soundwire: bus: Don't re-enumerate before status is UNATTACHED

Don't re-enumerate a peripheral on #0 until we have seen and
handled an UNATTACHED notification for that peripheral.

Without this, it is possible for the UNATTACHED status to be missed
and so the slave->status remains at ATTACHED. If slave->status never
changes to UNATTACHED the child driver will never be notified of the
UNATTACH, and the code in sdw_handle_slave_status() will skip the
second part of enumeration because the slave->status has not changed.

This scenario can happen because PINGs are handled in a workqueue
function which is working from a snapshot of an old PING, and there
is no guarantee when this function will run.

A peripheral could report attached in the PING being handled by
sdw_handle_slave_status(), but has since reverted to device #0 and is
then found in the loop in sdw_program_device_num(). Previously the
code would not have updated slave->status to UNATTACHED because it had
not yet handled a PING where that peripheral had UNATTACHED.

This situation happens fairly frequently with multiple peripherals on
a bus that are intentionally reset (for example after downloading
firmware).

Signed-off-by: Richard Fitzgerald <rf@opensource.cirrus.com>
Reviewed-by: Pierre-Louis Bossart <pierre-louis.bossart@linux.intel.com>
Link: https://lore.kernel.org/r/20220914160248.1047627-4-rf@opensource.cirrus.com
Signed-off-by: Vinod Koul <vkoul@kernel.org>

drivers/soundwire/bus.c

@@ -773,6 +773,16 @@ static int sdw_program_device_num(struct sdw_bus *bus)
 			if (sdw_compare_devid(slave, id) == 0) {
 				found = true;
 
+				/*
+				 * To prevent skipping state-machine stages don't
+				 * program a device until we've seen it UNATTACH.
+				 * Must return here because no other device on #0
+				 * can be detected until this one has been
+				 * assigned a device ID.
+				 */
+				if (slave->status != SDW_SLAVE_UNATTACHED)
+					return 0;
+
 				/*
 				 * Assign a new dev_num to this Slave and
 				 * not mark it present. It will be marked