net: ethernet: cpsw: fix hangs with interrupts
The CPSW IP implements pulse-signaled interrupts. Due to that we must write a correct, pre-defined value to the CPDMA_MACEOIVECTOR register so the controller generates a pulse on the correct IRQ line to signal the End Of Interrupt. The way the driver is written today, all four IRQ lines are requested using the same IRQ handler and, because of that, we could fall into situations where a TX IRQ fires but we tell the controller that we ended an RX IRQ (or vice-versa). This situation triggers an IRQ storm on the reserved IRQ 127 of INTC which will in turn call ack_bad_irq() which will, then, print a ton of: unexpected IRQ trap at vector 00 In order to fix the problem, we are moving all calls to cpdma_ctlr_eoi() inside the IRQ handler and making sure we *always* write the correct value to the CPDMA_MACEOIVECTOR register. Note that the algorithm assumes that IRQ numbers and value-to-be-written-to-EOI are proportional, meaning that a write of value 0 would trigger an EOI pulse for the RX_THRESHOLD Interrupt and that's the IRQ number sitting in the 0-th index of our irqs_table array. This, however, is safe at least for current implementations of CPSW so we will refrain from making the check smarter (and, as a side-effect, slower) until we actually have a platform where IRQ lines are swapped. This patch has been tested for several days with AM335x- and AM437x-based platforms. AM57x was left out because there are still pending patches to enable ethernet in mainline for that platform. A read of the TRM confirms the statement on previous paragraph. Reported-by: Yegor Yefremov <yegorslists@googlemail.com> Fixes: 510a1e7 (drivers: net: davinci_cpdma: acknowledge interrupt properly) Cc: <stable@vger.kernel.org> # v3.9+ Signed-off-by: Felipe Balbi <balbi@ti.com> Acked-by: Tony Lindgren <tony@atomide.com> Signed-off-by: David S. Miller <davem@davemloft.net>
This commit is contained in:
parent
9dac6232e2
commit
7ce67a38f7
|
@ -757,6 +757,14 @@ requeue:
|
|||
static irqreturn_t cpsw_interrupt(int irq, void *dev_id)
|
||||
{
|
||||
struct cpsw_priv *priv = dev_id;
|
||||
int value = irq - priv->irqs_table[0];
|
||||
|
||||
/* NOTICE: Ending IRQ here. The trick with the 'value' variable above
|
||||
* is to make sure we will always write the correct value to the EOI
|
||||
* register. Namely 0 for RX_THRESH Interrupt, 1 for RX Interrupt, 2
|
||||
* for TX Interrupt and 3 for MISC Interrupt.
|
||||
*/
|
||||
cpdma_ctlr_eoi(priv->dma, value);
|
||||
|
||||
cpsw_intr_disable(priv);
|
||||
if (priv->irq_enabled == true) {
|
||||
|
@ -786,8 +794,6 @@ static int cpsw_poll(struct napi_struct *napi, int budget)
|
|||
int num_tx, num_rx;
|
||||
|
||||
num_tx = cpdma_chan_process(priv->txch, 128);
|
||||
if (num_tx)
|
||||
cpdma_ctlr_eoi(priv->dma, CPDMA_EOI_TX);
|
||||
|
||||
num_rx = cpdma_chan_process(priv->rxch, budget);
|
||||
if (num_rx < budget) {
|
||||
|
@ -795,7 +801,6 @@ static int cpsw_poll(struct napi_struct *napi, int budget)
|
|||
|
||||
napi_complete(napi);
|
||||
cpsw_intr_enable(priv);
|
||||
cpdma_ctlr_eoi(priv->dma, CPDMA_EOI_RX);
|
||||
prim_cpsw = cpsw_get_slave_priv(priv, 0);
|
||||
if (prim_cpsw->irq_enabled == false) {
|
||||
prim_cpsw->irq_enabled = true;
|
||||
|
@ -1310,8 +1315,6 @@ static int cpsw_ndo_open(struct net_device *ndev)
|
|||
napi_enable(&priv->napi);
|
||||
cpdma_ctlr_start(priv->dma);
|
||||
cpsw_intr_enable(priv);
|
||||
cpdma_ctlr_eoi(priv->dma, CPDMA_EOI_RX);
|
||||
cpdma_ctlr_eoi(priv->dma, CPDMA_EOI_TX);
|
||||
|
||||
prim_cpsw = cpsw_get_slave_priv(priv, 0);
|
||||
if (prim_cpsw->irq_enabled == false) {
|
||||
|
@ -1578,9 +1581,6 @@ static void cpsw_ndo_tx_timeout(struct net_device *ndev)
|
|||
cpdma_chan_start(priv->txch);
|
||||
cpdma_ctlr_int_ctrl(priv->dma, true);
|
||||
cpsw_intr_enable(priv);
|
||||
cpdma_ctlr_eoi(priv->dma, CPDMA_EOI_RX);
|
||||
cpdma_ctlr_eoi(priv->dma, CPDMA_EOI_TX);
|
||||
|
||||
}
|
||||
|
||||
static int cpsw_ndo_set_mac_address(struct net_device *ndev, void *p)
|
||||
|
@ -1620,9 +1620,6 @@ static void cpsw_ndo_poll_controller(struct net_device *ndev)
|
|||
cpsw_interrupt(ndev->irq, priv);
|
||||
cpdma_ctlr_int_ctrl(priv->dma, true);
|
||||
cpsw_intr_enable(priv);
|
||||
cpdma_ctlr_eoi(priv->dma, CPDMA_EOI_RX);
|
||||
cpdma_ctlr_eoi(priv->dma, CPDMA_EOI_TX);
|
||||
|
||||
}
|
||||
#endif
|
||||
|
||||
|
|
Loading…
Reference in New Issue