Documentation: New DT parameters for tegra30-usb-phy
Document the new device tree parameters for Tegra30 USB PHY. Signed-off-by: Tuomas Tynkkynen <ttynkkynen@nvidia.com> Tested-by: Stephen Warren <swarren@nvidia.com> Reviewed-by: Stephen Warren <swarren@nvidia.com> Signed-off-by: Felipe Balbi <balbi@ti.com>
This commit is contained in:
parent
3e635202ce
commit
91e6670002
|
@ -3,7 +3,7 @@ Tegra SOC USB PHY
|
|||
The device node for Tegra SOC USB PHY:
|
||||
|
||||
Required properties :
|
||||
- compatible : Should be "nvidia,tegra20-usb-phy".
|
||||
- compatible : Should be "nvidia,tegra<chip>-usb-phy".
|
||||
- reg : Defines the following set of registers, in the order listed:
|
||||
- The PHY's own register set.
|
||||
Always present.
|
||||
|
@ -24,17 +24,26 @@ Required properties :
|
|||
Required properties for phy_type == ulpi:
|
||||
- nvidia,phy-reset-gpio : The GPIO used to reset the PHY.
|
||||
|
||||
Required PHY timing params for utmi phy:
|
||||
Required PHY timing params for utmi phy, for all chips:
|
||||
- nvidia,hssync-start-delay : Number of 480 Mhz clock cycles to wait before
|
||||
start of sync launches RxActive
|
||||
- nvidia,elastic-limit : Variable FIFO Depth of elastic input store
|
||||
- nvidia,idle-wait-delay : Number of 480 Mhz clock cycles of idle to wait
|
||||
before declare IDLE.
|
||||
- nvidia,term-range-adj : Range adjusment on terminations
|
||||
- nvidia,xcvr-setup : HS driver output control
|
||||
- Either one of the following for HS driver output control:
|
||||
- nvidia,xcvr-setup : integer, uses the provided value.
|
||||
- nvidia,xcvr-setup-use-fuses : boolean, indicates that the value is read
|
||||
from the on-chip fuses
|
||||
If both are provided, nvidia,xcvr-setup-use-fuses takes precedence.
|
||||
- nvidia,xcvr-lsfslew : LS falling slew rate control.
|
||||
- nvidia,xcvr-lsrslew : LS rising slew rate control.
|
||||
|
||||
Required PHY timing params for utmi phy, only on Tegra30 and above:
|
||||
- nvidia,xcvr-hsslew : HS slew rate control.
|
||||
- nvidia,hssquelch-level : HS squelch detector level.
|
||||
- nvidia,hsdiscon-level : HS disconnect detector level.
|
||||
|
||||
Optional properties:
|
||||
- nvidia,has-legacy-mode : boolean indicates whether this controller can
|
||||
operate in legacy mode (as APX 2500 / 2600). In legacy mode some
|
||||
|
|
Loading…
Reference in New Issue