-			    (tmp & DW_IC_DATA_CMD_DAT) <= I2C_SMBUS_BLOCK_MAX && tmp > 0) {
+			if (flags & I2C_M_RECV_LEN) {
+				/*
+				 * if IC_EMPTYFIFO_HOLD_MASTER_EN is set, which cannot be
+				 * detected from the registers, the controller can be
+				 * disabled if the STOP bit is set. But it is only set
+				 * after receiving block data response length in
+				 * I2C_FUNC_SMBUS_BLOCK_DATA case. That needs to read
+				 * another byte with STOP bit set when the block data
+				 * response length is invalid to complete the transaction.
+				 */
+				if (!tmp || tmp > I2C_SMBUS_BLOCK_MAX)
+					tmp = 1;
+
 				len = i2c_dw_recv_len(dev, tmp);
 			}
 			*buf++ = tmp;

drivers/i2c/busses/i2c-hisi.c

@@ -330,6 +330,14 @@ static irqreturn_t hisi_i2c_irq(int irq, void *context)
 	struct hisi_i2c_controller *ctlr = context;
 	u32 int_stat;
 
+	/*
+	 * Don't handle the interrupt if cltr->completion is NULL. We may
+	 * reach here because the interrupt is spurious or the transfer is
+	 * started by another port (e.g. firmware) rather than us.
+	 */
+	if (!ctlr->completion)
+		return IRQ_NONE;
+
 	int_stat = readl(ctlr->iobase + HISI_I2C_INT_MSTAT);
 	hisi_i2c_clear_int(ctlr, int_stat);
 	if (!(int_stat & HISI_I2C_INT_ALL))

drivers/i2c/busses/i2c-imx-lpi2c.c

@@ -209,6 +209,9 @@ static int lpi2c_imx_config(struct lpi2c_imx_struct *lpi2c_imx)
 	lpi2c_imx_set_mode(lpi2c_imx);
 
 	clk_rate = clk_get_rate(lpi2c_imx->clks[0].clk);
+	if (!clk_rate)
+		return -EINVAL;
+
 	if (lpi2c_imx->mode == HS || lpi2c_imx->mode == ULTRA_FAST)
 		filt = 0;
 	else

drivers/i2c/busses/i2c-sun6i-p2wi.c

@@ -250,7 +250,8 @@ static int p2wi_probe(struct platform_device *pdev)
 
 	p2wi->rstc = devm_reset_control_get_exclusive(dev, NULL);
 	if (IS_ERR(p2wi->rstc)) {
-		dev_err(dev, "failed to retrieve reset controller: %d\n", ret);
+		dev_err(dev, "failed to retrieve reset controller: %pe\n",
+			p2wi->rstc);
 		return PTR_ERR(p2wi->rstc);
 	}
 

drivers/i2c/busses/i2c-tegra.c

@@ -442,7 +442,7 @@ static int tegra_i2c_init_dma(struct tegra_i2c_dev *i2c_dev)
 	if (IS_VI(i2c_dev))
 		return 0;
 
-	if (!i2c_dev->hw->has_apb_dma) {
+	if (i2c_dev->hw->has_apb_dma) {
 		if (!IS_ENABLED(CONFIG_TEGRA20_APB_DMA)) {
 			dev_dbg(i2c_dev->dev, "APB DMA support not enabled\n");
 			return 0;
@@ -460,6 +460,7 @@ static int tegra_i2c_init_dma(struct tegra_i2c_dev *i2c_dev)
 	i2c_dev->dma_chan = dma_request_chan(i2c_dev->dev, "tx");
 	if (IS_ERR(i2c_dev->dma_chan)) {
 		err = PTR_ERR(i2c_dev->dma_chan);
+		i2c_dev->dma_chan = NULL;
 		goto err_out;
 	}