From 63d12e23235d982d8f55696e09b2ff91e3ba0042 Mon Sep 17 00:00:00 2001 From: Magnus Damm Date: Thu, 28 May 2009 12:00:25 +0000 Subject: [PATCH] sh: sh7785lcr mode pin configuration This patch adds mode pin support to the sh7785lcr board. The harware allows the user to control the mode pins using dip switches S1 and S2, but from the software the pins are fixed to the factory default since we have no way to reading out this configuration from software. Signed-off-by: Magnus Damm Signed-off-by: Paul Mundt --- arch/sh/boards/board-sh7785lcr.c | 22 ++++++++++++++++++++++ 1 file changed, 22 insertions(+) diff --git a/arch/sh/boards/board-sh7785lcr.c b/arch/sh/boards/board-sh7785lcr.c index 33b194b0454d..c2894c5b71ea 100644 --- a/arch/sh/boards/board-sh7785lcr.c +++ b/arch/sh/boards/board-sh7785lcr.c @@ -24,6 +24,7 @@ #include #include #include +#include /* * NOTE: This board has 2 physical memory maps. @@ -320,6 +321,26 @@ static void __init sh7785lcr_setup(char **cmdline_p) writel(0x000307c2, sm501_reg); } +/* Return the board specific boot mode pin configuration */ +static int sh7785lcr_mode_pins(void) +{ + int value = 0; + + /* These are the factory default settings of S1 and S2. + * If you change these dip switches then you will need to + * adjust the values below as well. + */ + value |= 1 << MODE_PIN_MODE4; /* Clock Mode 16 */ + value |= 1 << MODE_PIN_MODE5; /* 32-bit Area0 bus width */ + value |= 1 << MODE_PIN_MODE6; /* 32-bit Area0 bus width */ + value |= 1 << MODE_PIN_MODE7; /* Area 0 SRAM interface [fixed] */ + value |= 1 << MODE_PIN_MODE8; /* Little Endian */ + value |= 1 << MODE_PIN_MODE9; /* Master Mode */ + value |= 1 << MODE_PIN_MODE14; /* No PLL step-up */ + + return value; +} + /* * The Machine Vector */ @@ -328,5 +349,6 @@ static struct sh_machine_vector mv_sh7785lcr __initmv = { .mv_setup = sh7785lcr_setup, .mv_clk_init = sh7785lcr_clk_init, .mv_init_irq = init_sh7785lcr_IRQ, + .mv_mode_pins = sh7785lcr_mode_pins, };