UbiquitousOS
/
OpenCloudOS-Kernel
mirror of https://gitee.com/OpenCloudOS/OpenCloudOS-Kernel.git
11
0
Fork 0
Code Issues Projects Releases Wiki Activity

Bluetooth: hci_bcm: Use operation speed of 4Mbps only for ACPI devices 

Not all Broadcom controller support the 4Mbps operational speed on UART
devices. This is because the UART clock setting changes might not be
supported.

  < HCI Command: Broadcom Write UART Clock Setting (0x3f|0x0045) plen 1
         01                                               .
  > HCI Event: Command Complete (0x0e) plen 4
       Broadcom Write UART Clock Setting (0x3f|0x0045) ncmd 1
         Status: Unknown HCI Command (0x01)

To support any operational speed higher than 3Mbps, support for this
command is required. With that respect it is better to not enforce any
operational speed by default. Only when its support is known, then allow
for higher operational speed.

This patch assigns the 4Mbps opertional speed only for devices
discovered through ACPI and leave all others at the default 115200.

Signed-off-by: Marcel Holtmann <marcel@holtmann.org>
Signed-off-by: Johan Hedberg <johan.hedberg@intel.com>
This commit is contained in:
Marcel Holtmann 2017-08-16 09:53:30 +02:00 committed by Johan Hedberg
parent a0085f2510
commit 74183a1c50
1 changed files with 5 additions and 2 deletions
Show Stats Download Patch File Download Diff File Expand all files Collapse all files

7
drivers/bluetooth/hci_bcm.c
View File

@ -59,6 +59,7 @@ struct bcm_device {
bool clk_enabled;
u32 init_speed;
u32 oper_speed;
int irq;
u8 irq_polarity;
@ -303,6 +304,7 @@ static int bcm_open(struct hci_uart *hu)
if (hu->tty->dev->parent == dev->pdev->dev.parent) {
bcm->dev = dev;
hu->init_speed = dev->init_speed;
hu->oper_speed = dev->oper_speed;
#ifdef CONFIG_PM
dev->hu = hu;
#endif
@ -699,8 +701,10 @@ static int bcm_resource(struct acpi_resource *ares, void *data)
case ACPI_RESOURCE_TYPE_SERIAL_BUS:
sb = &ares->data.uart_serial_bus;
if (sb->type == ACPI_RESOURCE_SERIAL_TYPE_UART)
if (sb->type == ACPI_RESOURCE_SERIAL_TYPE_UART) {
dev->init_speed = sb->default_baud_rate;
dev->oper_speed = 4000000;
}
break;
default:
@ -853,7 +857,6 @@ static const struct hci_uart_proto bcm_proto = {
.name = "Broadcom",
.manufacturer = 15,
.init_speed = 115200,
.oper_speed = 4000000,
.open = bcm_open,
.close = bcm_close,
.flush = bcm_flush,