From 6f2a6a52560ad8d85710aabd92b7a3239b3a6b07 Mon Sep 17 00:00:00 2001 From: Wolfram Sang Date: Wed, 5 Dec 2012 21:46:02 +0100 Subject: [PATCH] mtd: nand: gpmi: reset BCH earlier, too, to avoid NAND startup problems It could happen (1 out of 100 times) that NAND did not start up correctly after warm rebooting, so the kernel could not find the UBI or DMA timed out due to a stalled BCH. When resetting BCH together with GPMI, the issue could not be observed anymore (after 10000+ reboots). We probably need the consistent state already before sending any command to NAND, even when no ECC is needed. I chose to keep the extra reset for BCH when changing the flash layout to be on the safe side. Signed-off-by: Wolfram Sang Acked-by: Huang Shijie Cc: stable@vger.kernel.org Signed-off-by: Artem Bityutskiy --- drivers/mtd/nand/gpmi-nand/gpmi-lib.c | 9 +++++++++ 1 file changed, 9 insertions(+) diff --git a/drivers/mtd/nand/gpmi-nand/gpmi-lib.c b/drivers/mtd/nand/gpmi-nand/gpmi-lib.c index 1585c5b1c8bf..d84699c7968e 100644 --- a/drivers/mtd/nand/gpmi-nand/gpmi-lib.c +++ b/drivers/mtd/nand/gpmi-nand/gpmi-lib.c @@ -165,6 +165,15 @@ int gpmi_init(struct gpmi_nand_data *this) if (ret) goto err_out; + /* + * Reset BCH here, too. We got failures otherwise :( + * See later BCH reset for explanation of MX23 handling + */ + ret = gpmi_reset_block(r->bch_regs, GPMI_IS_MX23(this)); + if (ret) + goto err_out; + + /* Choose NAND mode. */ writel(BM_GPMI_CTRL1_GPMI_MODE, r->gpmi_regs + HW_GPMI_CTRL1_CLR);